AEG Sk 78800 5i Operating And Installation Instructions

							
21

Changing the light bulb

Warning!
There is a risk of electric shocks! Before changing the light
bulb, switch off the appliance and unplug it, or disconnect from the
power supply.
Light bulb data: 220-240 V, max. 15 W

+
1.
To switch off the appliance, turn the thermostat knob to position 0.

2.
Unplug the mains plug.

3.
To change the light bulb, undo the
screw.

4.
Press the light bulb cover as shown
and slide it backwards.

5.
Change the defective light bulb.

6.
Refit the light bulb cover and the
screw.

7.
Put the refrigerator back into operation.

A
EG65
Noises during Operation
The following noises are characteristic of refrigeration appliances: 
¥
Clicks
Whenever the compressor switches on or off, a click can be heard.
¥
Humming
As soon as the compressor is in operation, you can hear it humming.
¥
Bubbling/Splashing
When refrigerant flows into thin tubes, you can hear bubbling or
splashing noises. Even after the compressor has been switched off,
this noise can be heard for a short time.
 
						

							
22

Regulations, Standards, Guidelines

This appliance was designed for household use and was manufactured
in accordance with the appropriate standards. The necessary measures
in accordance with appliance safety legislation regulations (GSG), acci-
dent prevention regulations for refrigeration appliances (VBG 20) and
the regulations of the German Society of Electrical Engineers (VDE)
were observed in the manufacture of this appliance.
The refrigerant circuit has been checked for leaks.This appliance is in accordance with the following EU
guidelines:
Ð 73/23/EWG dated 19 February 1973 - low voltage guidelines.
Ð 89/336/EWG dated 3 May 1989 (including guideline change notice 92/31/EWG) - EMV guideline
 
						

							
23

Technical terminology

¥
Refrigerant

Liquids that can be used to a generate a cooling effect are known as
refrigerants. They have a relatively low boiling-point, indeed so low,
that the warmth from the food stored in the fridge or freezer can
cause the refrigerant to boil and vaporise.
¥

Refrigerant Circuit

Closed circulation system that contains the refrigerant. The refriger-
ant circuit comprises primarily of an evaporator, a compressor, a con-
denser and pipe work.
¥

Evaporator

The refrigerant is evaporated in the evaporator. Similar to all other
liquids, refrigerant requires heat to evaporate. This heat is removed
from the interior of the appliance, as a result the interior is cooled.
The evaporator is therefore located inside the appliance or placed in
foam immediately behind the inner wall and thus not visible.
¥

Compressor

The compressor looks like a small drum. It is driven by a built-in
electric motor and is mounted on the base of the appliance at the
rear. The task of the compressor is to draw in vaporised refrigerant
from the evaporator, to compress it, and to pass it on to the con-
denser.
¥

Condenser

The condenser normally has the form of a grid. The refrigerant com-
pressed in the compressor is liquefied in the condenser. During this
process, heat is released to the surrounding air at the surface of the
condenser. The condenser is mounted on the base of the appliance.
 
						

							
AEG HausgerŠte GmbH
Postfach 1036
D-90327 NŸrnberg
http://www.aeg.hausgeraete.de
2222 754-54 -00- 082007Subject to change without notice
© Copyright by AEG