AEG S 76322 Kg Operating Instructions

							Maintenance and Cleaning
818 34 51-00/789
External Cleaning
1 Warning! 
 There are sharp edges on the underside of the product  so care should 
be taken when cleaning.
0 1.Clean the inside and accessories with warm water and bicarbonate of 
soda (5 ml to 0.5 litre of water). 
2.Rinse and dry thoroughly.
2 Accumulation of dust at the condenser increases energy consumption. 
For this reason carefully clean the condenser at the back of the 
appliance once a year with a soft brush or a vacuum cleaner.
3.After everything is dry place appliance back into service. 
Change of the carbon filter
To maintain the best performance 
the carbon filter should be chan-
ged once a year with normal 
usage. 
New carbon filters can be purcha-
sed from your local dealer.
0 1.The filter is placed behind the grill 
and can be reached by opening 
the cover. The cover can be ope-
ned by simultaneously pressing 
the lever on the right of the grill 
(1) and turning the cover outward 
(2). 
2.The carbon filter is then pulled 
out of its slot (3).
3.The new carbon filter is placed in 
the existing slot.
1 The filter should be handled care-
fully so fragments don´t loosen 
from the surface.
 
						

							90818 34 51-00/7
What to do if ...
Correcting Malfunctions
A malfunction may be caused by only a minor fault that you can rectify 
yourself using the following instructions. Do not perform any other 
work on the appliance if the following information does not provide 
assistance in your specific case.
1 Warning! Repairs to refrigerators/freezers may only be performed by 
qualified service engineers. Improper repairs can give rise to significant 
hazards for the user. If your appliance needs repairing, please contact 
your specialist dealer or our Customer Service.
SymptomPossible CauseSolution
No power to the appliance.
Appliance is not switched 
on.Switch on the appliance.
Mains plug is not plugged 
in or is loose.Insert mains plug.
Fuse has blown or is defec-
tive.Check fuse, replace if 
necessary.
Mains socket is defective.
Mains malfunctions are to 
be corrected by an electri-
cian.
Appliance cools too much.Temperature is set too cold.Temporarily select a higher 
temperature setting.
The food is too warm.
Temperature is not properly 
adjusted.Please look in the  Tem-
perature Adjustment sec-
tion.
Door was open for an 
extended period.Open the door only as long 
as necessary.
A large quantity of warm 
food was placed in the 
appliance within the last 
24 hours.Press the COOLMATIC and/
or FROSTMATIC button. 
Turn the temperature regu-
lator to a colder setting 
temporarily.
The appliance is near a 
heat source.Please look in the Installa-
tion section.
 
						

							What to do if ...
818 34 51-00/791
Temperature display shows 
a square or a letter.There is a function fault.
Please inform customer 
service. Do not open the 
doors of the appliance 
again.
Warning tone sounds, red 
warning indicator light and 
temperature display are 
flashing.
Temperature warning.
Please check in Control 
and Information System 
section.
Food items in the 0 °C 
fridge section are frozen.High moisture content in 
the food items.
Move the food items 
(distribute them around 
the 0 °C fridge section as 
much as possible, do not 
push them against the wall). 
Hold down the “+” and “-” 
buttons for the fridge for 
approximately 5 seconds in 
order to switch over to an 
increased operating 
temperature. A short 
acoustic signal will sound.
To switch back to the 
normal operating 
temperature, hold down 
the “+” and “-” buttons for 
the fridge for 
approximately 5 seconds 
again. A short acoustic 
signal will sound.
Interior illumination does 
not function.
Light bulb is defective.
Important: The interior 
lighting switches off auto-
matically after 7 minutes. 
Please refer to Replacing 
the Light Bulb section.
Water on the floor or on 
storage shelves.Water drain hole is 
blocked.See the Maintenance and 
Cleaning section.
Heavy build up of frost, 
possibly also on the door 
seal.Door seal is not air tight 
(possibly after changing 
over the hinges).
Carefully warm the leak-
ing sections of the door 
seal with a hair dryer (not 
hotter than approx. 50 °C). 
At the same time shape the 
warmed door seal by hand 
such that it sits correctly.
SymptomPossible CauseSolution
 
						

