AEG S 75395 Kg Operating Instructions

							Installation
45
The refrigerator/freezer needs ventilation
Air is fed under the door through the 
vent slots in the base and is 
exhausted upwards along the back 
wall. To ensure proper air circulation 
never cover or alter the vent 
openings.
Important!  If the appliance is 
installed under a hanging cabinet, a 
clearance of at least 10 cm between 
the top of the appliance and the 
cabinet above it must be maintained.
Please check whether, after installing 
your appliance and especially after 
reversing the door, the door seal seals 
tightly. A badly fitting door seal may 
lead to heavy frosting and a higher 
power consumption (see also 
Something not working“).
0 1.Remove the two wall spacers 
from the appliance accessories 
pack and insert them into the 
heat exchanger bars (condenser) 
located at the top of the rear of 
the appliance as per the illustra-
tion, so that the distance between 
the back of the appliance and the 
wall that is required for correct 
ventilation is ensured. 
Appliance Alignment
0 1.The appliance must be level. Please compensate for unevenness in the 
floor by turning the two adjustable feet at the front. 
 
						

							46
Electrical Connection
A properly installed socket outlet with earthing contact is required for 
electrical connection. Electrical fuse protection must be of at least 10 
ampere.
If the outlet socket is no longer accessible after installation of the 
appliance, appropriate measures must be taken during electrical instal-
lation to assure that the appliance can be disconnected from the mains 
(e.g. fuse, circuit breaker, non-operate current safety-switch or the like, 
with a contact opening of at least 3 mm).
0Before initial start-up, refer to the appliance rating plate to ascertain if 
supply voltage and current values correspond with those of the mains 
at the installation location.
e.g.: AC 220 ... 240 V 50 Hz or
 220 ... 240 V~50 Hz
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance at the left. 
Warning: To avoid potential danger, if the mains connection lead of 
this appliance is damaged, it must be replaced by our customer service 
representative or a person with similar qualifications. 
Warning: Under no circumstances should the appliance be connected 
to electronic “power saving plugs” or to a.c.-d.c. converters which con-
vert direct current to 230 V alternating current (e.g., solar installations, 
ship networks)
Reversing The Door 
The door hinges can be changed from right (as supplied) to left if 
required to suit the location where the appliance is installed. 
1 Warning! Unplug from the mains, before reversing the door. 
0 1.Open the freezer door and with-
draw the base mask to the front. 
At the same time, press on the 
base mask from above. Transfer 
the door bearing covers on the 
base mask from left to right.
 
						

							Reversing The Door
47
2.Unscrew the centre door bear-
ing:
Open the fridge and freezer 
doors. Undo the screws far 
enough to be able to take the 
top door bearing bolt out of 
the freezer door. Close the 
freezer door. Remove the door 
bearing bolt from the bottom 
of the fridge door and close 
the fridge door. 
Caution! Take care when 
removing the centre door bear-
ing that the doors do not fall 
down.
Remove the centre door bear-
ing; remove the doors and lay 
them carefully on the floor.
3.Unscrew the upper and lower 
door bearing bolts, transfer, 
and screw them onto the 
opposite side.
4.Remove the plastic covers for 
the centre door bearing and 
insert them on the opposite side.
5.Transfer the self-closing system:
Unscrew the self-closing system on the right of the freezer door and 
screw it onto the opposite side of the freezer door.
Unscrew the self-closing system on the right of the fridge door and 
screw it onto the opposite side of the fridge door.
6.Fit the freezer door into the lower door bearing bolt and insert the cen-
tre door bearing above into the freezer door.
7.Insert the fridge door into the upper door bearing bolt. Pull both doors 
forwards until the centre door bearing can be inserted below into the 
fridge door.
8.Position the doors and centre door bearing against the housing and 
screw the centre door bearing tight with each door open. 
9.Fit the base mask with the freezer door open. To do this insert the two 
lower fins of the base mask in the housing and press the basemask 
against the housing until the upper catches of the basemask snap into 
position in the housing. To do this, press the catches downwards.
 
