AEM Series 2 Plug Play EMS 306600 User Manual

							
 
 
30-1600 (Series 1) vs 30-6600 (Series 2) EMS differences: 
The EMS functions assigned to certai n pins have been changed and no longer 
match the 30-1600 EMS. Unle ss otherwise noted, the following pins and functions 
will need to be manually reconfigured after  using AEMTuner to convert a V1.19 30-
1600, Series 1 EMS calibration for use with the 30-6600 Series 2 hardwar\
e. 
 
Pin  Vehicle harness 
destination 30-1600 function 30-6600 function Notes 
12 CAN Low Side 8 CAN1H LS8 not available 
15 TX Data Injector 8 EGT 2 Injector 8 moved to pin 114 
42 CAN Switch 1 CAN1L Switch 1 not available 
114 --- EGT 2 Injector 8 EGT 2 moved to pin 15 
Page 11 of 12  
						

							
AEM Electronics Warranty 
  
Advanced Engine Management Inc. warrants to the consumer that all AEM Electronics 
products will be free from defects in material  and workmanship for a period of twelve 
months from date of the original purchase. Products that fail within this 12-month warranty 
period will be repaired or repl aced when determined by AEM that the product failed due to 
defects in material or workmanship. This warr anty is limited to the repair or replacement of 
the AEM part. In no event shall this warranty  exceed the original purchase price of the 
AEM part nor shall AEM be responsible for s pecial, incidental or consequential damages 
or cost incurred due to the failure of this  product. Warranty claims to AEM must be 
transportation prepaid and accompanied with dat ed proof of purchase. This warranty 
applies only to the original  purchaser of product and is  non-transferable. All implied 
warranties shall be limited in duration to t he said 12-month warranty period. Improper use 
or installation, accident, abuse, unauthorized r epairs or alterations voids this warranty. 
AEM disclaims any liability for consequential damages due to breach of any written or 
implied warranty on all produc ts manufactured by AEM. Warranty returns will only be 
accepted by AEM when accompanied by a valid Return Merchandise Authoriza\
tion (RMA) 
number.  Product must be received by AEM withi n 30 days of the date the RMA is issued. 
  
Please note that before AEM can issue an RMA for any electronic product, it is first 
necessary for the installer or end user to contact the tech line at 1-800-423-0046 to 
discuss the problem.  Most issues c an be resolved over the phone.  Under no 
circumstances should a system be returned or  a RMA requested before the above process 
transpires. 
  
AEM will not be responsible for electronic products  that are installed incorrectly, installed 
in a non approved application, mi sused, or tampered with.  
  
Any AEM electronics product can be returned for repair if it is out of the warranty period. 
There is a minimum charge of $75.00 for in spection and diagnosis of AEM electronic 
parts. Parts used in the repair of AEM el ectronic components will be extra. AEM will 
provide an estimate of repairs and receive wri tten or electronic authorization before repairs 
are made to the product.  
 
 
Page 12 of 12