AEM Series 2 Plug Play EMS 306310 User Manual

							Page 11 of 15 
Connection Diagram for EMS P/N 306310 
PnP Means the Plug and Play system comes with this conf
igured for proper operation of this 
device. Is still available for reassignment by the  end user. 
Avail  Means the function is not currently allocated  and is available for use 
Dedicated  Means the location is fixed and cant be changed 
 
Pin  95 - 99 Eclipse Turbo / Talon Tsi 2003-2005 Evo VIII AEM EMS 30-6310 I/O 95 - 99 Eclipse/Talon Notes 2003-2005 Evo VIII Notes 
31 
  
						

							Page 12 of 15 
Connection Diagram for EMS P/N 306310 
PnP Means the Plug and Play system comes with this conf
igured for proper operation of this 
device. Is still available for reassignment by the  end user. 
Avail  Means the function is not currently allocated  and is available for use 
Dedicated  Means the location is fixed and cant be changed 
 
Pin  95 - 99 Eclipse Turbo / Talon Tsi 2003-2005 Evo VIII AEM EMS 30-6310 I/O 95 - 99 Eclipse/Talon Notes 2003-2005 Evo VIII Notes 
51 
  Immobilizer System  Low Side 3  Output Avail, Switched Ground driver 
						

							Page 13 of 15 
Connection Diagram for EMS P/N 306310 
PnP Means the Plug and Play system comes with this conf
igured for proper operation of this 
device. Is still available for reassignment by the  end user. 
Avail  Means the function is not currently allocated  and is available for use 
Dedicated  Means the location is fixed and cant be changed 
 
Pin  95 - 99 Eclipse Turbo / Talon Tsi 2003-2005 Evo VIII AEM EMS 30-6310 I/O 95 - 99 Eclipse/Talon Notes 2003-2005 Evo VIII Notes 
71 
Starter Signal  
						

							Page 14 of 15 
   
30-1310 (Series 1) vs 30-6310 (Series 2 EMS differe
nces: 
The EMS functions assigned to certain pins have bee n changed and no longer match the 
301310 EMS. Unless otherwise noted, the following  pins and functions will need to be 
manually reconfigured after using AEMTuner to conve rt a V1.19 (301310, Series 1 EMS) 
calibration for use with the 306310 Series 2 hardw are.  
 
Pin  
95-99 Eclipse 
Turbo / Talon Tsi 2003-2005 Evo VIII 
30-1310 
function 
30-6310 
function Notes 
7      Switch 4  N/C 
Pin has no internal 
connection, Switch 4 
available on pin 43 
32    Condenser Fan 
control (HI)  PW 2  Idle 5 
301313 used Idle5  also
  
34  Timing Adj. / LF 
O2 heater     Injector #10  Injector 12 Inj10 available on pin 35 
38  MFI Relay control  MFI Relay control  Coil 5  Coil  7 Use Coil 7 settings from 
6310 startup calibration 
43  Clutch Pedal Sw  HS4  Switch 4 HS4 not available 
44       EGT 2  Switch 6 EGT 2 available on pin   61 
52       PW #1i  Coil 3 connects to pin 11 
53       Switch 6  Coil 5 Switch 6 available on 
pin 44  
56       High Side #3  Coil 6  HS3 not available 
57    H2O spray relay  HS1  Idle 7 301313 used Idle7 also 
60  O2 Heater Front  O2 Heater Front  Injector #9  Inje ctor 11 Inj 9 available on pin 83 
(54) 
61 Fuel Tank Diff. 
Press. sensor  Fuel Tank Diff. 
Press. sensor  ADCR11  EGT 2  ADCR11 not available 
62  Data Link 
Connector  Data Link 
Connector   FM  Coil 4  
77    Fuel Temperature  Knock #2  CAN1L Knock #2 not available 
87  Throttle Position 
switch  Throttle Position 
Switch  ADCR14  CAN1H ADCR14 not available  
						

							Page 15 of 15 
 
AEM Electronics Warranty 
  
Advanced Engine Management Inc. warrants to the con sumer that all AEM Electronics 
products will be free from defects in material and  workmanship for a period of twelve 
months from date of the original purchase. Products  that fail within this 12month warranty 
period will be repaired or replaced when determined  by AEM that the product failed due to 
defects in material or workmanship. This warranty i s limited to the repair or replacement of 
the AEM part. In no event shall this warranty excee d the original purchase price of the 
AEM part nor shall AEM be responsible for special,  incidental or consequential damages 
or cost incurred due to the failure of this product . Warranty claims to AEM must be 
transportation prepaid and accompanied with dated p roof of purchase. This warranty 
applies only to the original purchaser of product a nd is nontransferable. All implied 
warranties shall be limited in duration to the said  12month warranty period. Improper use 
or installation, accident, abuse, unauthorized repa irs or alterations voids this warranty. 
AEM disclaims any liability for consequential damag es due to breach of any written or 
implied warranty on all products manufactured by AE M. Warranty returns will only be 
accepted by AEM when accompanied by a valid Return  Merchandise Authorization (RMA) 
number.  Product must be received by AEM within 30  days of the date the RMA is issued. 
   
Please note that before AEM can issue an RMA for an y electronic product, it is first 
necessary for the installer or end user to contact  the tech line at 18004230046 to 
discuss the problem.  Most issues can be resolved o ver the phone.  Under no 
circumstances should a system be returned or a RMA  requested before the above process 
transpires.
 
  
AEM will not be responsible for electronic products  that are installed incorrectly, installed 
in a non approved application, misused, or tampered  with.  
  
Any AEM electronics product can be returned for rep air if it is out of the warranty period. 
There is a minimum charge of $75.00 for inspection  and diagnosis of AEM electronic 
parts. Parts used in the repair of AEM electronic c omponents will be extra. AEM will 
provide an estimate of repairs and receive written  or electronic authorization before repairs 
are made to the product.