AllTrade Tradespro 19 Gal Vertical Air Compressor 835534 User Manual

ASSEMBLY INSTRUCTIONS
THE COMPRESSOR IS SHIPPED WITHOUT OIL IN THE CRANKCASE. ADD OIL AS INDICATED BELOW.
STEP 1 – PUMP LUBRICATION
This air compressor features an oil lubricated pump that requires the use of SAE 30 weight non-detergent air compressor oil.
Adding Compressor Oil:
1. Place air compressor on a flat, level surface.
2. Remove plastic oil fill 
breather plug (see Fig. 1).
4. See diagram for determining proper oil fill level using oil fill sight glass 
(see Fig. 3).
5. Install supplied plastic...

OPERATION
INITIAL SETUP / BREAK-IN PROCEDURE:
Do not attach air hose, air tools or other air accessories to the air outlet until break-in procedure has been successfully completed.
1. Read and understand the entire instruction manual, including all safety warnings before setting up air compressor.
2. Place air compressor on a flat, level surface.
3. Check oil fill level in crankcase and add oil as needed.
4. Turn the pressure regulator knob fully clockwise to open airflow from air outlet port. 
Be...

SHUTDOWN AND STORAGE:
NOTE: NEVER stop the air compressor by unplugging it from the power outlet as this may result in damage to the compressor.
1.Turn the switch to the OFF position
2.Disconnect the power cord from the power outlet by grabbing the plug (not the cord). Loop around handle for storage.
3.Turn the pressure regulator knob fully counterclockwise to close airflow from air outlet port. Check the outlet pressure gauge to ensure that
it reads 0 PSI.
4.Remove the air hose and any air accessories....

CHECKING SAFETY RELIEF VALVE:
SAFETY RELIEF VALVE MUST BE REPLACED IF IT CANNOT BE ACTUATED OR IT LEAKS AIR AFTER THE RING IS RELEASED.
1. The air compressor must be turned OFF.
2.Disconnect compressor from the power source.
3. Open tank drain to bleed off all air pressure before attempting any maintenance or repair.
4. Allow compressor to fully cool before attempting any maintenance or repair.
5.  Grasp the wire ring on the safety relief valve.
6. Pull and release the ring a few times to ensure that the...

13
TROUBLESHOOTING GUIDE
Problem EncounteredPossible CausePossible Solution
The compressor does not start or restart:Power cord not plugged in.Plug cord into grounded outlet.
Motor/Pressure switch in OFF positionMove switch to AUTO position.
Motor thermal overload switch hastripped.Turn air compressor off, wait until the motor is cool, thenpress motor thermal overload (red) button firmly until click is heard.
Fuse blown or circuit breaker hastripped.Replace fuse or reset circuit breaker.
Check for proper...

14
TROUBLESHOOTING GUIDE
Problem EncounteredPossible CausePossible Solution
Air continues to leak atmotor/pressure switch releasevalve while motor is running:
Defective motor/pressure switch.Replace.
Check valve stuck in open position.Replace check valve. DANGER—Do not disassemble thecheck valve with tank pressurized. Open tank petcock valveto allow air to escape from tank prior to servicing.
Air leaks from safety reliefvalve:Possible defective safety relief valve.Operate safety relief valve manually by...

PARTS LIST
15
NO.PART NO.DESCRIPTIONQTYNO.PART NO.DESCRIPTIONQTY
1835534-1Air Filter155835534-55Bushing2
2835534-2Connector156835534-56Wheel2
3835534-3Bolt M8x103457835534-57Bolt M102
4835534-4Cylinder Head158835534-58Foot1
5835534-5Cylinder Head Gasket159835534-59Nut1
6835534-6Valve Plate160835534-60Power Cord1
7835534-7Valve Plate Gasket161835534-61Pressure Switch1
8835534-8Column262835534-62Safety Valve1
9835534-9Valve163835534-63Pressure Gauge2
10835534-10Cylinder164835534-64Quick Coupler1...

16
PARTS DIAGRAM  

ONE YEAR LIMITED WARRANTY
ALLTRADE TOOLS LLC AIR COMPRESSORS
Express and Exclusive Limited Warranty to Original Retail Buyer
Alltrade Tools LLC (hereinafter “Alltrade”) expressly warrants to the original retail purchaser of the accompanying air compressor and no one
else all parts of the product (except those parts referred to below which are specifically excluded from such warranty (see Exclusions)) to be free
from defects in materials and workmanship during the following periods from the original date...

Alltrade will not be liable for the following: labor charges, loss or damage resulting from improper operation, maintenance or repairs made by
other persons; pre-delivery services such as assembly, oil or lubricants, and adjustment; maintenance services that are normally required to
maintain the air compressor.
The use of other than genuine Alltrade Repair Parts will void warranty.
Warranty Disclaimers 
EXCLUSION AND DISCLAIMER OF ALL OTHER EXPRESS WARRANTIES, GUARANTIES AND/OR REPRESENTATIONS. EXCEPT...