AMT Datasouth Printer Fastmark 4600 PLUS Quick Start Guide

 
                                 P/N 140121 Rev B                                                Page   1/6 
Quick Installation Guide  
Direct and Transfer Thermal Printer 
 
 
Overview 
 
The enclosed printer is currently 
comprised of two models: 
 
 203dpi (dots per inch) model 
 300dpi (dots per inch) model 
 
 
Unpacking 
 
1. Remove top foam packing piece. 
2. Lift printer straight up out of box. 
3. Remove accessory kit and supplies. 
4. Remove printer from plastic bag. 
 
NOTE:    Save  box...

P/N 140121 Rev B                                                Page   2/6 
Installation 
 
1. Determine a suitable location for the 
printer with the following 
requirements: 
 Flat  stable  surface  with  sufficient 
clearance  to  allow  for  interface 
cables and media loading. 
 Free  from  excessive  direct 
sunlight,  temperature,  humidity, 
dust, dirt, and debris. 
 Near  a  grounded  AC  power 
receptacle  wired  in  compliance 
with local ordinances. 
2. Ensure  printer Power  Switch is...

P/N 140121 Rev B                                                Page   3/6 
Loading Media 
 
1. Fully open Media Access Cover. 
2. Open  the Front  Access  Door by 
rotating down. 
3. Rotate  the  green Printhead  Latch 
counterclockwise  to  open  the 
printhead. 
4. Rotate  the Side  Access  Door down 
to  allow  the  media  to  be  loaded 
under the printhead module. 
5. Pull  down  to  unlock  and  slide  the 
Media  Supply  Guide to  the  full 
widest/open position. 
6. Ensure  the  media  is face...

P/N 140121 Rev B                                                Page   4/6 
 
15. Grasping  the Sensor  Adjust  Knob 
and sliding it in or out as needed can 
move  the Media  Sensor.  This  is 
required  only  if  the  sensor  must  be 
moved  to  a  specific  location  on  the 
label to detect a notch (hole) or gap. 
16. IMPORTANT: To  ensure  proper 
media  feeding  and  sensor  operation, 
complete the following checklist: 
 Media  is  wound  face  (print  side) 
out  and  feeding  off  the  top  of...

P/N 140121 Rev B                                                Page   5/6 
 
Loading Ribbon 
1. If  needed,  follow  steps  1-4  under 
Loading Media section. 
2. Unwrap  the  ribbon  and  place  the 
Ribbon Supply  Roll on  the Ribbon 
Supply  Spindle located  towards 
back of printer. 
3. Place  the Ribbon Take-up core  on 
the Ribbon  Take-Up  Spindle 
located  towards  the  front  of  the 
printer. 
4. Slide  both  cores  completely  towards 
the center of the printer. 
5. Route  the  ribbon  under...

P/N 140121 Rev B                                                Page   6/6 
 
Installing Windows Drivers 
Windows  drivers  are  included  with  each 
printer  on  CD.  Run  the  printer 
installation  setup,  as  required  for  the 
version Windows you are using.   
 
 
Setting Printer Features 
 
 Press PAUSE, verify mode on LCD 
display. 
 Press FEED and PAUSE at the 
same time to enter setup mode. 
 Press and hold FEED, use CANCEL 
to scroll through the list of features. 
 Press CANCEL to select...