AOC E2041s User Manual

							
 51
Specification 
General Specification 
Model number   e2041S
Driving system   TFT Color LED   
Viewable Image Size 50.8 cm diagoanl 
Pixel pitch   0.2768mm(H) x 0.2768mm(V) 
Video  R, G, B Analog lnterface   
Separate Sync.   H/V TTL 
Display Color   16.7M Colors   
Panel  
Dot Clock   108 MHz   
Horizontal scan range   30 kHz - 60 kHz 
Horizontal scan Size(Maximum)   442.8 mm  
Vertical scan range   55 Hz - 75 Hz   
Vertical scan Size(Maximum)   249.075 mm  
Optimal preset resolution   1600 x 900 (60 Hz) 
Highest preset resolution   1600 x 900 (60  Hz)   
Plug & Play   VESA DDC2B/CI   
Input Connector   D-Sub 15pin   
Input Video Signal   Analog: 0.7Vp-p(standard), 75 OHM, Positive   
Power Source   100~240VAC, 50/60Hz   
Active < 25 W   
Resolution  
Power Consumption   Standby < 0.1 W   
Connector Type   15-pin Mini D-Sub   
Signal Cable Type   Detachable  
Dimensions & Weight:    
Height (with base)   368.0 mm 
Width  491.3 mm 
Depth  150.0 mm 
Physical 
Characteristics 
Weight (monitor only)   3.4 kg 
Temperature:      
Operating  0°C to 40° C  
Non-Operating  -25°Cto 55°C 
Humidity:      
Operating  10% to 85% (non-condensing)   
Environmental  
Non-Operating  5% to 93% (non-condensing)   
 
						

							
 52
Altitude:      
Operating  0~ 3,658m (0~ 12,000 ft )   
Non-Operating  0~ 12,192m (0~ 40,000 ft )   
Preset Display Modes 
Standard ResolutionH. Frequency
(kHz) V. Frequency
(Hz) 
VGA  640x480@60Hz  31.469 59.940 
 640x480@67Hz 
35.000   66.667 
 
 
640x480@72Hz 
37.861  72.809
 
37.500 75.000
 
720x400@7 0Hz  31.469
70.087 
 800x600@56Hz 
35.156  56.250
 
800x600@60Hz 
37.879  60.317
SVGA 
48.077        72.188
 
 46.875
 75.000
 49.725 74.500
 48.363 60.004 
XGA 56.476 
70.069
 
 
1024x768@75Hz 60.023 75.029 
 
1024x768@75Hz 60.241   74.927
 
 
1280x720@60Hz 45 
60.023 
VGA 
VGA 
VGA  640x480@75Hz 
Dos-mode
SVGA 
SVGA 
800x600@72Hz 
SVG A 
800x600@75Hz 
SVG A  832
x624 @75Hz 
XGA 1024x768@60Hz 
1024 x768@70Hz 
XGA 
XGA 
  1600x900 @60Hz 
60 
60
720P
WSXGA
 
						

							 53
Pin Assignments 
 
 
 
Pin Number 15-Pin Side of the Signal Cable 
1 Video-Red 
2 Video-Green 
3 Video-Blue 
4 N.C. 
5 Detect Cable 
6 GND-R 
7 GND-G 
8 GND-B 
9 +5V 
10 Ground 
11  N.C. 
12 DDC-Serial data 
13 H-sync 
14 V- s yn c  
15 DDC-Serial clock 
 
 
						

							 54  
 
Plug and Play 
Plug & Play DDC2B Feature 
 
This monitor is equipped with VESA DDC2B capabilities according to the VESA DDC STANDARD. It allows the 
monitor to inform the host system of its identity and, depending on the level of DDC used, communicate additional 
information about its display capabilities. 
 
The DDC2B is a bi-directional data channel based on the I2C protocol. The host can request EDID information over 
the DDC2B channel.
 
						

							 55
Regulation 
FCC Notice 
 
FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS) 
 
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference 
in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not 
installed and used in accordance with the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the following measures: 
 
Reorient or relocate the receiving antenna.   
Increase the separation between the equipment and receiver.   
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.   
Consult the dealer or an experienced radio/TV technician for help.   
 
