Agio International Umbrella Stand User Manual

							Page2MODEL # 477IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!Step 1:Identify all parts packed in the carton against the parts list. 
            Remove all protective materials. Set the parts on a flat,             non-abrasive surface. If you are missing any parts or are             unsure as to how to proceed with assembly please contact             our Customer Service Center immediately at 1-800-416-3511.              Do not attempt to assemble if any parts are missing or 
            damaged.
Step 2:Gently insert the extension pole into the base.  Using the 
            bolts provided, gently guide them through the bottom of             the umbrella  base and into the holes that  are pre-drilled             in the extension pole. Check the bolts to ensure they are            aligned properly. Using the hex bolt driver provided,               tighten each bolt a few revolution at a time until they            are fully tightened.  Do not over tighten.  Over tightening            could strip the boltsPARTS LISTQTY/PCSDESCRIPTION HEX BOLT DRIVERBOLT1
131BASEEXTENSION POLEStep 3:Your umbrella base is now ready for use. Carefully guide the 
            umbrella pole through the hole in the center of the table, and            if applicable, through the hole in the table connector ring, and             then into the base. Using the screw already in place in the             extension pole, turn until your umbrella pole is secure in the             extension pole.
            Caution: Although you have an umbrella base, we highly 
            recommend you remove your umbrella from its base and the            table when not in use.  Even when closed, strong winds could            open the umbrella and damage the umbrella or the table.