AEG U3100-5-m Manual

31 
INSTALLATION INSTRUCTIONS 
 
WARNINGS  
• This appliance must be installed by a 
qualified electrician/competent person. Safety 
may be impaired if installation is not carried 
out in accordance with these instructions. 
• This appliance must be earthed. 
• Do not remove the screws from the earth tab 
extending from the oven mains terminal block 
(Fig. 1). 
• Before connecting the appliance make sure 
that the voltage of your electricity supply is 
the same as that indicated on the rating plate....

 
32  THINGS TO NOTE 
• This appliance is designed to be fitted between 
cabinets with the recommended dimensions as 
shown in Fig. 3 & 4. 
• If there is an existing housing unit it must be 
removed. 
• The dimensions given provide adequate air 
circulation around the unit within the cabinet, 
ensuring compliance with BS EN60-335. 
• This appliance must not be installed on a wooden 
base board. 
• Enquiries regarding the installation of the cooker 
point, if required, should be made to your 
Regional...

33  HOW TO FINISH UNPACKING 
• Place packed appliance next to the space in 
which it will be installed.   
• Remove the appliance packing except for bottom 
tray which should be left in position until the 
appliance is ready to be fitted into its cabinet. 
 
NOTE:  It is imperative that the appliance is left in 
the base to protect both the appliance and the 
floor. 
• Ensure the owner is given these operating 
instructions. 
 
 
 
Important:  Switch off at mains, miniature 
circuit breaker and, if...

 
34  CONNECTING TO THE MAINS TERMINAL 
 
 
Warning:  This appliance must be earthed. 
 
• We recommend you use a new length of 6mm2 
twin core and earthed cable to ensure your 
safety. 
• Make connection as shown in Fig.11 by 
proceeding as follows:- 
• Preform wires to the appropriate shape to suit 
fitting into the mains terminal block. 
• Strip inner insulation on wires using 
wirestrippers. 
• Twist the bared wires using pliers. 
• Cut bared wires 10mm away from the end of the 
inner insulation....

35  FITTING INTO THE SPACE BETWEEN 
CABINETS 
 
 
IMPORTANT:  Ensure that the oven is 
switched off at the wall before any further 
work is carried out. 
 
• Position the appliance in front of the cabinet.  
See Fig. 12. 
• Take out all oven furniture before installation to 
reduce the weight you need to lift.  The oven 
door should be taped up to keep it closed. 
• To place the appliance into the space between 
cabinetry follow the procedure below: 
• N.B.  Two people will be required to carry out 
the...

 
 
IMPORTANT NOTICE 
 
 
 
In line with our continuing policy of research and development, we reserve the right to alter models and 
specifications without prior notice. 
 
 
 
This instruction  booklet is accurate at the date of  printing, but will be superseded if  specifications or appearance are 
changed. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
AEG-ELECTROLUX 
MAJOR APPLIANCES,  ADDINGTON WAY, 
LUTON, 
BEDFORDSHIRE  LU4 9QQ. 
TELEPHONE 0870 5 350350 
To buy accessories, consumables and...