						

							Reversing The Door
48
After changing the door hinges, check that the magnetic seals on the 
doors fit perfectly against the housing and that the interior lighting 
goes off when the door is closed.
10.Depending on the model:
Model with bar handle
Unscrew the top handle bracket 
from the handle rod (1). Unscrew 
the bottom handle bracket from 
the door (2).
Unscrew the top handle bracket 
from the door (3) and screw onto 
the bottom right-hand side of the 
door (4).
1 Caution! Do not overtighten the 
screws (max. 2 Nm) as you may 
damage the door handles.
Turn the handle bracket with the 
handle rod 180° and screw them 
to the door (5) and the fitted 
handle bracket (6). 
1 Caution! Do not overtighten the 
screws (max. 2 Nm) as you may 
damage the door handles.
 
						

							49
Appliance Description
View of Appliance
(various models)
áControl Panel 
àButter and Cheese Compartment with Lid
âDoor Storage Compartments
äBottle Compartment/Bottle Rack
ãFRESH Box
åFruit/Vegetable Drawer 
çShelves
éFreezer Drawer (Maxi Box) 
èFreezer Drawer 
êFRUIT-Box 
ëRating Plate 
 
						

							50
No-Frost-System
The no-frost-system enables both the freezing of fresh foods and the 
storage of ready frozen or cooled foods by means of cold air. A vapor-
iser cools the air in the interior space of the appliance, which is circu-
lated and uniformly distributed by a ventilator. This uniformly 
circulating air-flow provides for a dry climate, low temperature fluctu-
ations and low temperature differences throughout the appliances 
interior space. The moisture in the air condenses as frost on the vapor-
iser. As soon as is necessary, the vaporiser defrosts fully automatically. 
The melted water is drained off outside to the compressor and evapo-
rates as a result of the heat generated there. This means that the inte-
rior of the appliance and the stored chilled or frozen foodstuffs always 
remain free of frost and ice. Manual defrosting is not needed. 
Control Panel 
  1Temperature regulator for the freezer
  2WARNING OFF button (open door warning) (red)
  3WARNING OFF button (temperature warning) (red)
  4FROSTMATIC button (for rapid freezing in the freezer compart-
ment) (yellow)
  5ON/OFF button (green)
  6Temperature regulator for fridge
Prior to Initial Start-Up
1 Before connecting the appliance to the mains and putting it into ope-
ration for the first time, leave the appliance to stand for 30 minutes if 
was transported upright. After transport on its side, the appliance must 
be left to stand for 4 hours before putting it into operation. This is 
necessary to allow the oil to flow back into the compressor. Otherwise 
the compressor may be damaged.
0 1.Please clean the appliance interior and all accessories prior to initial 
start-up (see section: Maintenance and Cleaning).
 
						

							51
Starting Up and Regulating the Temperature
Fridge and freezer sections can each be regulated independently of the 
other. The control panel is situated behind the fridge door at the top of 
the fridge section. 
0 1.Insert plug into mains socket. Within 20 seconds the electronics carry 
out a system test and switch the appliance on. The ON/OFF button 
lights up in green, the interior lighting comes on and the appliance 
starts working. If the temperature warning signal sounds, this can be 
switched off by pressing the ALARM OFF button.
3 Starting up when the appliance is switched off:
Press and hold down the ON/OFF button for three seconds. The ON/OFF 
button lights up in green, the interior lighting comes on and the 
appliance starts working. If the temperature warning signal sounds, it 
can be switched off by pressing the ALARM OFF button.
Setting the Fridge Temperature
0 1.Open the fridge door.
A coin is required to turn the temperature regulator. This makes it more 
difficult to change the temperature setting accidentally (child safety).
Setting “
H” = holiday switch
Setting “2” = warmest interior temperature
Setting “5” = coldest interior temperature
2.Using a coin, set the temperature required for the fridge by turning the 
temperature regulator. Select a middle position for normal operation.
The interior temperature is affected by the ambient temperature, the 
amount of food in the fridge, and how frequently and for how long the 
door is opened.
3.Close the fridge door
3 As the storage temperature within the fridge is reached quickly you can 
store food immediately after switching on.
Setting the Freezer Temperature
0 1.Open the fridge door.
A coin is required to turn the temperature regulator. This makes it more 
difficult to change the temperature setting accidentally (child safety).
Setting “1” = warmest interior temperature
Setting “5” = coldest interior temperature
 
						

