AIPTEK Pocketcinema V50 Users Manual

							Downloaded from www.Manualslib.com manuals search engine Downloaded From projector-manual.com Aiptek ManualsUser’s Manual 
www.aiptek.eu Page 21 
EN 
Specifications 
 
Item Description 
Optical Technology DLP 
Light Source RGB LED 
Aspect Ratio 16:9 (4:3 compatible) 
Luminous Flux Up to 50 Peak Lumens   
(*ANSI Lumens: 40 Lumens) 
Resolution 854 x 480 Pixel (WVGA) 
Projection Image Size 25cm ~ 215cm (9” ~ 85”) 
Projection Distance 35cm ~ 300cm (14” ~ 118”) 
Zoom & Focus Manual 
Contrast Ratio 2000:1 
Throw Ratio (Diagonal: Distance) 1.59 (Projection Distance/Width of Image) 
Offset 100% 
Playback Format Photo: JPEG, BMP 
Video: H.264: *.mov, *.avi, *.mp4, *.3gp 
MPEG-4: *.mov, *.avi, *.mp4, *.3gp 
Audio: *.mp3, *.wav, *.ogg 
Document: *.ppt, *.pdf (converting via bundled software)
Audio Speaker Mono 
Built-in Memory 128MB 
Memory Slot SD/SDHC/MMC card up to 32GB 
Power Supply Input: 220 ~ 240V AC 
Output: 5V, 3.6A DC 
Battery Life Enhanced Mode: 60min 
Eco Mode: 120min 
Power Consumption 1. Power Mode: Enhanced: 11.7W, Eco: 6.2W 
2. Battery Mode: Enhanced: 11.4W, Eco: 4.8W 
Weight 225g 
Dimension 134 x 69 x 25 mm 
Model Code RPT2 (V50) 
Humidity 20-80%, 80% (Max.), non-condensing. 
Operating Temperature 0° - 35°C. 
   
						

							Downloaded from www.Manualslib.com manuals search engine Downloaded From projector-manual.com Aiptek ManualsUser’s Manual 
www.aiptek.eu Page 22 
EN 
Troubleshooting 
If your projector does not seem to be functioning properly, check the items below before you 
contact an authorized service center. 
 
 
 
 
Reset Your Device 
Occasionally, you may need to reset your Micro Projector. 
This can be useful when a program is not performing 
properly. 
Locate the small hole on the down of the device shown as 
the RESET. 
Using the tip of paper clip, gently push the button inwards. 
 
 
 
 
Symptom Check Point 
The projector can not be turned on. ● Check if the USB Cable is plugged correctly. 
● Make sure the PC has been switched to projector display. 
The projected image is too dark. ● Use the projector in a darker environment. 
● Increase the brightness by using the AC power adapter. 
● Decrease the size of projected image. 
The projected image is dim. ● Adjust the focus. Please refer to “Adjusting the Focus”. 
● Check if the lens is dirty. 
The surface temperature of projector ascended. 
● Because of the high-luminance LED equipped, it is normal for this projector to generate heat in long-time use. This will not affect the performance of projector. The projector case will help to dissipate heat so that its surface temperature will ascend. Always keep the ventilation slots free of dirt or obstructions and operate the projector in a properly ventilated environment. 
 
 
Reset Hole