Aiphone IS IP Network Direct Install Manual

							11
■ Connections (IS-IPDV and IS-IPDVF)
NOCOMNC
DC
24V
P
PT
LAN/PoE
CAT5e/6
*1:  A power supply unit is not needed when using a switch or injector that has a PoE (Power over Ethernet) function. The unit is supplied with power 
along with data signal via a LAN cable.
*2: Output specifi cations
Output method N/O or N/C dry closure contact
Voltage between
terminals24V AC, 0.5A (resistive load)
24V DC, 0.5A (resistive load)
Minimum overload (AC/DC): 
100mV, 0.1mA
NOTES:
Do not use the unoccupied terminals and ports for other purposes.
In order to prevent miswiring, label both ends of each cable with the unit and terminal names to which they are to be connected.
For connecting other manufacturer’s products, refer to the instruction manuals for those products.
The illustration of the unit’s rear panel differs from the actual one. This is for simplifying the connection diagram.
AC transformer
The terminals are inside the terminal • 
cover. After connecting, route the 
wires through the wiring paths, then 
close the cover.
Be sure to route the CAT5e/6 cable 
• 
and option wires through inlet.
When closing the terminal cover, 
• 
close it until it clicks.
Electric door strike *2
(non-shielded)
Terminal cover InletCAT5e/6 cableOption 
wires
Connect to the electric door strike 
according to its specifi cations.
Switch (Hub)
P: Polarized
15m (50) 100m (330)
10m (33)
10m (33)
10m (33)φ
0.65-1.2 (22-16AWG)-2C φ
0.65-1.2mm 
(22-16AWG)
φ
0.65-1.2mm 
(22-16AWG)
φ
0.65-1.2mm 
(22-16AWG)Power supply unit *1
(PS-2420/D/UL/S) 10BASE-T/100BASE-TX 
						

							12
TECHNICAL DATA AND PRECAUTIONS
Technical data
Operating temperature:• 
Color monitor IP master station (IS-IPMV) 0 - 40°C (+32°F - +104°F)
IP vandal-resistant video door station (IS-IPDV, IS-IPDVF) -10 - 60°C (+14°F - +140°F)
Dimensions:
• 
Color monitor IP master station (IS-IPMV) 250 (W) x 189 (H) x 59 (D) mm
9-7/8 (W) x 7-1/2 (H) x 2-3/8 (D)
IP vandal-resistant video door station (IS-IPDV) 105 (W) x 215 (H) x 32 (D) mm
4-3/16 (W) x 8-1/2 (H) x 1-5/16 (D)
IP vandal-resistant video door 
station (IS-IPDVF)IS-IPDVF 150 (W) x 265 (H) x 38 (D) mm
5-15/16 (W) x 10-7/16 (H) x 1-1/2 (D)
Flush mount back box 120 (W) x 235 (H) x 45 (D) mm
4-3/4 (W) x 9-5/16 (H) x 1-13/16 (D)
Weight:
• 
Color monitor IP master station (IS-IPMV) Approx. 820 g (1.81 lbs.)
IP vandal-resistant video door station (IS-IPDV) Approx. 540 g (1.19 lbs.)
IP vandal-resistant video door 
station (IS-IPDVF)IS-IPDVF Approx. 860 g (1.90 lbs.)
Flush mount back box Approx. 600 g (1.32 lbs.)
Technical precautions
Cleaning: Clean the units with a soft cloth dampened with a neutral household cleanser. Do not use an abrasive cleanser or cloth.•  
						

							13
WARRANTY
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of two 
years after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective upon which 
examination shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make the fi nal decision 
whether there is a defect in materials and/or workmanship; and whether or not the product is within the warranty. This warranty 
shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, power surge, or to use in violation of 
instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This warranty does not cover 
batteries or damage caused by batteries used in connection with the unit. This warranty covers bench repairs only, and any repairs 
must be made at the shop or place designated in writing by Aiphone. Aiphone will not be responsible for any costs incurred involving 
on site service calls. Aiphone will not provide compensation for any loss or damage incurred by the breakdown or malfunction of its 
products during use, or for any consequent inconvenience or losses that may result.
The object area of 
 is the EU.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause 
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired 
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment 
generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 
Reorient or relocate the receiving antenna
• 
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. Increase the separation • 
between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.
•  
						

							14
MEMO 
						

							15
MEMO 
						

							AIPHONE CO., LTD., NAGOYA, JAPAN
AIPHONE CORPORATION, BELLEVUE, WA, USA
AIPHONE S.A.S., LISSES-EVRY, FRANCE
http://www.aiphone.net/
Printed in Thailand