Home > Altek > Calibrator > Altek Process Calibrator TechChek 820 Manual Supplement

Altek Process Calibrator TechChek 820 Manual Supplement

    Download as PDF Print this page Share this page

    Have a look at the manual Altek Process Calibrator TechChek 820 Manual Supplement online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 45 Altek manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							Supplement   
    © 2002 Altek Industries, Inc. All rights reserved. Printed in U.S.A.
    Manual Title: 820 Supplement Issue:1
    Part Number: 1839053 Issue Date: 6/02
    Revision/Date: Rev A April 2002
    This supplement contains information necessary to ensure the
    accuracy of the above manual.
    Safety Information
    4Caution, risk of Danger; read the manual with particular attention to WARNINGS and
    user operation.
    -Conforms to European Low Voltage 73/23/EEC, EN61010-1 + Amendments 1,2 and
    EMC Directive 89/336/EEC standard EN61326
    #
    Direct Current:  For this product only direct currents and voltages are applicable
    1Equipment protected throughout by DOUBLE INSULATION or REINFORCED
    INSULATION
    CAT IOVERVOLTAGE CATEGORY I: Signal level, special equipment or parts of equipment,
    telecommunications, electronics, etc., with smaller transient overvoltages than
    OVERVOLTAGE CATEGORY II.
    Cleaning Instructions
    Clean with mild soap and water with care applied in removing any excess soap or water.
    4
     WARNINGS
     4
    · If the equipment is used in a manner not specified by the manufacturer,
    the protection provided by the equipment may be impaired.
    · Before use, verify the meter’s operation by measuring a known voltage
    or current.
    · Inspect the test leads for damaged insulation or exposed metal and do
    not used if damaged.
    · Do not use this product if it is damaged. Before you use the product,
    inspect the case. Look for cracks or missing plastics.   Pay particular
    attention to the insulation surrounding the connectors.
    · To avoid false readings, which could lead to possible electric shock or
    personal injury, replace the batteries as soon as the low battery
    indicator appears.
    · When using the probes, keep your fingers behind the exposed metal by
    at least 10mm.
    · Do not operate the meter with the instrument open.
    · Remove test probes from any measurement circuits prior to opening or
    changing batteries.
    · Use only 9V alkaline batteries. 
    						
    All Altek manuals Comments (0)

    Related Manuals for Altek Process Calibrator TechChek 820 Manual Supplement