Home > AEM > K-Type Thermocouple Amplifier 4 Channels > AEM KType Thermocouple Amplifier 4 Channel 302204 User Manual

AEM KType Thermocouple Amplifier 4 Channel 302204 User Manual

Add to Favourites
    Download as PDF

    View the AEM KType Thermocouple Amplifier 4 Channel 302204 User Manual for free. All the AEM manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 ADVANCED ENGINE MANAGEMENT INC. 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aempower.com Instruction Part Number: 10-2204 Rev 0 © 2005 Advanced Engine Management, Inc. Page 1 Installation Instructions for: 30-2204 4 Channel Thermocouple Amplifier WARNING: This installation is not fo the electrically or mechanically challenged! Use th th EXTREMEr is sensor wi ,! caution! If you are t uncomfortable with anything...
    Page 2 The Advanced Engine Management (AEM) 4 channel thermocouple amplifier revolutionizes temperature measurements by providing labora tory grade accuracy for your temperature measurements. The accuracy is guaranteed to be be tter than 1% full scale, even at the extremes of the temperature range. It is designed either for integration into vehicles already fitted with aftermarket ECU’s or other devices that can accept an analog signal for either analysis or logging. Alternately, an RS-232 output is...
    Page 3 voltage given by a thermocouple with a multi-meter. This is because the thermocouple acts as a differential device between the junctions and the connection of a multi-meter creates a junction at that point as well. The voltage supplied is for the difference of the temperature at the two different ends of the thermocouple so the output voltage will be for the temperature difference between the two points, not the absolute temp erature at the measurement tip. This makes knowing the temperature at the...
    Page 4 SERIAL OUTPUT The serial output can be used for data logging when an EFI system is not accessible. To run the data stream, a RS-232 (DB-9) Fema le Receptacle must be purchased. 12345 6789 Wire View of RS-232 (DB-9) Male Plug Two wires need to be connected to a RS- 232 serial port. The YELLOW wire from the AEM thermocouple amplifier shall be connected to Pin #2 (RX) on the serial port for receiving data. Pin # 5 (GND) on the serial port is the ground and should be conne cted to the...
    Start reading AEM KType Thermocouple Amplifier 4 Channel 302204 User Manual
    All AEM manuals