 
NOTICE : 
 
The changes or modifications not expressly approved by the party responsible for compliance could void the users 
authority to operate the equipment.   
Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission limits.   
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to this 
equipment. It is the responsibilities of the user to correct such interference. It is the responsibility of the user to 
correct such interference.
 
						

							 56
WEEE Declaration 
Disposal of Waste Equipment by Users in Private Household in the European Union.   
 
 
This symbol on the product or on its packaging indicates that this product must not be disposed of with your other 
household waste.Instead, it is your responsibility to dispose of your waste equipment by handing it over to a 
designated collection point for the recycling of waste electrical and electronic equipment.The separate collection 
and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure 
that it is recycled in a manner that protects human health and the environment. For more information about where 
you can drop off your waste equipment for recycling, please contact your local city office, your household waste 
disposal service or the shop where you purchased the product . 
 
 
HG Declaration 
SAFETY: Lamp Disposal   
LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE RECYCLED OR DISPOSED OF 
ACCORDING TO LOCAL, STATE OR FEDERAL LAWS. FOR MORE INFORMATION, CONTACT THE 
ELECTRONIC INDUSTRIES ALLIANCE AT WWW.EIAE.ORG
. 
 
 
 
						

							 57
EPEAT Declaration 
 
EPEAT is a system to help purchasers in the public and private sectors evaluate, compare and select desktop 
computers, notebooks and monitors based on their environmental attributes. EPEAT also provides a clear and 
consistent set of performance criteria for the design of products, and provides an opportunity for manufacturers to 
secure market recognition for efforts to reduce the environmental impact of its products.   
 
 
AOC believes in protecting the environment. 
With a key concern for the conservation of natural resources, as well as landfill protection, AOC announces the 
launch of AOC monitor’s packaging recycling program. This program is designed to help you discard of your 
monitor carton and filler materials properly. If a local recycling center is not available, AOC will recycle the 
packaging material for you, including foam filler and carton. AOC Display solution will only recycle AOC monitor 
packaging. Please refer to the following website address: 
 
Only for North and South American, excluding Brazil: 
http://us.aoc.com/about/environmental_impact
 
 
For Germany:   
http://www.aoc-europe.com/en/service/tco.php
 
 
For Brazil:   
http://www.aoc.com.br/2007/php/index.php?req=pagina&pgn_id=134
 
						

							 58
Service 
Warranty Statement for Europe 
LIMITED THREE-YEAR WARRANTY*   
AOC Color Monitors sold within Europe   
AOC International (Europe) GmbH warrants this product to be free from defects in material and workmanship for a 
period of Three (3) years after the original date of consumer purchase. During this period, AOC International 
(Europe) GmbH will, at its option, either repair the defective product with new or rebuilt parts, or replace it with a 
new or rebuilt product at no charge except as *stated below. The defective products that are replaced become the 
property of AOC International (Europe) GmbH.   
 
If the product appears to be defective, please contact your local dealer or refer to the warranty card when attached 
to the product.   
 
Deliver the product freight pre-paid, along with the dated proof of purchase, to the AOC Authorized Service Center. 
If you cannot deliver the product in person:   
 
Pack it in its original shipping container (or equivalent)   
Put the RMA number on the address label   
Put the RMA number on the shipping carton   
Insure it (or assume the risk of loss/damage during shipment)   
Pay all shipping charges   
 
AOC International (Europe) GmbH is responsible neither for any damage or loss during inbound transport damage 
nor to inbound product that was not properly packaged.   
 
AOC International (Europe) GmbH will pay the return shipping charges within one of the countries specified within 
this warranty statement. AOC International (Europe) GmbH is not responsible for any costs associated with the 
transportation of product across international borders. This includes the international border within the European 
Union.  
 
* This limited warranty does not cover any losses or damages that occur as a result of   
Shipping or improper installation or maintenance   
Misuse  
Neglect  
Any cause other than ordinary commercial or industrial application   
Adjustment by non-authorized source   
Repair, modification, or installation of options or parts by anyone other than an AOC Authorized Service Center   
Improper environment   
Excessive or inadequate heating or air conditioning or electrical powers failures, surges, or other irregularities   
 
This limited warranty does not cover any of the product firmware or hardware that you or any third party have 
 
						

							 59 modified or altered; you bear the sole responsibility and liability for any such modification or alteration. 
 
