AEG Sn 81840 5i User Manual

Hints for refrigeration
Useful hints:
Meat (all types) : wrap in polythene bags and place on the glass shelf above the vegetable
drawer.
For safety, store in this way only one or two days at the most.
Cooked foods, cold dishes, etc..: these should be covered and may be placed on any shelf.
Fruit and vegetables: these should be thoroughly cleaned and placed in the special draw-
er(s) provided.
Butter and cheese: these should be placed in special airtight containers or wrapped in alu-
minium foil or...

This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must
therefore only be carried out by authorized technicians.
Periodic cleaning
The equipment has to be cleaned regularly:
• clean the inside and accessories with lukewarm water and some neutral soap.
• regularly check the door seals and wipe clean to ensure they are clean and free from
debris.
• rinse and dry thoroughly.
Do not pull, move or damage any pipes and/or cables inside the cabinet.
Never use detergents,...

Defrosting of the freezer
The freezer compartment of this model, on the other hand, is a no frost type. This means
that there is no buildup of frost when it is in operation, neither on the internal walls nor on
the foods.
The absence of frost is due to the continuous circulation of cold air inside the compart-
ment, driven by an automatically controlled fan.
Periods of non-operation
When the appliance is not in use for long periods, take the following precautions:
•disconnect the appliance from...

ProblemPossible causeSolution
 The product temperature is too
high.Let the product temperature de-
crease to room temperature be-
fore storage.
 The room temperature is too
high.Decrease the room temperature.
Water flows on the rear
plate of the refrigerator.During the automatic defrosting
process, frost defrosts on the
rear plate.This is correct.
Water flows into the re-
frigerator.The water outlet is clogged.Clean the water outlet.
 Products prevent that water
flows into the water collector.Make sure...

6. Open the door. Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to Installation.
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
   
Dimension of the recess  
 Height1780 mm
 Width560 mm
 Depth550 mm
Rising Time 21 h
Voltage 230-240 V
Frequency 50 Hz
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label....

The manufacturer declines all responsibility if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Directives.
Door reversibility
The door of the appliance opens to the right. If you want to open the door to the left, do
these steps before you install the appliance:
1. Loosen the upper pin and remove the
spacer.
2. Remove the upper pin and the upper
door.
3. Unscrew the pins (B) and spacers (C).
4. Remove the lower door.
5. Loosen the lower pin.
On the opposite...

Ventilation requirements
The airflow behind the appliance must be suffi-
cient.
Installing the appliance
CAUTION!
Make sure that the mains cable can move freely.
Do these steps.
1. If necessary cut the adhesive sealing
strip and then apply it to the appliance
as shown in figure.
2. Drill the hinge cover A, as shown in fig-
ure.
Apply the covers A and A1 (in the acces-
sories bag) in to the middle hinge.
50 mmmin.
200 cm2
min.
200 cm2
x
x
A1 A
Installation57
 

3. Install the appliance in the niche.
Push the appliance in the direction of
the arrow (1) until the upper gap cover
stops against the kitchen furniture.
Push the appliance in the direction of
the arrow (2) against the cupboard on
the opposite side of the hinge.
4. Adjust the appliance in the niche.
Make sure that the distance between
the appliance and the cupboard front-
edge is 44 mm.
The lower hinge cover (in the accessories
bag) makes sure that the distance be-
tween the appliance and the kitchen...

6. Remove the correct part from the hinge
cover (E). Make sure to remove the part
DX, in the case of right hinge, SX in op-
posite case.
7. Attach the covers (C, D) to the lugs and
the hinge holes.
Install the vent grille (B).
Attach the hinge covers (E) to the hinge.
8. If the appliance must connect laterally
to the kitchen furniture door:
a) Slacken the screws in fixing brackets
(H).
b) Move the brackets (H).
c) Retighten the screws.
BE
E
DC
HH
Installation59
 

9. Disconnect the parts (Ha), (Hb), (Hc) and
(Hd)
10. Install the part (Ha) on the inner side of
the kitchen furniture.
11. Push the part (Hc) on the part (Ha).
ca. 50 mm
ca. 50 mm21 mm 90°       
90°       
21 mm
Ha
Hc
60Installation