Home > Alarm Lock > Alarm Lock > Alarm Lock ETDLCylinder Adapter Kit Addendum User Manual

Alarm Lock ETDLCylinder Adapter Kit Addendum User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Alarm Lock ETDLCylinder Adapter Kit Addendum User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 84 Alarm Lock manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							CYLINDER ADAPTER KIT 
     
    ADDENDUM 
    WI 1177  1/03 
    CAUTION 
    PROPER ALIGNMENT OF GEARS IS CRITICAL! 
     
    FAILURE TO ALIGN GEARS PROPERLY WILL CAUSE LOCK TO MALFUNCTION.   
    345 Bayview Avenue 
    Amityville, New York 11701 
    For Sales and Repairs 1-800-ALA-LOCK 
    For Technical Service 1-800-645-9440 
    © ALARM LOCK 2003 
    Note:  See the illustrated instructions, WI 1163, 
    How to Replace Cylinder for detailed replace-
    ment procedures.  After inserting the new cylin-
    der and Slide Plate, and before replacing the 
    Cover Plate (step 16), align the gears as follows: 
     
    The rollpin hole located on the Spindle Bush-
    ing (HW970) must be aligned with the 
    stamped arrow on the Gear Driver (HW968).  
    Using a straight edge (or for convenience you 
    can use the Cover Plate HW1016 instead of a 
    straight edge) align the gears as shown in the il-
    lustration at right: 
     
    Place one end of the straight edge directly over 
    the center retaining screw of the Gear Driver.  
    Align the other end of the straight edge with the 
    rollpin hole.  The stamped arrow (!) on the Gear 
    Driver must be directly underneath the straight 
    edge when aligned with the rollpin hole.   
     
    If the arrow is not aligned, loosen the Gear 
    Driver retaining screw, lift the Gear Driver.  The 
    Slide Plate springs will cause the Spindle Bush-
    ing to self-align (if the Slide Plate is installed 
    properly).  Re-position the Gear Driver until the 
    arrow is aligned with the rollpin hole.  Tighten the 
    Gear Driver Retaining screw, and Replace the 
    Cover Plate and Frame Spacer as per the direc-
    tions in WI 1163. 
    Rollpin hole 
    on Spindle 
    Bushing 
    (HW970) 
    Idle Gear 
    (HW967) 
    Stamped 
    Arrow on 
    Gear Driver 
    (HW968) 
    Gear Driver 
    retaining 
    screw  
    						
    All Alarm Lock manuals Comments (0)

    Related Manuals for Alarm Lock ETDLCylinder Adapter Kit Addendum User Manual