Amptron ATB60 user manual

							 ALTERNATOR  TEST  BENCH
 ATB60  
          BATTERY VOLTAGE 
                 SELECTOR
Range:  select 12 or 24 V
Low cost basic electrical 
test bench for fleet owners, 
cars, LDVs etc. 
DC POWER SOURCE
2 x 12 volt 50 Amp/Hr Batteries  (not supplied)
Battery shelf with cables fitted with post 
connectors for easy installation. 
ALTERNATOR OUTPUT
            CURRENT
0- 100 A    Analog  only
With normal and reverse
selector switch
BATTERY VOLTAGE
Range:  0-30 Volt Analog 
ALTERNATOR 
FAULT LAMPS
  12 or 24 volt
BATTERY LOAD TESTER
  & STARTER CURRENT
         ( FREE RUN)
       Manual selected: 
Dinse socket & plug
Range: 0-250A  0- 500A
 
 With normal and reverse
 selector switch
     ALTERNATOR LOAD
 20 Block 500 amp carbon 
 pile variable unit
DESIGNED AND MANUFACTURED IN SOUTH AFRICA
Appearance And specifications listed in this brochure are subject to change without notice
Measurements done: analog   109 x 66    
     
INDICATING INSTRUMENTS
UNIT DIMENSIONS  H x W x D   520 x 630 x 850
DRIVE SYSTEM
Rotation:   REV  OFF  FWD  Rotary
switch.   Motor 2.2 KW high torque
Motor pulley: accommodate V and 
flat  belts  diameter:  120 mm  Belt 
driven with tension lever
AC POWER  SOURCE
Voltage:                  220 Volt AC
Phases:                        1 Phase
Frequency:                  50 Hertz
Power consumption:    2.2 KW
Mains switch: 1 pole 16A MCB
Mains lead:      3  meter 1.5 sq
3  Wire  with  earth  &  neutral
AMPTRON
SOLENOID VOLTAGE
Manual  push  button with overload
MCB 16 A Range:  12 or 24 V 
Battery  cables outlets  right hand
side of bench. Easy transportable 
      (bench top  LDV model)
Working   area   covered  with  a  
rubber  mat.  Bench  fully isolated 
from  battery  poles.  Starter  test 
free run.   Full  set  of  test  leads