Home > Agio International > Accessories > Agio International Coleman Stainless Steel Outdoor Workbench User Manual

Agio International Coleman Stainless Steel Outdoor Workbench User Manual

Add to Favourites
    Download as PDF

    View the Agio International Coleman Stainless Steel Outdoor Workbench User Manual for free. All the Agio International manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 QTYDESCRIPTIONORDER PART #QTYDESCRIPTIONORDER PART #QTYDESCRIPTIONORDER PART #M10 X 55MM BOLT3M6 X 50MM BOLT6M6 X 16MM BOLT16M6 NUT126MM WASHER610MM WASHER512MM WASHER4 10MM END CLIP2 12MM END CLIP410MM PVC COVER212MM PVC COVER2 M6 PVC NUT COVER4LARGE WHEEL2WHEEL COVER4AXLE SLEEVE3RIGHT SUPPORT FRAME1LEFT SUPPORT FRAME1CUSHION HANDLE GRIP1CASTERS2FRONT SUPPORT BAR1REAR SUPPORT BAR1MIDDLE SUPPORT FRAME1FRONT PANEL1COILED SHELF1DRAIN PLUG1DOWEL RODS3REAR FAUCET PANEL1FOLDING COUNTER1AXLE FOR FOLDING...
    Page 2 STEP 4 FRAME ASSEMBLY Connect right side support frame (Q) and left side support frame (R) using the rear support bar (V). Be sure that the hole in the center of the rear support bar is facing up. Add a 10mm washer (F) to a M10 x 55 mm bolt (A) and insert through the left side frame support(r) into the fixed nuts in the rear support bar (V) as shown in figure 3. Repeat for opposite side. (Q). Attach front support bar to middle support frame as shown in figure 3 using a M6 x 16mm bolt. Tighten with...
    Page 3 STEP 6 SINK ASSEMBLY (continued) Position the sink top assembly (Z) over the left side, right side and middle support frames, making sure the holes for the bolts are properly aligned. Once in proper position, use M6 x 16mm bolts (C) to attach sink top/basin assembly to the left support frame. Insert bolts through holes in sink top into the fixed nuts in the left side support frame. Repeat procedure for right side support frame. Insert M6 x 50mm bolts (B) through the holes in the middle portion of...
    Page 4 STEP 8 FINAL TOUCHES Drawer assembly. Tilt the front end of drawer up and slide into track. Make sure track and drawer runners are properly aligned. Slide the two bottom trays (GG) into frame as shown in figure 8. At this time, make sure all nuts and bolts are tightened completely using wrench and hex key wrench. Do not over tighten. Add 12mm PVC cover (K) to each end of wheel axle and 10mm PVC cover (J) to each end of the folding shelf axle as shown in figure 8. LIMITED WARRANTY This...
    Start reading Agio International Coleman Stainless Steel Outdoor Workbench User Manual

    Related Manuals for Agio International Coleman Stainless Steel Outdoor Workbench User Manual

    All Agio International manuals