ALL EXPRESS AND IMPLIED WARRANTIES FOR THIS PRODUCT (INCLUDING THE WARRANTIES OF 
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE) ARE LIMITED IN DURATION TO A 
PERIOD OF THREE (3) YEARS FOR PARTS AND LABOR FROM THE ORIGINAL DATE OF CONSUMER 
PURCHASE. NO WARRANTIES (EITHER EXPRESSED OR IMPLIED) APPLY AFTER THIS PERIOD.   
 
AOC INTERNATIONAL (EUROPE) GMBH OBLIGATIONS AND YOUR REMEDIES HEREUNDER ARE SOLELY 
AND EXCLUSIVELY AS STATED HERE.   AOC INTERNATIONAL (EUROPE) GMBH LIABILITY, WHETHER 
BASED ON CONTRACT, TORT, WARRANTY, STRICT LIABILITY, OR OTHER THEORY, SHALL NOT EXCEED 
THE PRICE OF THE INDIVIDUAL UNIT WHOSE DEFECT OR DAMAGE IS THE BASIS OF THE CLAIM. IN NO 
EVENT SHALL AOC INTERNATIONAL (EUROPE) GMBH BE LIABLE FOR ANY LOSS OF PROFITS, LOSS OF 
USE OR FACILITIES OR EQUIPMENT, OR OTHER INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGE. 
SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL 
DAMAGES, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. ALTHOUGH THIS LIMITED WARRANTY 
GIVES YOU SPECIFIC LEGAL RIGHTS, YOU MAY HAVE OTHER RIGHTS, WHICH MAY VARY FROM 
COUNTRY TO COUNTRY. THIS LIMITED WARRANTY IS ONLY VALID FOR PRODUCTS PURCHASED IN THE 
MEMBER COUNTRIES OF THE EUROPEAN UNION.   
 
 
Information in this document is subject to change without notice. 
For more details, please visit: http://www.aoc-europe.com/en/service/index.php 
 
 
						

							 60
Warranty Statement for North & South America (excluding Brazil) 
WARRANTY STATEMENT     
for AOC Color Monitors 
Including those Sold within North America as Specified 
 
Envision Peripherals, Inc. warrants this product to be free from defects in material and workmanship for a period of 
three (3) years for parts & labor and one (1) year for CRT Tube or LCD Panel after the original date of consumer 
purchase. During this period, EPI ( EPI is the abbreviation of Envision Peripherals, Inc. ) will, at its option, either 
repair the defective product with new or rebuilt parts, or replace it with a new or rebuilt product at no charge except 
as *stated below. The parts or product that are replaced become the property of EPI. 
 
In the USA to obtain service under this limited warranty, call EPI for the name of the Authorized Service Center 
closest to your area. Deliver the product freight pre-paid, along with the dated proof of purchase, to the EPI 
Authorized Service Center. If you cannot deliver the product in person: 
 
Pack it in its original shipping container (or equivalent)   
Put the RMA number on the address label   
Put the RMA number on the shipping carton   
Insure it (or assume the risk of loss/damage during shipment)   
Pay all shipping charges   
 
EPI is not responsible for damage to inbound product that was not properly packaged. 
EPI will pay the return shipment charges within one of the countries specified within this warranty statement. EPI is 
not responsible for any costs associated with the transportation of product across international borders. This 
includes the international borders of the countries within this warranty statements. 
 
In the United States and Canada contact your Dealer or EPI Customer Service, RMA Department at the toll free 
number (888) 662-9888. Or you can request an RMA Number online at www.aoc.com/na-warranty. 
 
* This limited warranty does not cover any losses or damages that occur as a result of:   
 
Shipping or improper installation or maintenance   
Misuse  
Neglect  
Any cause other than ordinary commercial or industrial application   
Adjustment by non-authorized source   
Repair, modification, or installation of options or parts by anyone other than an EPI Authorized Service Center   
Improper environment   
Excessive or inadequate heating or air conditioning or electrical power failures, surges, or other irregularities   
 
This three-year limited warranty does not cover any of the products firmware or hardware that you or any third 
party have modified or altered; you bear the sole responsibility and liability for any such modification or alteration.