AEM Water Temp Sensor Kit 302012 User Manual

							 
 
 
 
AEM Performance Electronics 
2205 126th Street Unit A, Hawthorne, CA. 90250 
Phone: (310) 484-2322 Fax: (310) 484-0152 
http://www.aemelectronics.com 
Instruction Part Number: 10-2012 Rev 01 
© 2011 AEM Performance Electronics 
 
Part Number 30-2012 
Fluid Temperature Sensor 
Kit Contents: 
1 x Fluid Temp Sensor 
1 x Mating Connector 
1 x Connector Lock 
3 x Terminal 
 
 
Specs: 
Thread Size 1/8”NPT 
Hex Size ½” 
Typical Voltage Supply 5 Vdc 
Operating Temperature 
  Sensor Tip -40C to 200C 
  Connector -40C to 150C 
Typical Pullup Resistor 2K2 Ohms 
Wire Size 22AWG TXL 
 
Pinout: 
One wire to sensor ground 
One wire to sensor signal 
Polarity does not matter 
 
Crimper: 
Delphi 12039500 or equivalent 
 
Wire Strip Length: 
0.175” to 0.200” 
5.60 DIA
11 . 64
50 . 6
14 . 00
16 . 64 
						

							Page 2 
  
 
 
 
Temp Temp  Res Voltage 2.2K 
pullup  Temp  Temp  Res Voltage 2.2K 
pullup 
degC degF Ohms  Volts   degC degF Ohms  Volts 
-40 -40 402K  4.97   60 140 2.7K  2.74 
-35 -31 289K  4.96   65 149 2.2K  2.52 
-30 -22 210K  4.95   70 158 1.9K  2.30 
-25 -13 154K  4.93   75 167 1.5K  2.09 
-20 -4 114K  4.91   80 176 1.3K  1.88 
-15 5 85.0K  4.87   85 185 1.1K  1.70 
-10 14 64.3K  4.83   90 194 965  1.52 
-5 23 48.9K  4.78   95 203 826  1.37 
0  32 37.5K  4.72   100 212 710  1.22 
5  41 29.0K  4.65   105 221 613  1.09 
10  50 22.5K  4.56   110 230 531  0.97 
15  59 17.7K  4.45   115 239 462  0.87 
20  68 14.0K  4.32   120 248 403  0.77 
25  77 11.1K  4.18   125 257 352  0.69 
30  86  8.9K  4.01   130 266 309  0.62 
35  95  7.2K  3.83   135 275 272  0.55 
40  104 5.8K  3.63   140 284 241  0.49 
45  113 4.7K  3.42   145 293 213  0.44 
50  122 3.9K  3.20   150 302 189  0.40 
55 131 3.2K  2.97       
 
 
 
12 MONTH LIMITED WARRANTY 
 
Advanced Engine Management Inc. warrants to the consumer that all AEM High Performance products will be free from defects in 
material and workmanship for a period of twelve (12) months from date of the original purchase. Products that fail within this 12-
month warranty period will be repaired or replaced at AEM’s option, when determined by AEM that the product failed due to defects 
in material or workmanship. This warranty is limited to the repair or replacement of the AEM part. In no event shall this warranty 
exceed the original purchase price of the AEM part nor shall AEM be responsible for special, incidental or consequential damages 
or cost incurred due to the failure of this product.  Warranty claims to AEM must be transportation prepaid and accompanied with 
dated proof of purchase. This warranty applies only to the original purchaser of product and is non-transferable. All implied 
warranties shall be limited in duration to the said 12 month warranty period. Improper use or installation, accident, abuse, 
unauthorized repairs or alterations voids this warranty. AEM disclaims any liability for consequential damages due to breach of any 
written or implied warranty on all products manufactured by AEM. Warranty returns will only be accepted by AEM when 
accompanied by a valid Return Goods Authorization (RGA) number.  Product must be received by AEM within 30 days of the date 
the RGA is issued. 
 
Please note that before AEM can issue an RGA for any product, it is first necessary for the installer or end user to contact the AEM 
Performance Electronics tech line at 1-800-423-0046 to discuss the problem.  Most issues can be resolved over the phone.  Under 
no circumstances should a system be returned or a RGA requested before the above process transpires. 
 
Table 1.  Temperature Calibration 
Figure 1.  Insert Terminals and Lock