Airpura Air Purifier P 600 User Manual

							
Operating 
& Filter Replacement 
Directions

Thank You for choosing an 
Airpura High Efficiency Air Purifier
To bring you the benefits of clean indoor air 

To Begin Using Your Airpura...

Inspect the exterior of your Airpura to verify there is no 
damage from shipping. If any damage is noted please 
follow the instructions in the Airpura returns policy.
Wipe the unit with a damp cloth to remove any dust from 
packaging
Plug the unit into a regular grounded 110 volt outlet
Turn on the unit to MAX and allow it to run for a few minutes
Set the variable speed control to the level you wish
The most efficient way to use your Airpura for regular air 
quality maintenance is to run it at a low speed 24 hours a 
day 7 days a week

Feel the difference breathing clean air makes
 to your health

Replace the 
4 screws and 
tighten
Turn the 
Airpura
back onto 
its casters
Replace the 
gasket
To close the filter chamber
Position the 
indentation
in the cover
into the center of
the HEPA filter
P600
Open the filter chamber following the instructions on page 2
Pull the bulb and reflector together upward out of the 
connector
Push the replacement bulb firmly into the connector
Airpura limited warranty
5 years on parts and 10 years labor
Details on line at www.airpura.com
Replacing the UV Bulb and
TitanClean Reflector
TM
Place the reflector around the bulb and replace the retaining 
screws
Snip off the plastic retainer (for shipping only: does not need 
to be replaced)
Unscrew the 2 retaining screws of the reflector
Close the filter chamber following instructions on page 4 
						

							 
 

Filter Maintenance and Replacement 



The HEPA Filter
 


 
 

The Activated Carbon Filter




Can be vacuumed from the exterior of the unit
once a month or more often.
Should be replaced at least after 12 months of use




Should be replaced at least every 3 to 5 years of normal 
use 


 

Remove the 
4 retaining 
screws



Take off 
the cover


  
   
Let the spiral open to fill the opening
Open the top of the spiral to make a slight funnel
Insert the carbon canister into the funnel and hold it straight
Let the canister slidedown the filter slider
Pull the filter slider upout of the cavity using both hands and let the canister slide to the bottom of the cavity
Remove the filterslider and fold it for further use 

Place a felt gasketat the bottom of the filter chamber
Position the pre-filterinside the filter chamber