Aiphone ISWBCE ISWBCA Instructions User Manual

							IS-WBCA, IS-WBCE
Stainless Steel Wall Mount Box with Assistance or Emergency Signage and a Light Cage 
-INSTRUCTIONS-
Pg.1
The IS-WBCA wall box comes with “ASSISTANCE” in reflective blue lettering on both sides of the box.  
A blue beacon/strobe is mounted on top enclosed in a vandal resistant cage.
The IS-WBCE wall box comes with “EMERGENCY” in reflective red lettering on both sides of the box.  
A blue beacon/strobe is mounted on top enclosed in a vandal resistant cage.
The IS-WBCA, and IS-WBCE are made of 12 Gauge stainless steel and are weather/vandal resistant.  
The wall boxes’ narrow 4” depth allows it to meet all ADA mounting requirements. The blue beacon/
strobe requires a 24V DC power source, not included. Compatible emergency / assistance sub 
stations include the IX-DF-2RA, IX-SS-2RA, IX-SS-RA, IS-SS-RA, IS-SS-2RA, and IS-DVF-2RA.
IS-WBCA
Wall box with 
Light Cage and Blue  Assistance Signage IS-WBCE
Wall box with 
Light Cage and Red 
Emergency Signage 
						

							Pg. 2
IS-WBCA, IS-WBCE
0115JD
Aiphone Corporation
1700 130th AVE NE * Bellevue, WA 98005
Ph: (800) 692-0200 * Fax: (425) 455-0071
[email protected] FREE TECHNICAL SUPPORT:
(800) 692-0200
E-MAIL: [email protected]
MOUNTING / WIRING:
The IS-WBCA / IS-WBCE wall box comes pre-assembled with the beacon/strobe and the c\
age 
attached. Mount the box to the wall, then wire the beacon/strobe, as wel\
l as the intercom sub 
station. Complete installation by mounting the intercom sub station to the wall box. See below for 
additional information.
12”
4”OFFO
NNO
NOC
NC
C
NC1234
Relay board on back of sub stations
+ -
24VDC
Back View Front View
Secure the wall box to any flat surface 
using mounting hardware suitable for 
the surface you are mounting to.  Top 
mounting holes are 4” apart and top to 
bottom mounting holes are 12” apart. 
There are 3 knockouts on the back and 
2 underneath for routing wire. Connect the red and black wires from the beacon / 
strobe to a 24V DC power supply.  Red to positive 
and black to negative.  Connect the white trigger 
wire to the N/O side of relay 2 on the sub station.  
Connect a wire between the common of relay 2 and 
the positive terminal of the 24V DC power supply.  
See the sub station’s installation manual for its 
complete wiring and dip switch setting options.
SPECIFICATIONS:
Surface box:
Mounting:   
Surface mount directly to wall
Material:    12 Gauge Stainless Steel
Color:      Polished Stainless Steel
Dimensions:    
Box only    20” H x 8” W x 4” D
Including cage  26” H x 8” W x 4” D
Beacon / strobe:
Voltage:    24V DC
Current:    200mA
Wiring:    Black: Ground
      Red: +24V DC
   White: Trigger
Operating Temp:  -40°F to 149°F