Air Live Router WL-5450AP User Manual

1 
User’s Guide 
Wireless Access Point  WL-5450AP & WL-5460AP  

2 
FCC Certifications 
This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules.    These limits are designed to provide reasonable protection 
against harmful interference in a residential installation.  This equipment generates uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications.  However, there is no guarantee...

3 
Table of Content 
Introduction............................................................................................................................................................4
 
FEATURES...................................................................................................................................................................4...

4 
INTRODUCTION 
AirLive WL-5450AP/WL-5460AP is an IEEE802.11b/g compliant 11 Mbps & 54 Mbps Ethernet 
Wireless Access Point.    The Wireless Access Point is equipped with two 10/100 M Auto-sensing 
Ethernet ports for connecting to LAN and also for cascading to next Wireless Access Point. 
AirLive WL-5450AP/WL-5460AP provides 64/128bit WEP encryption, WPA and IEEE802.1x 
which ensures a high level of security to protect users’ data and privacy.  The MAC Address filter 
prevents the unauthorized MAC...

5 
Application 
Example 1 
 
Example 2 
  

6 
Parts Names and Functions 
1. Front Panel: (LED Indicators) 
 
 
 
 LED  Status 
 Indicator Color  Solid  Flashing 
1 Power  Green  Turns solid green when power is 
applied to this device.   N/A. 
2 Status Red Turns solid red when the device is 
booting, after boot successfully, 
the light turn off.  
Link/Act.   Green    Turns solid green when connected 
and associated to at least a client 
station.  Receiving/ 
Sending data 
WEP/WPA Orange  Turns solid orange when wireless 
security is enabled. N/A...

7 
2. Rear Panel: Connection Ports 
 
 
 Port/button   Functions 
A 12V DC Connects the power adapter plug   
B LAN1 Connects to Ethernet 
C LAN2 Connects to Ethernet 
D 
 (Factory)  
RESET Press over 3 seconds to reboot this device. 
Press for over 10 seconds to restore factory settings.   
Performing the Factory Reset will erase all previously 
entered device settings. 
 
Table 2: Connection Ports  

8 
Factory Default Settings   
Setting Wireless Access Point 
Device Name 
WL-5460AP 
SSID 
Default value: airlive 
Channel 11  
WEP Default value: Disabled 
IP Address 192.168.100. 252 
ƒ  
  

9 
HARDWARE CONNECTION 
Note: Before you starting hardware connection, you are advised to find an appropriate location to 
place the Access Point. Usually, the best place for the Access Point is at the center of your wireless 
network, with line of straight to all your wireless stations. Also, remember to adjust the antenna; 
usually the higher the antenna is placed, the better will be the performance.   
 
1. Connect to your local area network: connect a Ethernet cable to one of 
the Ethernet port (LAN1...

10 
ABOUT THE OPERATION MODES   
This device provides four operational applications with Access Point, Bridge, 
Client (Ad-hoc) and Client (Infrastructure) modes, which are mutually 
exclusive.  
This device is shipped with configuration that is functional right out of the box. If 
you want to change the settings in order to perform more advanced configuration 
or even change the mode of operation, you can use the web-based utility 
provided by the manufacturer as described in the following sections....