AEM Series 2 Plug Play EMS 306320 User Manual

							Page 11 of 13 
Connection Diagram for EMS P/N 306320 
PnP Means the Plug and Play system comes with this conf
igured for proper operation of this 
device. Is still available for reassignment by the  end user. 
Avail  Means the function is not currently allocated  and is available for use 
Dedicated  Means the location is fixed and cant be changed 
 
Pin  2006 Mitsubishi Lancer EVO IX AEM EMS 30-6320 I/O Notes 
71 Front Heated Oxygen Sensor  O2 #1 
Input PnP for Primary O2 Sensor 
72   EGT #2 
Input Available 05V Analog Input 
73 Rear Heated Oxygen Sensor  O2 #2 
Input PnP for Secondary O2 Sensor 
74   EGT #3 
Input Available 05V Analog Input 
75 Power Ground (European EVO Only)  Power Ground 
Input Dedicated 
76  
Coil #4 
Output Available Switched Gnd, 1.5A Max 
77   
 
   
78  Throttle Position Sensor  TPS 
Input PnP for Throttle Position 
79 Idle Position Signal  ADCR13 
Input Available 05V Analog Input 
80 Vehicle Speed Sensor  Switch #2 
Input PnP for Vehicle Speed 
81   Injector #12 
Output Available Switched Gnd, 1.5A Max 
82  
 
   
83  A/C Switch  Switch #6 
Input PnP for A/C Switch 
84   High Side Driver 
#2  Output Available Switched 12V, 1.5A Max 
85  Data Link Connector  PCRX 
Input Available Serial Connection 
86   High Side Driver 
#3  Output Available Switched 12V, 1.5A Max 
87    High Side Driver 
#4  Output Available Switched 12V, 1.5A Max 
88  Cluch Pedal Position Switch (US EVO Only)  Switch #4
 
Input Available Switched Input 
89   
 
   
90 Intercooler Water Spray Combination Meter (European
 
EVO Only)  Coil #3 
Output Available Switched Gnd, 1.5A Max 
91  Knock Sensor  Knock #1 
Input PnP for Knock Detection 
92 Manifold Absolute Pressure Sensor  MAP 
Input PnP for Manifold Pressure 
93 Fuel Tank Differential Pressure Sensor  ADCR11 
Input Available 05V Analog Input 
94   PCGND 
Input Available Serial Connection 
95 Main Fuel Pump and Level Sensor (US EVO Only)  Knock
 #2 
Input Available Knock Detection 
96  Fuel Tank Temperature Sensor  ADCR14 
Input Available 05V Analog Input 
97 Sub Fuel Pump and Level Sensor (US EVO Only)  EGT #4
 
Input Available 05V Analog Input 
98  Engine Immobiliser System   
   
99 Ignition Switch  12V Switched 
Input Dedicated 
100 Data Link Connector  PCTX 
Output Available Serial Connection 
 
 
 
            
						

							Page 12 of 13 
   
 
30-1320 (Series 1) vs 30-6320 (Series 2) EMS differ ences: 
The EMS functions assigned to certain pins have bee n changed and no longer match the 
301320 EMS. Unless otherwise noted, the following  pins and functions will need to be 
manually reconfigured after using AEMTuner to conve rt a V1.19 (301320, Series 1 EMS) 
calibration for use with the 306320 Series 2 hardw are.  
 
Pin  EVO IX harness destination 30-1320 function 30-6320 function Notes 
17    Injector #9i  Injector 11 Inj11 controlled independently of Inj9 
81    Injector #10i  Injector 12 Inj12 controlled independently of Inj10 
13      CAN1H   
33      CAN1L   
  
						

							Page 13 of 13 
 
AEM Electronics Warranty 
  
Advanced Engine Management Inc. warrants to the con sumer that all AEM Electronics 
products will be free from defects in material and  workmanship for a period of twelve 
months from date of the original purchase. Products  that fail within this 12month warranty 
period will be repaired or replaced when determined  by AEM that the product failed due to 
defects in material or workmanship. This warranty i s limited to the repair or replacement of 
the AEM part. In no event shall this warranty excee d the original purchase price of the 
AEM part nor shall AEM be responsible for special,  incidental or consequential damages 
or cost incurred due to the failure of this product . Warranty claims to AEM must be 
transportation prepaid and accompanied with dated p roof of purchase. This warranty 
applies only to the original purchaser of product a nd is nontransferable. All implied 
warranties shall be limited in duration to the said  12month warranty period. Improper use 
or installation, accident, abuse, unauthorized repa irs or alterations voids this warranty. 
AEM disclaims any liability for consequential damag es due to breach of any written or 
implied warranty on all products manufactured by AE M. Warranty returns will only be 
accepted by AEM when accompanied by a valid Return  Merchandise Authorization (RMA) 
number.  Product must be received by AEM within 30  days of the date the RMA is issued. 
   
Please note that before AEM can issue an RMA for an y electronic product, it is first 
necessary for the installer or end user to contact  the tech line at 18004230046 to 
discuss the problem.  Most issues can be resolved o ver the phone.  Under no 
circumstances should a system be returned or a RMA  requested before the above process 
transpires.
 
  
AEM will not be responsible for electronic products  that are installed incorrectly, installed 
in a non approved application, misused, or tampered  with.  
  
Any AEM electronics product can be returned for rep air if it is out of the warranty period. 
There is a minimum charge of $50.00 for inspection  and diagnosis of AEM electronic 
parts. Parts used in the repair of AEM electronic c omponents will be extra. AEM will 
provide an estimate of repairs and receive written  or electronic authorization before repairs 
are made to the product.