AEG Sn 81840 4i Operating And Installation Instructions

							33
Housing dimensions
Height 1780 mm
Depth 550 mm
Width 560 mm
Instructions for total built-in


Apply joint the sealing strip as shown
in figure. site side
5. Unscrew the lower pin and remo-
ve  the  spacer  and  refit  them  on
the opposite side




Fit the appliance in the niche by
making sure that it stands against
the interior surface of the unit on
the side where the door hinges of
the appliances are fitted. Insert the
appliance until the upper strip butts
up against the unit (1) and make
sure that the lower hinge is in line
with the surface of the unit (2).
40Interior AccessoriesStorage Shelves
The  glass  shelf  above  the  fruit  and
vegetable  compartment  should
always  remain  in  position,  to  ensure
fruit  and  vegetables  stay  fresh  lon-
ger.
The remaining storage shelves can be
adjusted to various heights:
Pull the storage shelf forward until it
can be tipped up or down and remo-
ved.
To insert at a different height use the same procedure in reverse.
Adjustment for tall goods:
Remove the front half of the two-part vario glass storage shelf and insert it
at  a  different  level.  Space  is  thus  gained  for  storage  of  tall  goods  on  the
underlying storage shelf.
Variable Inner Door
The  door  compartments  can  be  pulled  up  and  removed,  and  inserted  at
other positions as needed.




 
						

							34

Fasten  the  appliance  with  4  screws
provided in the kit included with the
appliance.  (I = short) (P = long)
 


Apply covers (C-D) on joint cover lugs
and into hinge holes.
Snap  vent  grille  (B)  and  hinge  cover
(E) into position.Separate  parts  Ha,  Hb,  Hc,  Hd  as
shown in the figure

	
		
	
39
Quick-freezing
For quick-freezing, push the Normal/Super button (D). The super
control light (C) will then light up.
The Quick-freezing  function accelerates the freezing of fresh food
and, at the same time, protects foodstuffs already stored from
undesirable warming.
If this function is not ended manually, the appliance switches off
the Quick-freezing function after 52 hours. The yellow light goes
out.
This function can be ended manually at any time by pressing the
Normal/Super button again. The yellow light goes out.
Starting  up  and  temperature  regulation  of
freezer compartment
• Turn the temperature regulator (B) in the direction of “1”. The green(A)
comes on. The freezer motor starts up.
• Psuh the 
Normal/Super push button
(D), the yellow light  (B) comes on; 
Setting “0”:Off.
Setting “1”: Hightest temperature, (warmest setting).
Setting “4” (end-stop) :Lowest temperature, (coldest setting). 
The  exact  setting  should  be  chosen  keeping  in  mind  that  the  temperature
inside the appliance depends on:
- the quantity of food stored
- how often the door is opened
- ambient temperature
Vownlo~JQJzYromz)riJgQäX~nu~lP»omzX~nu~ls 
						

							35
Place guide (Ha) on the inside part of
the  furniture  door,  up  and  down  as
shown  in  the  figure  and  mark  the
position  of  external  holes.  After
having  drilled  holes,  fix  the  guide
with the screws supplied.











	
	

Fix  cover  (Hc)  on  guide  (Ha)  until  it
clips into place.Open the appliance door and the fur-
niture  door  at  90°.  Insert    the  small
square  (Hb)  into  guide  (Ha).    Put
together  the  appliance  door  and  the
furniture door and mark the holes as
indicated in the figure. 

	

	

38
However, the exact setting should be chosen keeping in the mind that the
temperature inside the refrigerator depends on:
-the quantity of food stored
-how often the door is opened
The temperatures in the refrigerator compartment and freezer co partment
cannot be independently regulated.
If  you  want  the  freeze  fresh  food  rapidly,  select  setting  „6“,  ensuring  that
the  temperature  in  the  refrigerator  compartment  does  not  drop  blow  0°C.
You should also promptly reset the temperature regulator to setting „3“ or
„4“.
Important!
High ambient temperatures (e.g. on hot summer days) and a cold setting on
the temperature regulator (position"5" to "6") can cause the compressor to
run continuously.
If  this  happens,  turn  the  temperature  regulator  back  to  a  warmer  setting
(position "3" to "4"). At this setting the compressor will be switched on and
off as usual and automatic defrosting recommenced.
	



 

A. Pilot light (green)
B. Thermostat knob
C. Super control light (yellow) 
D. Normal/Super push buttonControl panel 
The control panel elements are:the thermostat (B)is  also the on/off swit-
ch .
The green pilot light (A),which comes on when the mains voltage is avail-
ble. Switch the temperature regulator knob to a number position, the refri-
gerating  unit  automatically  operates  by  system  control.The  yelloew  pilot
light (C) comes on whenthe normal/super push botton is pushed.
Important note:if you operate the fast-freeze switch or adjust the tempe-
rature  regulator,  it  may  happen  that  your  appliance’s  refrigeration  motor
does  not  start  immediately  but  only  after  some  time.  This  does  not  mean
that your appliance has a fault..
Vownlo~JQJzYromz)riJgQäX~nu~lP»omzX~nu~ls 
						

							36
Remove the brackets and mark a
distance of 8 mm from the outer
edge  of  the  door  where  the  nail
must be fitted (K).

	
	
Fix  cover  (Hd)  on  guide  (Hb)  until  it
clips into place.
40

Place  the  small  square  on  the  guide
again and fix it with the screws sup-
plied.
Should the lining up of the furniture
door  be  necessary,  use  the  clearance
of slots.
At the end of operations, it is neces-
sary  to  check  if  the  door  of  the  fur-
niture closes properly.


37
Prior to Initial Start–Up
• Please clean the appliance interior and all accessories prior to initial start-
up (see section: “Cleaning and Care”).
Electrical connection
Before initial start-up, refer to the appliance rating plate to ascertain if sup-
ply  voltage  and  current  values  correspond  with  those  of  the  mains  at  the
installation location.
e.g.:  AC 220 ... 240 V 50 Hz or
220 ... 240 V~ 50 Hz
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
A correctly installed, earthed socket is required for the electrical supply. The
supply must have a fuse rating of at least 10 Amps.
If  the  socket  is  not  accessible  once  the  appliance  is  built  in,  the  electrical
installation must include suitable means of isolating the appliance from the
mains  (e.g.  fuse,  cut-out,  current  trip  or  similar  with  a  minimum  contact
separation of 3 mm).
Attention:  The  mains  connection  cable  may  only  be  replaced  by  a  skilled
electrician. Please contact your dealer or our customer service department
for repairs.
Starting up and temperature regulation
0 Insert the plug of the connection lead into the plug socket with protecti-
ve  earth  contact.  When  the  refrigerator  compartment  door  is  opened,  the
internal lighting is switched on. The temperature selector knob is located on
the control panel.
Setting „0“ means:Off.
Setting „1“ means: Hightest temperature, (warmest setting).
Setting „6“ (end-stop) means:Lowest temperature, (coldest setting). 








If  the  appliance  is  fixed  to  the
side  of  the  kitchen  unit,  simply
slacken  the  screws  in  the  fixing
brackets (E), move the brackets as
shown in the figure and re-tight-
en the screws.
Vownlo~JQJzYromz)riJgQäX~nu~lP»omzX~nu~ls