AEG S 70408 Kg Operating Instructions

Installation
818 36 43-01/711
The refrigerator/freezer needs ventilation
Air is fed under the door through the 
vent slots in the base and is exhausted 
upwards along the back wall. To ensure 
proper air circulation never cover or 
alter the vent openings.
Important!  If the appliance is installed 
under a hanging cabinet, a clearance of 
at least 10 cm between the top of the 
appliance and the cabinet above it must 
be maintained.
Please check whether, after installing 
your appliance and especially...

Installation
12818 36 43-01/7
Electrical Connection
Any electrical work required to install this appliance should be carried 
out by a qualified electrician or competent person.
1 WARNING – THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should these safety measures 
not be observed.
Before switching on, make sure the electricity supply voltage is the 
same as that indicated on the appliance rating plate. The rating plate is 
inside, on the left.
The appliance is supplied with a 13...

818 36 43-01/713
Reversing The Door 
The door hinges can be changed from right (as supplied) to left if 
required to suit the location where the appliance is installed. 
1 Warning! Unplug from the mains, before reversing the door. 
0 1.Open the freezer compartment 
door and remove the plinth to 
the front. Move the door bearing 
cover on the plinth from the left 
to the right. 
2.Close the freezer compartment 
door. Open the fridge compart-
ment door and unscrew the 
retaining screw for the self-clos-...

Reversing The Door
14818 36 43-01/7
5.Unscrew the centre door bearing. 
6.Remove the fridge compartment 
door carefully to the front and 
place on one side. 
7.Unscrew the retaining screw for 
the self-closing mechanism on the 
bottom of the fridge compart-
ment door. 
8.Move the upper bearing pivot to 
the left. 
9.Unscrew the top handle bracket 
from the handle rod (1). Unscrew 
the bottom handle bracket from 
the door (2).
10.Unscrew the top handle bracket 
from the door (3) and screw onto 
the bottom...

Reversing The Door
818 36 43-01/715
11 .Turn the handle bracket with the 
handle rod 180° and screw them 
to the door (5) and the fitted han-
dle bracket (6). 
1 Caution! Do not overtighten the 
screws (max. 2 Nm) as you may 
damage the door handles.
12.Fasten the self-closing mechanism 
to the bottom left of the fridge 
compartment door.
13.Carefully slide the fridge com-
partment door onto the top bear-
ing pivot and close. 
14.Slide the centre door bearing into 
the bottom left of the fridge com-...

Reversing The Door
16818 36 43-01/7
15.Fasten the self-closing mechanism 
on the top left of the freezer 
compartment door. 
16.Carefully slide the freezer com-
partment door onto the centre 
bearing pivot and close. 
17.Place the lower door bearing with 
the bearing pivot in the lower left 
of the freezer compartment door 
and fasten. 
18.Open the freezer compartment 
door and fit the plinth. 
Important: Do not damage door 
contact (if present). 
 

818 36 43-01/717
Appliance Description
View of Appliance
(various models)
áControl panel 
àButter and cheese compartment with lid
âDoor storage compartments
äBottle compartment
ãSalad bin
åBottle rack
çShelves
éFreezer drawer (only for storage) 
When defrosting the bottom drawer also serves as a water 
collecting vessel.
èFreezer drawer (for storage and freezing)
êFreezer tray 
ëRating plate 
 

Appliance Description
18818 36 43-01/7
Freezer tray 
A freezer tray  is included below the 
upper drawer in the freezer 
compartment.
Berries and vegetables, for example, 
can be pre-frozen on the freezer tray.
Advantage: The berries are not squeezed and maintain their natural 
form. The frozen berries can then be stored in compartments or drawers 
packaged in individual portions. 
Cold Accumulation Block
A cold accumulation block is enclosed with the appliance.
3 In the event of power failure or a...

Appliance Description
818 36 43-01/719
Control Panel
  1ON/OFF button and ON/OFF indicator light (green)
  2Temperature display for refrigerator
  3Temperature setting buttons for refrigerator 
  4COOLMATIC button and COOLMATIC indicator light (yellow) 
 COOLMATIC for intensive cooling in the refrigerator
  5FROSTMATIC button and FROSTMATIC indicator light (yellow)
 FROSTMATIC for fast freezing in the freezer compartment
  6Temperature display for freezer compartment 
  7Temperature setting buttons for...

Appliance Description
20818 36 43-01/7
Temperature setting buttons
The temperature is adjusted using the 
„+“ (WARMER) and „-“ (COLDER) buttons.
These buttons are connected to the temperature display.
 The temperature display is switched over from the display of the 
ACTUAL temperature (Temperature display is illuminated) to the dis-
play of the DESIRED temperature (Temperature display flashes) by 
pressing one of the two buttons, „+“ (WARMER) or „-“ (COLDER). 
 Each time one of the two buttons is...