AOC E2343fs User Manual

							
 51
Troubleshoot 
 
Problem & Question  
Possible Solutions 
 
 
Power LED Is Not ON  
Make sure the power button is ON and the Power Cord is properly connected 
to a grounded power outlet and to the monitor.   
 
 
 
 
 
 
 
 
 
 
No images on the screen  
Is the power cord connected properly? 
Check the power cord connection and power supply. 
Is the cable connected correctly? 
(Connected using the D-sub cable) 
Check the DB-15 cable connection.    
(Connected using the DVI cable) 
Check the DVI cable connection.  
* DVI input is not available on every model. 
If the power is on, reboot the comput er to see the initial screen (the login 
screen), which can be seen. 
If the initial screen (the login screen) ap pears, boot the computer in the 
applicable mode (the safe mode for Windows ME/XP/2000) and then change 
the frequency of the video card. 
(Refer to the Setting t he Optimal Resolution) 
If the initial screen (the login screen) d oes not appear, contact the Service 
Center or your dealer. 
Can you see Input Not Supported on the screen? 
You can see this message when the signal from the video card exceeds the 
maximum resolution and frequency that the monitor can handle properly. 
Adjust the maximum resolution and fr equency that the monitor can handle 
properly. 
Make sure the AOC Monitor Drivers are installed. 
 
Picture Is Fuzzy & Has 
Ghosting Shadowing Problem     
Adjust the Contrast and Brightness Controls.   
Press to auto adjust.   
Make sure you are not using an ext
ension cable or switch box. We 
recommend plugging the monitor directly to the video card output connector 
on the back .   
 
Picture Bounces, Flickers Or 
Wave Pattern Appears In The 
Picture  Move electrical devices that may cause electrical interference as far away 
from the monitor as possible.   
Use the maximum refresh rate your monitor is capable of at the resolution 
your are using.   
 
						

							
 52
 
 
 
 
Monitor Is Stuck In Active 
Off-Mode 
 
The Computer Power Switch should be in the ON position.   
The Computer Video Card should be snugly fitted in its slot.   
Make sure the monitors video cable is properly connected to the computer. 
Inspect the monitors video cable and make sure no pin is bent.   
Make sure your computer is operational by hitting the CAPS LOCK key on 
the keyboard while observing the CAPS 
LOCK LED. The LED should either 
turn ON or OFF after hitting the CAPS LOCK key.   
 
Missing one of the primary 
colors (RED, GREEN, or 
BLUE)   
Inspect the monitors video cable and make sure that no pin is damaged.   
Make sure the monitors video cable is properly connected to the computer. 
 
Screen image is not centered 
or sized properly 
 
Adjust H-Position and V-Position or press hot-key (AUTO).   
 
Picture has color defects 
(white does not look white)  
Adjust RGB color or select desired color temperature.   
 
Horizontal or vertical 
disturbances on the screen  
Use Windows 95/98/2000/ME/XP sh
ut-down mode Adjust CLOCK and 
FOCUS.  
Press to auto-adjust.   
 
						

							
 53
Specification 
General Specification 
Model number   e2343F /e2343Fk /e2343Fb 
Driving system   TFT Color LED   
Viewable Image Size 58.42cm diagoanl 
Pixel pitch   0.265mm(H) x 0.265mm(V) 
Video  R, G, B Analog lnterface   
Separate Sync.   H/V TTL 
Display Color   16.7M Colors   
Panel  
Dot Clock   148.5 MHz   
Horizontal scan range   30 kHz - 83 kHz 
Horizontal scan Size(Maximum)   509.2mm  
Vertical scan range   55 Hz - 75 Hz   
Vertical scan Size(Maximum)   286.4mm  
Optimal preset resolution   1920 x 1080 (60 Hz) 
Highest preset resolution   1920 x 1080 (60 Hz)   
Plug & Play   VESA DDC2B/CI   
Input Connector   
Input Video Signal    
Power Source   100~240VAC, 50/60Hz   
Active < 28 W  (Typical) 
Resolution  
Power Consumption   Standby < 0.5 W   
Connector Type   
Signal Cable Type   Detachable  
Dimensions & Weight:    
Height (with base)   404.6 mm 
Width  547.2 mm 
Depth  182.4 mm 
Physical 
Characteristics 
Weight (monitor only)   2.85 kg 
Temperature:      
Operating  0°C to 40° C 
Non-Operating  -25°Cto 55°C 
Humidity:      
Operating  10% to 85% (non-condensing)   
Environmental  
Non-Operating  5% to 93% (non-condensing)   
D-Sub 15pin/DVI-D   
Analog: 0.7Vp-p(standard), 75 OHM, Positive;DVI-D; TMDS
15-pin Mini D-Sub, DVI-D  & Digital Interface 
 
