Home > AEM > Series 2 Plug & Play EMS > AEM Series 2 Plug Play EMS 306311 User Manual

AEM Series 2 Plug Play EMS 306311 User Manual

Here you can view all the pages of manual AEM Series 2 Plug Play EMS 306311 User Manual. The AEM manuals for Series 2 Plug & Play EMS are available online for free. You can easily download all the documents as PDF.

Page 1

  
   
ADVANCED ENGINE MANAGEMENT INC. 
2205 126
th Street Unit A    Hawthorne, CA. 90250 
Phone: (310) 4842322 Fax: (310) 4840152  http://www.aempower.com 
Instruction Part Number: 106311 Rev.A (Oct 2009) 
  2009 Advanced Engine Management, Inc. 
 
 
Page 1 of 12 
  
  
Installation Instructions for: 
EMS P/N 30-6311 
1991-97 Mitsubishi 3000GT VR4  1991-1997 Dodge Stealth TT 
 
WARNING: 
 ! 
This installation is not for the tuning novice nor  the PC illiterate! 
Use this system with EXTREME caution!...

Page 2

Page 2 of 12 
Thank you for purchasing an AEM Engine Management System.  
  
The AEM Engine Management System (EMS) is the resul t of extensive development on a 
wide variety of cars. Each system is engineered for  the particular application. The AEM 
EMS differs from all others in several ways. The EM S is a stand alone system, which 
completely replaces the factory ECU and features un ique Plug and Play Technology, 
which means that each system is configured especial ly for your make and model of car...

Page 3

Page 3 of 12 
Read and understand these instructions BEFORE attempting to install this product. 
1)  Install AEMTuner software onto your PC   The latest version of the AEMTuner software can be  downloaded from the AEMTuner 
section of the AEM Performance Electronics forums.  Series 2 units are not supported 
by the older AEMPro tuning software.   
  
2)  Remove the Stock Engine Control Unit 
a) Access  the  stock  Engine  Control  Unit  (ECU).  The  loc ation  of  the  ECU  on  the  1G 
DSM vehicles is...

Page 4

Page 4 of 12 
less than 0.2% or greater than 99.8%, this is considered a sensor error and may 
cause some functions including idle feedback and ac celeration fuel to operate 
incorrectly.    
4)  Ready to begin tuning the vehicle. 
a) Before  starting  the  engine,  verify  that  the  fuel  pu mp  runs  for  a  couple  of  seconds 
when the key is turned on and there is sufficient p ressure at the fuel rail.  
If  a  MAP  sensor  is  installed,  check  that  the  Engine   Load  indicates  something  near...

Page 5

Page 5 of 12 
Application Notes for EMS P/N 306311 
19911997 3000GT VR4 / Stealth TT 
Make:  Mitsubishi/Dodge    Spare Injector Drivers:  Inj 7, Pin 116 
Model:  3000GT VR4 / Stealth TT    Spare Injector Drivers:  Inj 8, Pin 6 
Years Covered:  1991 – 1997    Spare Injector Drivers:   Inj 9, Pin 83 
Engine Displacement:  3.0L    Spare Injector Drivers:  Inj 10, Pin 105 
Engine Configuration:  V6    Spare Injector Drivers:  I nj 11, Pin 89 
Firing Order:  123456    Spare Injector Drivers: Inj 12,...

Page 6

Page 6 of 12 
 
WARNING:      
*  The  factory  A/C  request  switch  sends  12V  power  to   signal  an  A/C  request  and  the  30
6311 EMS has been designed to accept 12V power on t his switched input. If users desire 
to  rewire  a  new  switch  to  trigger  the  Switch  2  inp ut  the  switch  should  connect  to  12V 
power when the switch is on. The pin can be left fl oating (disconnected) when the switch is 
off, it is not required to send ground to this pin.    
  
**All  other  switch  input...

Page 7

Page 7 of 12 
  
Peak and Hold Injector Drivers
 
Injectors  16  include  Peak  (4  amps)  and  Hold  (1  amp )  injector  drivers.  These  drivers  may 
be  used  with  peak  and  hold  or  saturated  type  inject ors.  The  factory  Mitsubishi  wiring 
harness  contains  a  resistor  pack  to  prevent  excessi ve  current  when  using  lowimpedance 
injectors  with  the  stock  ECU.  With  the  306311  inst alled,  users  can  elect  to  remove  and 
bypass the OEM resistor pack for more precise...

Page 8

Page 8 of 12 
Connection Diagram for EMS P/N 306311 199197 Mitsubishi 3000GT VR4, Dodge Stealth TT 
PnP  Means the Plug and Play system comes with this  configured for proper operation of this device. Is still available for reassignment by the end user. 
Avail  Means the function is not currently allocated  and is available for use 
Dedicated  Means the location is fixed and cant be c hanged 
91-93 94-97            
Pin  Pin  91-93 3000 GT 94-97 3000 GT AEM EMS 30-6311 I/O 91-93 Notes 94-97 Notes 
1  1...

Page 9

Page 9 of 12 
 
91-93 94-97 91-93 3000 GT 94-97 3000 GT AEM EMS 30-6311 I/O 91-93 Notes 94-97 Notes 
101  31 
Ignition OK input  Fuel Pump Relay (Low)  Not Used        
102  32 
Active Exhaust*  Wastegate Solenoid*  PW 2  Output PnP for Wastegate Control Solenoid 

Page 10

Page 10 of 12 
 
91-93 94-97 91-93 3000 GT 94-97 3000 GT AEM EMS 30-6311 I/O 91-93 Notes 94-97 Notes 
51  71 
Starter Signal  
Start reading AEM Series 2 Plug Play EMS 306311 User Manual

Related Manuals for AEM Series 2 Plug Play EMS 306311 User Manual

All AEM manuals