Apple power mac g4 agp graphics User Manual

 Take ApartPower Supply, Power Mac G4 (QuickSilvers)  -   119
6. Maneuver the power 
supply and its cables out 
of the chassis.  

 Take ApartPower Supply, Power Mac G4 (QuickSilvers)  -   120
Replacement Note: If you 
are replacing the power 
supply, remove the power 
supply bracket and reattach 
it to the new power supply. 

 Take ApartPower Supply, Power Mac G4 (QuickSilvers)  -   121
Replacement Note: You must 
set the power supply voltage 
switch to the correct setting 
(115 V in North America) 
to avoid damaging the 
computer. 

 Take ApartPower Supply, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio  -   122
Power Supply, PCI/
AGP Graphics/Gigabit 
Ethernet/Digital Audio
Before you begin, do the 
following:
¥ Open the side access 
panel.
¥ Remove the CD/DVD drive 
bezel.
¥ Move the CD/DVD/Zip 
drive carrier forward 1 
inch. 

 Take ApartPower Supply, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio  -   123
1. Disconnect the power-
to-fan connector. 

 Take ApartPower Supply, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio  -   124
2. Disconnect the following  
power cables:
¥cables P6 and P7 from 
the CD-ROM/Zip drive
¥Power Mac G4 (PCI 
Graphics): cable P4 
from the front panel 
board 
¥main power cable from 
the logic board
¥cable(s) to hard drives 

 Take ApartPower Supply, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio  -   125
3. Using a 2.5 mm Allen 
wrench, remove the 
three screws on the rear 
vented panel.  

 Take ApartPower Supply, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio  -   126
4. On the inside of the 
chassis, remove the 
screw that attaches the 
power supply to the 
power supply shelf.
5. Slide the power supply 
forward toward the front 
of the computer. 
Maneuver the power 
supply (clearing the 
security bar on the 
inside and upper 
chassis) and its cables 
out of the chassis. 
Note: If you are replacing 
the power supply, remove 
the power supply bracket  

 Take ApartPower Supply, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio  -   127
and reattach it to the new 
power supply.
Replacement Note: You must 
set the power supply voltage 
switch to the correct setting 
(115 V in the U.S.) to avoid 
damaging the computer. 

 Take ApartSpeaker, Power Mac G4 (QuickSilvers)  -   128
Speaker, Power Mac 
G4 (QuickSilvers)
Before you begin, do the 
following:
¥ Open the side access 
panel.
¥ Remove the carrier 
support plate.