AEG Sk 81840 6i User Manual
Here you can view all the pages of manual AEG Sk 81840 6i User Manual. The AEG manuals for Fridge freezer are available online for free. You can easily download all the documents as PDF.
Page 51
Ventilation requirements The airflow behind the appliance must be suffi- cient. Installing the appliance CAUTION! Make sure that the mains cable can move freely. Do the following steps: 1. Apply the adhesive sealing strip to the appliance as shown in figure. 50 mmmin. 200 cm2 min. 200 cm2 Installation51
Page 52
2. Drill the appliance using a Ø 2.5 mm drill (10 mm max. penetration). Fix the square fitting to the appliance . 3. Install the appliance in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the opposite side of the hinge. 4. Adjust the appliance in the niche. Make sure that the distance between the appliance and the cupboard front-edge is 44 mm. The...
Page 53
5. Attach the appliance to the niche with 4 screws. 6. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in op- posite case. 7. Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge. I I BE E DC Installation53
Page 54
8. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). 9. Install the part (Ha) on the inner side of the kitchen furniture. 10. Push the part (Hc) on the part (Ha). Ha Hc 54Installation
Page 55
11. Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Remove the small squares and drill holes with ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. 12. Align the kitchen furniture door and the appliance door by adjusting the part (Hb). 13. Press the part (Hd) on the part (Hb). Do a...
Page 56
Reversibility of the freezer door 180˚ Environmental concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of...
Page 57
Nous vous remercions d’avoir choisi l’un de nos produits de qualité. Afin de garantir une performance optimale et constante de votre appareil, veuillez lire attentivement cette notice dutilisation. Il vous permettra d’utiliser correctement et efficacement toutes les fonctions de l’appareil. Nous vous recommandons de conserver cette notice à proximité pour une utilisation rapide et optimale. Si lappareil devez être vendu ou cédé à une autre personne, assurez-vous que la notice dutilisation laccompagne....
Page 58
servez cette notice avec lappareil. Si lappareil doit être vendu ou cédé à une autre personne, veillez à remettre cette notice au nouveau propriétaire, afin quil puisse se familiariser avec son fonctionnement et sa sécurité. Pour la sécurité des personnes et des biens, conservez et respectez les consignes de sécurité figurant dans cette notice. Le fabricant décline toute responsabilité en cas de dommages dus au non-respect de ces instructions. Sécurité des enfants et des personnes vulnérables • Cet...
Page 59
• Il est dangereux de modifier les caractéristiques de lappareil ou lappareil. Un cordon dalimentation endommagé peut être la cause de courts-circuits, dincendies et/ou de décharges électriques. AVERTISSEMENT Les composants électriques (cordon dalimentation, prise, compresseur) doivent être rem- placés par un technicien dentretien agréé ou par un électricien spécialisé. 1. Ne branchez pas le cordon dalimentation à une rallonge. 2. Assurez-vous que la prise nest pas écrasée ou endommagée par larrière de...
Page 60
• Placez lappareil dos au mur pour éviter tout contact avec le compresseur et le conden- seur (risque de brûlure). • Placez de préférence votre appareil loin dune source de chaleur (chauffage, cuisson ou rayons solaires trop intenses). •Assurez-vous que la prise murale reste accessible après linstallation de lappareil. • Branchez à lalimentation en eau potable uniquement. 11) Maintenance • Les branchements électriques nécessaires à lentretien de lappareil doivent être réalisés par un électricien...