							52
2.Using a coin, set the temperature required for the freezer by turning 
the temperature regulator. Select a middle position for normal opera-
tion.
3.Press the FROSTMATIC button. The FROSTMATIC button will be illumi-
nated in yellow and the compressor will operate continuously. 
4.To switch off the FROSTMATIC function, press the FROSTMATIC button 
again. The yellow FROSTMATIC button will go off. 
5.Wait until the temperature in the freezer compartment has reached 
-18 °C before storing frozen foods. 
3 Where food hygiene is concerned -18 °C should be considered suffi-
ciently cold for storing food in the freezer.
Information: The red warning indicator and temperature warning tone 
will be activated:
– when the freezer is started up (if the storage temperature has not yet 
been reached)
– if the temperature in the freezer compartment is too warm;
– if there is a malfunction in the appliance.
You can cancel the warning tone with the ALARM OFF button. The 
warning indicator and warning tone switch off automatically when the 
temperature in the freezer falls below -10 °C.
Such a temperature increase is probably due to:
– frequent or extended opening of the door;
– storing large quantities of warm food;
– high ambient temperature;
– a fault in the appliance.
FROSTMATIC Button
The FROSTMATIC function accelerates the freezing of fresh food and, at 
the same time, protects foodstuffs already stored from undesirable 
warming.
0 1.The FROSTMATIC function is switched on by pressing the FROSTMATIC 
button. The button is illuminated in yellow. The compressor runs con-
tinuously.
2.The FROSTMATIC function can be switched off again manually at any 
time by pressing the FROSTMATIC button again. The yellow illumination 
in the button will go off.
 
						

							53
If the FROSTMATIC function is not ended manually, the appliance elec-
tronics switch off the FROSTMATIC function after 36 hours. The yellow 
illumination in the button will go off.
“Open Door” Warning
When the fridge or freezer door are open the open door warning but-
ton flashes red and a warning tone is sounded.
– after approx. 1 minute if the freezer door is open
– after approx. 4 minutes if the fridge door is open
If you need more time for inserting frozen or chilled foods or moving 
them around you can switch off the warning tone by pressing the 
DOOR OPEN button. The button will stop flashing and will be 
illuminated in red.
The warning tone and the red warning indicator switch off when the 
doors are closed.
Temperature Warning
The ALARM OFF button flashes in red and a warning tone sounds as 
soon as the temperature in the freezer rises above -10 °C. 
0 1.You can cancel the warning tone with the ALARM OFF button. 
The button will stop flashing and will be illuminated in red.
3 The warning tone and the red warning indicator switch off automati-
cally when the temperature in the freezer falls below -10 °C. 
Such a temperature increase is probably due to:
– frequent or extended opening of the door;
– storing large quantities of warm food;
– high ambient temperature;
– a fault in the appliance.
Attention! If suspicion of partial or complete thawing exists, please 
check the quality of the foods to determine if they can be used.
If the temperature warning stays on for a longer period please contact 
AEG Service Force.
 
						

							54
Switching the Appliance Off
0 1.To switch off, hold down the ON/OFF button for approx. 3 seconds. The 
green illumination in the button will go off.
If the appliance is not going to be used for an extended period:
0 1.Switch off the appliance by holding down the ON/OFF button for 
approx. 3 seconds. The green illumination in the button will go off.
2.Remove the mains plug or switch off.
3.Clean the appliance thoroughly (see section: “Cleaning and Care”).
4.Leave the doors open after defrosting to avoid accumulation of odours. 
Holiday Mode
In the holiday mode the temperature for the refrigerator is approxi-
mately between +10 °C and +12 °C. In the holiday mode it is therefore 
possible to leave the door of the empty refrigerator closed during peri-
ods of extended absence. Advantage: Unintentional closing of the door, 
or accidental closing of the door by persons who have access to your 
home during your absence, is no longer possible. Without the holiday 
mode leaving the door closed would lead to the accumulation of 
odours and mould.
After emptying and cleaning the appliance, proceed as follows:
0 1.To switch on the holiday mode, turn the temperature regulator for the 
fridge to position H. 
Important! Do not store any foodstuffs in the fridge when the holiday 
mode is operating. The temperature when the holiday switch is on is 
regulated to between approximately +10 °C and +12 °C. This is too 
warm for foods. 
Opening the Freezer Compartment Door
If the freezer compartment door is closed when the appliance is in 
operation, it is possible that it cannot be immediately opened again. A 
vacuum occurs in the freezer compartment which holds the door closed 
until pressure has been equalised. The door can be opened again after 
several minutes.