Apple imac 20 inch late 2006 User Manual
Here you can view all the pages of manual Apple imac 20 inch late 2006 User Manual. The Apple manuals for Display are available online for free. You can easily download all the documents as PDF.
Page 31
iMac (20-inch Late 2006) Take Apart — Camera Board 31 With your fingers or black stick, flex the two black tabs forward to release the camera board 4. from the camera bracket. Remove the camera board from the front bezel. 5. Note: The flex cable, camera lens, and black mounting bracket are part of the front bezel.
Page 32
iMac (20-inch Late 2006) Take Apart — Camera Board 32 Replacing the Camera Board Position the camera board in the plastic bracket. Make sure the flex cable is not pinched as 1. you install the board. Snap the board into the mounting bracket and lock the flex cable into the connector with 2. the locking hinge.
Page 33
iMac (20-inch Late 2006) Take Apart — Camera Board 33 Reapply the tape across the length of the camera board. 3. Connect the two cables to the camera board. 4. Tuck the camera board cables neatly into the channel on the rear housing. 5.
Page 34
iMac (20-inch Late 2006) Take Apart — Camera Board 34 Holding the memory ejector levers closed, lower the font bezel down. 6. Replace the bezel screws along the bottom of the computer. 7. Replace the access door; tighten the two captive screws. 8.
Page 35
iMac (20-inch Late 2006) Take Apart — Lower EMI Shield 35 Lower EMI Shield Tools Black stick (or other nonconductive nylon or plastic flat-blade tool). • Preliminary Steps Before you begin, remove the following: A • ccess door F • ront bezel Part Location
Page 36
iMac (20-inch Late 2006) Take Apart — Lower EMI Shield 36 Removing the Lower EMI Shield Carefully peel the lower EMI shield off the bottom edge of the rear housing. Use a black 1. stick to help peel back the shield. Gently lift the EMI shield to rest of the way to expose the other modules. 2.
Page 37
iMac (20-inch Late 2006) Take Apart — Lower EMI Shield 37 Replacing the Lower EMI Shield Position the lower EMI shield over the bottom of the unit so that the holes (for the IR board 1. and the LED) in the shield are properly aligned. Press the sticky, edge of the EMI shield onto the bottom side of the display panel. The crease 2. in the EMI shield should align with the edge of the panel. Fold down the EMI shield and press it firmly over the bottom edge of the rear housing. Use a 3. black stick...
Page 38
iMac (20-inch Late 2006) Take Apart — IR Board 38 IR Board Tools Torx T6 screwdriver. • Preliminary Steps Before you begin, remove the following: A • ccess door F • ront bezel Lower EMI shield • Part Location
Page 39
iMac (20-inch Late 2006) Take Apart — IR Board 39 Removing the IR Board 1. Disconnect the IR cable and remove the two T6 screws on the IR board. Lift the IR board from its mounting bracket. If necessary, 2. use a Torx T6 screwdriver to remove the IR board mounting bracket. 922-7010 922-7010
Page 40
iMac (20-inch Late 2006) Take Apart — IR Board 40 Note 3. : If you are replacing the IR /camera cable, you must remove the optical drive and disconnect the cable from the logic board.