DC POWER SOURCE
4 x 6 volt 150 Amp/Hr Batteries (not supplied)
Battery shelf with cables fitted with post connectors for easy installation. Power supply: 2 independent 6 volt and one 12 volt linear regulators with current limit set at 5 amp and Voltage at 6.9-13.8 V wired to keep the batteries
always fully charged. (On /off switch for manual use)With active convection cooling
REGULATOR TEST
Range: 12 / 24 / 32 Volt
Meter: 0-50Volt Analog
& Digital 6 wire system
Din plug with harness
DIODE...
DC POWER SOURCE
2 x 12volt 180 Amp/Hr Batteries (not supplied)
Battery shelf with cables fitted with post
REGULATOR TEST
Range: 12/24/32 Volt
Meter: 0-50Volt Analog & Digital
6 wire system Din plug with harness
DIODE TEST
Test Voltage 99 V pp
Green LED: good
LOW RESISTANCE METER
Analog & Digital
3 Ranges: 1 10 100 Ohm
ALTERNATOR OUTPUT
CURRENT
0- 300 A Analog & Digital
With normal and reverse
selector switch
BATTERY VOLTAGE
Range: 0-50 Volt Analog & Digital
ALTERNATOR
FAULT...
ALTERNATOR TEST BENCH
ATB60
BATTERY VOLTAGE
SELECTOR
Range: select 12 or 24 V
Low cost basic electrical
test bench for fleet owners,
cars, LDVs etc.
DC POWER SOURCE
2 x 12 volt 50 Amp/Hr Batteries (not supplied)
Battery shelf with cables fitted with post
connectors for easy installation.
ALTERNATOR OUTPUT
CURRENT
0- 100 A Analog only
With normal and reverse
selector switch
BATTERY VOLTAGE
Range: 0-30 Volt Analog
ALTERNATOR
FAULT LAMPS
12 or 24...
AC POWER SOURCE
Voltage: 380 Volt AC
Phases: 3 Phase
Frequency: 50 Hertz
Power consumption: 7.5KW
Mains switch: 3 pole 25 A MCB
Mains lead: 4 metre 2.5 sq
5 Wire with earth & neutral
DC POWER SOURCE
2 x 12 volt 150 Amp/Hr Batteries (not supplied)
Battery shelf with cables fitted with post
connectors for easy installation.
FIELD CURRENT SUPPLY
Voltage range: 13.8 V fixed
Current range: 0-5 A variable
Meter: 0 -...
ALTERNATOR TEST BENCH
ATB700
ALTERNATOR OUTPUT
CURRENT
Range: 0-100 Amperes
BATTERY VOLTAGE
SELECTOR
Range: select 12 or 24 V
Battery cables outlets right hand side of bench
Easy transportable normal door entry
(bench top model)Working area covered with a rubber mat
Bench fully isolated from battery poles
Starter test free run
Full set of test leads
Low cost efficient electrical
test bench for fleet owners,
cars, LDVs etc.
DC POWER SOURCE
2 x 12 volt 50...
User and Installation Guide
BlueFIDELITYTM
Bluetooth Audio Amplifier
Model 300Connect the AC adapter with the amplifier
BEFORE plugging the AC adapter into an
outlet to avoid spark generation!
The Charger operates in a constant voltage/current mode.
It is designed to have a square type of characteristic as illustrated. When the battery is low, the charger is under
the control of the current feedback signal, thus ensuring that a constant current is applied to the battery. Under
these conditions the battery voltage will rise slowly untilthe predetermined constant voltage setting is reached. At this point the charger current will decrease while the charger operates...
User and Installation Guide
microFIDELITYTM
Digital-to-Analog Converter/Amplifier
Model 250Connect the AC adapter with the amplifier
BEFORE plugging the AC adapter into an
outlet to avoid spark generation!
EDUCATIONAL EQUIPMENTP O Box 137 Parow 7499 Bellville 7530 27 21 9300929 / 32 27 21 9300934Fax:E-mail:[email protected] site:Tel:Unit 8 Boulevard Park
Off Boulevard Drive
Cape Town MPTRONAELECTRONICS (Pty) LtdREG. NO: 79/02792/07
R
User and Installation
Guide
Digital Wireless
Audio TransmitteriFiniy t
TM
R
User and Installation
Guide
Digital Wireless
Audio Receiver
iFini
y t
TM
05257595100
User and Installation
Guide
Digital Wireless
Indoor / Outdoor SpeakeriFiniy t
TM
R
User and Installation Guide
microFIDELITY
TM
Digital Audio Amplifier
Model 200
Connect the AC adapter with the amplifier
BEFORE plugging the AC adapter into an
outlet to avoid spark generation!
Us
M
M
Us
W
M
Us
W
M
