AEM Engine Position Module 303251 User Manual
Have a look at the manual AEM Engine Position Module 303251 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 223 AEM manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
ADVANCED ENGINE MANAGEMENT INC. 2205 126 th Street Unit A Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 Http://www.aempower.com Instruction Part Number: 10-3252 © 2007 Advanced Engine Management, Inc. Page 1 of 2 Installation Instructions for: EPM for V8 Engines WARNING: ,! This installation is not for the t uning novice nor the PC illiterate! Use this system with EXTREME caution! Misuse of this product can destroy your engine! If y ou are not well versed in engine dynamics and the tuning of management systems or are not PC literate, please do not attempt the installation. Refer the installation to a AEM trained tuning shop or call 800-423-0046 for technical assistance. You shoul d also visit the AEM Tech Forum at http://www.aempower.com NOTE: AEM holds no responsibility for any engine damage that results from the misuse of this product! This product is legal in California for racing vehicles only and should never be used on public highways.
The AEM Engine Position Sensor (EPM) replaces the stock V8 distributor and allows the use of a coil on plug or wasted spark ignition system and can be used with any aftermarket engine management system that recognizes the common 24 – 1 input for crank and cam signal. The EPM provides precise engine position using dual zero speed optical sensors. This offers the adv antage of immediate signal generation when the engine is cranked. Read and understand these instructions BEFORE attempting to install this product. The EPM is outfitted from AEM with a “steel” distributor gear. If your cam requires the use of a “bronze” gear please call AEM for further details. If you are not sure which gear you need please double check with your cam manufacture first to verify the type of gear needed for your cam. 1) Remove the Stock Distribut or and install the AEM EPM. You can rotate the EPM so that the cable routing is optimized for y our application, timing will be set with the EMS software. 2) EPM Wiring a) The EPM has a short cable with a 4 pi n connector, supplied with the EPM is the mating connector housing with 5 crimp terminals. The connector pinouts are shown in figure 1. Figure 1. b) The EPM puts out a 12V square wave, 24 crank signals and 1 short pulse cam signal every 360 distribut or degrees, see figure 2. Page 2 of 3