AEG Vented dryer T65170AV User Manual

INSTALLATION
APPLIANCE POSITIONING
• The tumble dryer must be installed in
a clean position, where dirt does not
collect.
• Air must flow freely around the appli-
ance. Make sure that the front airflow
slots in the bottom of the appliance
are not blocked .
• To keep vibration and noise at the
minimum, when the tumble dryer op-
erates, it must be put on a stable and
flat surface.
• When the appliance is put in its per-
manent position, check if is fully level
with the aid of a spirit level. If it is
not,...

THE VENT HOSE
INSTALLATION
There are 3 vent outlets: on the
left, right side and at the rear.
1.Pull the ring nut A from the vent
outlet at the rear.
2.Screw on the ring nut to the hose
and push it into position.
3.The not used vents must be sealed
with supplied covers.
If the hose is long and the room
temperature low, the moisture
might condense to water inside
the hose. This is an usual occur-
rence. To prevent this water
from the hose, it is recommend
to drill a small hole (via. 3 mm) in
the lowest...

that the steam exhaust is unobstructed.
Thus, if a permanent hose installed to
an external wall or ceiling, it must be
ensured an exhaust capacity of mini-
mum 150 m3/h. If the dryer is installed
adjacent to kitchen units, make sure
that the vent hose is not squashed. If
the hose is not fully squashed, drying
efficiency will be decreased , resulting
in longer drying times and higher ener-
gy consumption. If the hose is fully
squashed, the automatic cut-outs with
which the appliance is fitted can oper-...

5.Unscrew hinge A from the load
door and turn it through 180°, then
put on the opposite side and screw
down.
6.Turn cover plates B through 180°
and put them on the opposite side.
7.Unscrew cover plates D from the
front of the appliance, turn through
180° and screw down on the oppo-
site side.
E
E
D D
F F
8.Unscrew door lock E, push down
lightly and remove from the front of
the appliance.
9.Push snap-in button F in and down,
push cover down lightly and re-
move from front of the appliance.
10.Change door...

A
B
C
D
A)green and yellow - ground — earth
(E)
B)brown - live (L)
C)cord clamp
D)blue - neutral (N)
The green and yellow coloured wire
must be connected to the terminal with
E mark or the ground 
 mark or the
green and yellow coloured terminal.
The blue coloured wire must be con-
nected to the terminal N or black col-
oured .The brown coloured wire must be con-
nected to the terminal L or red col-
oured .
The wires of the cable must be no cut
or stray strands of wire present and the
cable clamp must be...

26 

ENGLISH 27 

www.aeg.com/shop136915230-A-232011