AOC E2043fk User Manual

 2

Safety........................................................................\
.................................................
............................................... 4
 
National Conventions........................................................................\
................................... .............................. 4 
Power ........................................................................\
.....................................................

 3
HG Declar
ation ........................................................................\
......................................... ............................... 58
 
EPEAT Declaration ........................................................................\
...................................... ............................ 59 
Service ........................................................................\...

 4
Safety 
National Conventions 
The following subsections describe notational conventions used in this document. 
 
Notes, Cautions, and Warnings 
 
Throughout this guide, blocks of text may be accompanied by an icon and printed in bold type or in italic type. 
These blocks are notes, cautions, and warnings, and they are used as follows: 
 
 
NOTE: A NOTE indicates important information that helps you make better use of your computer system. 
 
 
CAUTION: A CAUTION indicates either potential damage to...

 5
Power 
The monitor should be operated only from the type of power source indicated on the label. If you are not sure 
of the type of power supplied to your home, consult your dealer or local power company.   
 
 
The monitor is equipped with a three-pronged grounded plug, a plug with a third (grounding) pin. This plug 
will fit only into a grounded power outlet as a safety f eature. If your outlet does not accommodate the three-wire 
plug, have an electrician install the correct outlet, or use  an...

 6
Installation 
Do not place the monitor on an unstable cart, stand, tripod, bracket, or table. If the monitor falls, it can injure a 
person and cause serious damage to this product. Use only a  cart, stand, tripod, bracket, or table recommended by 
the manufacturer or sold with this product. Follow the  manufacturer’s instructions when installing the product and 
use mounting accessories recommended by the manufactu rer. A product and cart combination should be moved 
with care.   
 
Never push any...

 7
Cleaning 
Clean the cabinet regularly with the cloth provided.    You can use soft-detergent to wipe out the stain, instead 
of strong-detergent which will c auterize the product cabinet.     
 
When cleaning, make sure no detergent is leaked into  the product. The cleaning cloth should not be too rough 
as it will scratch the screen surface.   
 
Please disconnect the power cord before cleaning the product.   
 
 

 8
Other 
If the product is emitting a strange smell, sound or smoke, disconnect the power plug IMMEDIATELY and 
contact a Service Center.     
 
Make sure that the ventilating openings are not blocked by a table or curtain.     
 
Do not engage the LCD monitor in severe vibration  or high impact conditions during operation.     
 
Do not knock or drop the monitor durin g operation or transportation.     
 

 9
Setup 
Contents in Box 
 
Not all signal cables (Analog, USB, DVI, and HDMI cables) will be provided for all countries and regions. Please 
check with the local dealer or AOC branch office for confirmation.
Monitor
 
QSG   
 
CD Manual 
Power Cable  Analog Cable 
Adaptor                DVI
 Cable
 

 10
Setup Stand & Base 
Please setup  the base following the steps as below. 
 
Setup: 
 
1.  Place  monitor  on  the  firm  surface  (such  as,  table)   
2.   Use  your  hands  to hold  the  monitor  base   
3.   Use  your  hands  to fold  the  monitor  base  as  figure  instructed  above  by  switch  
safety  lock  to  the  right  side 
4.   Once  the monitor  base  begin  to  fold  you  can release  the  safety  lock  (caution:  
you  must  hear  “click”  after  you fold the  monitor  base  to...

 11
Adjusting Viewing Angle 
For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitors angle to your 
own preference.   
Hold the stand so you will not topple the moni tor when you change the monitors angle.   
You are able to adjust the monitors angle from -5° to 18 °.   
 
 
NOTE: 
Do not touch the LCD screen when you change the a ngle. It may cause damage or break the LCD screen.
-5
18