						

							
 54
Altitude:      
Operating  0~ 3,658m (0~ 12,000 ft )   
Non-Operating  0~ 12,192m (0~ 40,000 ft )   
Preset Display Modes 
STAND RESOLUTION    HORIZONTAL 
 
FREQUENCY  (kHZ)   VERTICAL 
 
FREQUENCY  (Hz)     
 
VGA 640x480@60Hz 31.469 59.940 
VGA 640x480@72Hz 37.861 72.809 
VGA 640x480@75Hz 37.500 75.00 
SVGA 800x600@56Hz 35.156 56.250 
SVGA 800x600@60Hz 37.879 60.317 
SVGA 800x600@72Hz 48.077 72.188 
SVGA 800x600@75Hz 46.875 75.000 
XGA 1024x768@60Hz 48.363 60.004 
XGA 1024x768@70Hz 56.476 70.069 
XGA 1024x768@75Hz 60.023 75.029 
SXGA 1280x1024@60Hz 63.981 60.020 
SXGA 1280x1024@75Hz 79.976 75.025 
WXGA+ 1440x900@60Hz 55.935 59.887 
WXGA+ 1440x900@60Hz 55.469 59.901 
WSXGA 1680x1050@60Hz 65.290 59.954 
1680x1050@60Hz
 64.674 59.883 
WUXGA 1920x1080@60HZ 67.5 59.934 
 
 
						

							
 55
Pin Assignments 
   
 
Pin Number 15-Pin Side of the Signal Cable 
1 Video-Red 
2 Video-Green 
3 Video-Blue 
4 N.C. 
5 Detect Cable 
6 GND-R 
7 GND-G 
8 GND-B 
9 +5V 
10 Ground 
11  N.C. 
12 DDC-Serial data 
13 H-sync 
14 V- s yn c  
15 DDC-Serial clock 
 
 
 
Pin No. Signal Name Pin No. Signal Name Pin No. Signal Name 
1 TMDS Data 2- 9 TMDS Data 1- 17 TMDS Data 0- 
2 TMDS Data 2+ 10 TMDS Data 1+ 18 TMDS Data 0+ 
3 TMDS Data 2/4 Shield 11  TMDS Data 1/3 Shield 19 TMDS Data 0/5 Shield
4 TMDS Data 4- 12 TMDS Data 3- 20 TMDS Data 5- 
5 TMDS Data 4+ 13 TMDS Data 3+ 21 TMDS Data 5+ 
6 DDC Clock 14 +5V Power 22 TMDS Clock Shield 
7 DDC Data 15 Ground(for+5V) 23 TMDS Clock + 
8 N.C. 16 Hot Plug Detect 24 TMDS Clock - 
 
						

							
 56
 
 
Plug and Play 
Plug & Play DDC2B Feature 
 
This monitor is equipped with VESA DDC2B capabilities according to the VESA DDC STANDARD. It allows the 
monitor to inform the host system of its identity and,
 depending on the level of DDC used, communicate additional 
information about its display capabilities. 
 
The DDC2B is a bi-directional data channel based on the  I2C protocol. The host can request EDID information over 
the DDC2B channel.
 
						

							
 57
Regulation 
FCC Notice 
 
FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS) 
 
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference 
in a residential installation. This equipment generates, us es and can radiate radio frequency energy, and if not 
installed and used in accordance with the instructions,  may cause harmful interference to radio communications. 
However, there is no guarantee that inte rference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television receptio n, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the in terference by one or more of the following measures: 
 
Reorient or relocate the receiving antenna.   
Increase the separation between the equipment and receiver.   
Connect the equipment into an outlet on a circuit differ ent from that to which the receiver is connected.   
Consult the dealer or an experienced radio/TV technician for help.   
 
 
NOTICE : 
 
The changes or modifications not expressly approved by the  party responsible for compliance could void the users 
authority to operate the equipment.   
Shielded interface cables and AC power cord, if any, must  be used in order to comply with the emission limits.   
The manufacturer is not responsible for any radio or TV  interference caused by unauthorized modification to this 
equipment. It is the responsibilities of the user to correct su ch interference. It is the responsibility of the user to 
correct such interference.
 