							What to do if ...
92818 34 51-00/7
If after the above checks there is still a fault, call your local AEG Service 
Force Centre.
In-guarantee customers should ensure that the above checks have been 
made as the engineer will make a charge if the fault is not a 
mechanical or electrical breakdown.
Please note that proof of purchase is required for in-guarantee service 
calls.
Replacing the Light Bulb
3 For safety reasons the interior lighting switches off after 7 minutes 
when the door is open. It switches on again the next time the door is 
opened. 
1 Warning!  Danger of electrical shock! Before replacing the light bulb 
switch off the appliance and remove the mains plug.
Light bulb specifications: 220-240 V, max. 25 W, fitting: E 14 
0 1.To switch the appliance off press and hold the ON/OFF button.
2.Unplug the mains plug.
3.To change the light bulb, undo the 
cross head screw and remove the 
light bulb cover downwards.
4.Change the defective light bulb.
5.Refit the light bulb cover and the 
cross head screw.
The compressor does not 
start immediately after 
changing the temperature 
setting.
This is normal, no error has 
occurred.The compressor starts after 
a period of time.
NoiseAppliance is not level.
Readjust the front levelling 
feet.
Refer to Normal Operating 
Sounds
SymptomPossible CauseSolution
 
						

							818 34 51-00/793
Normal Operating Sounds
The following noises are characteristic of refrigeration appliances:
Clicks
Whenever the compressor switches on or off, a click can be heard.
Humming
As soon as the compressor is in operation, you can hear it humming.
Bubbling/Splashing
When refrigerant flows into thin tubes, you can hear bubbling or 
splashing noises. Even after the compressor has been switched off, 
this noise can be heard for a short time. 
Regulations, Standards, Guidelines
This appliance was designed for household use and was manufactured 
in accordance with the appropriate standards. The necessary measures 
in accordance with appliance safety legislation regulations (GSG), 
accident prevention regulations for refrigeration appliances (VBG 20) 
and the regulations of the German Society of Electrical Engineers (VDE) 
were observed in the manufacture of this appliance.
The refrigerant circuit has been checked for leaks.
; This appliance is in accordance with the following EU guidelines:
– 73/23/EWG dated 19 February 1973 - low voltage guidelines.
– 89/336/EWG dated 3 May 1989
(including guideline change notice 92/31/EWG) - EMV guideline 
 
						

							94818 34 51-00/7
Technical Terminology
Refrigerant
Liquids that can be used to a generate a cooling effect are known as 
refrigerants. They have a relatively low boiling-point, indeed so low, 
that the warmth from the food stored in the fridge or freezer can 
cause the refrigerant to boil and vaporise.
Refrigerant Circuit
Closed circulation system that contains the refrigerant. The 
refrigerant circuit comprises primarily of an evaporator, a compressor, 
a condenser and pipe work.
Evaporator
The refrigerant is evaporated in the evaporator. Similar to all other 
liquids, refrigerant requires heat to evaporate. This heat is removed 
from the interior of the appliance, as a result the interior is cooled. 
The evaporator is therefore located inside the appliance or placed in 
foam immediately behind the inner wall and thus not visible.
Compressor
The compressor looks like a small drum. It is driven by a built-in 
electric motor and is mounted on the base of the appliance at the 
rear. The task of the compressor is to draw in vaporised refrigerant 
from the evaporator, to compress it, and to pass it on to the 
condenser.
Condenser
The condenser normally has the form of a grid. The refrigerant 
compressed in the compressor is liquefied in the condenser. During 
this process, heat is released to the surrounding air at the surface of 
the condenser. The condenser is mounted on the base of the 
appliance.
 
						

							818 34 51-00/795
Customer Service
If you cannot find the remedy for a malfunction in these operating 
instructions, please contact your dealer or our customer service depart-
ment. Addresses and telephone numbers are listed in the accompanying 
booklet Guarantee Conditions/Service Departments.
Selective ordering of replacement parts can save unnecessary travel 
and costs. For this reason always provide the following appliance infor-
mation:
This information can be found on the rating plate in the interior at the 
left of the appliance. We recommend that you enter this information 
here, so that it is handy if needed.
Note:  The customer bears the costs of unjustified customer service 
calls even during the guarantee period.  Model Name
 Model Number (PNC)
 Serial Number (S-No.)
 
						

							From the Electrolux Group. The world´s No.1 choice.
The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning and outdoor
use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines,
vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. USD 14 billion in more
than 150 countries around the world.
AEG Hausgeräte GmbH
Postfach 1036
D-90327 Nürnberg
http://www.aeg.hausgeraete.de
© Copyright by AEG
818 3451 – 00/7 - 0404 Änderungen vorbehalten
Subject to change without notice
Salvo modificaciones