						

							
 58
WEEE Declaration 
Disposal of Waste Equipment by Users in Private Household in the European Union.   
 
 
This symbol on the product or on its packaging indicates t hat this product must not be disposed of with your other 
household waste.Instead, it is your responsibility to dis pose of your waste equipment by handing it over to a 
designated collection point for the recycling of waste el ectrical and electronic equipment.The separate collection 
and recycling of your waste equipment at the time of di sposal will help to conserve natural resources and ensure 
that it is recycled in a manner that  protects human health and the environment. For more information about where 
you can drop off your waste equipment for recycling, pleas e contact your local city office, your household waste 
disposal service or the shop where you purchased the product . 
 
 
HG Declaration 
SAFETY: Lamp Disposal   
LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY  AND MUST BE RECYCLED OR DISPOSED OF 
ACCORDING TO LOCAL,  STATE OR FEDERAL LAWS. FOR MORE INFORMATION, CONTACT THE 
ELECTRONIC INDUSTRIES ALLIANCE AT WWW.EIAE.ORG
. 
 
 
 
						

							
 59
EPEAT Declaration 
 
EPEAT is a system to help purchasers in the public an d private sectors evaluate, compare and select desktop 
computers, notebooks and monitors ba sed on their environmental attributes. EPEAT also provides a clear and 
consistent set of performance criteria  for the design of products, and provides  an opportunity for manufacturers to 
secure market recognition for efforts to r educe the environmental impact of its products.   
 
 
AOC believes in protecting the environment. 
With a key concern for the conservation of natural resources, as well as land  ll protection, AOC announces the 
launch of AOC monitor’s packaging recycling program. This  program is designed to help you discard of your 
monitor carton and   ller materials properly. If a local recycling center is not available, AOC will recycle the 
packaging material for you, including foam   ller and carton. AOC Display solution will only recycle AOC monitor 
packaging. Please refer to the following website address: 
 
Only for North and South American, excluding Brazil: 
http://us.aoc.com/about/environmental_impact
 
 
For Germany:   
http://www.aoc-europe.com/en/service/tco.php
 
 
For Brazil:   
http://www.aoc.com.br/2007/php/index.php?req=pagina&pgn_id=134
 
						

							
 60
Service 
Warranty Statement for Europe 
LIMITED THREE-YEAR WARRANTY*   
AOC Color Monitors sold within Europe   
AOC International (Europe) GmbH warrants this product to be free from defects in material and workmanship for a 
period of Three (3) years after the original date of c onsumer purchase. During this period, AOC International 
(Europe) GmbH will, at its option, either  repair the defective product with new or  rebuilt parts, or replace it with a 
new or rebuilt product at no charge except as *stated bel ow. The defective products that are replaced become the 
property of AOC International (Europe) GmbH.   
 
If the product appears to be defective, please contact your  local dealer or refer to the warranty card when attached 
to the product.   
 
Deliver the product freight pre-paid, along with the dated  proof of purchase, to the AOC Authorized Service Center. 
If you cannot deliver the product in person:   
 
Pack it in its original shipping container (or equivalent)   
Put the RMA number on the address label   
Put the RMA number on the shipping carton   
Insure it (or assume the risk of loss/damage during shipment)   
Pay all shipping charges   
 
AOC International (Europe) GmbH is responsible neither  for any damage or loss during inbound transport damage 
nor to inbound product that was not properly packaged.   
 
AOC International (Europe) GmbH will pay the return shippi ng charges within one of the countries specified within 
this warranty statement. AOC International (Europe) GmbH  is not responsible for any costs associated with the 
transportation of product across international borders. This  includes the international border within the European 
Union.  
 
* This limited warranty does not cover any losse s or damages that occur as a result of   
Shipping or improper installation or maintenance   
Misuse  
Neglect  
Any cause other than ordinary commercial or industrial application   
Adjustment by non-authorized source   
Repair, modification, or installation of options or parts  by anyone other than an AOC Authorized Service Center   
Improper environment   
Excessive or inadequate heating or air conditioning or electr ical powers failures, surges, or other irregularities   
 
This limited warranty does not cover any of the product fi rmware or hardware that you or any third party have