AEG S 70358 Kg Operating Instructions

818 36 23-02/711
Installation
Installation Location
The appliance should be installed in a well ventilated, dry room.
Energy use and efficient performance of the appliance is affected by 
the ambient temperature.
The appliance should therefore
– not be exposed to direct sunlight;
– not be installed next to radiators, cookers or other sources of heat;
– only be installed at a location whose ambient temperature 
corresponds to the climate classification, for which the appliance is 
designed.
The climate...

Installation
12818 36 23-02/7
The refrigerator/freezer needs ventilation
Air is fed under the door through the 
vent slots in the base and is exhausted 
upwards along the back wall. To ensure 
proper air circulation never cover or 
alter the vent openings.
Important!  If the appliance is installed 
under a hanging cabinet, a clearance of 
at least 10 cm between the top of the 
appliance and the cabinet above it must 
be maintained.
Please check whether, after installing 
your appliance and especially...

818 36 23-02/713
0 1.Before initial start-up, refer to the appliance rating plate to ascertain if 
supply voltage and current values correspond with those of the mains 
at the installation location.
e.g.: AC 220 ... 240 V 50 Hz or
 220 ... 240 V~50 Hz
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance at the left. 
Warning: To avoid potential danger, if the mains connection lead of 
this appliance is damaged, it must be replaced by our customer service...

Reversing The Door
14818 36 23-02/7
3.With the freezer compartment 
door closed, remove the cross-
head screws from the lower door 
bearing and remove the door 
bearing downwards. 
4.Move the bearing pivot from the 
right to the left hand hole. 
Remove the freezer compartment 
door carefully to the front and 
place on one side. 
5.Unscrew the centre door bearing. 
6.Remove the fridge compartment 
door carefully to the front and 
place on one side. 
7.Unscrew the retaining screw for 
the self-closing...

Reversing The Door
818 36 23-02/715
9.Unscrew the top handle bracket 
from the handle rod (1). Unscrew 
the bottom handle bracket from 
the door (2).
10.Unscrew the top handle bracket 
from the door (3) and screw onto 
the bottom right-hand side of the 
door (4).
1 Caution! Do not overtighten the 
screws (max. 2 Nm) as you may 
damage the door handles.
11 .Turn the handle bracket with the 
handle rod 180° and screw them 
to the door (5) and the fitted han-
dle bracket (6). 
1 Caution! Do not overtighten...

Reversing The Door
16818 36 23-02/7
13.Carefully slide the fridge com-
partment door onto the top bear-
ing pivot and close. 
14.Slide the centre door bearing into 
the bottom left of the fridge com-
partment door and fasten to the 
housing. 
15.Fasten the self-closing mechanism 
on the top left of the freezer 
compartment door, 
16.Carefully slide the freezer com-
partment door onto the centre 
bearing pivot and close. 
17.Place the lower door bearing with 
the bearing pivot in the lower left 
of the...

818 36 23-02/717
Appliance Description
View of Appliance
(various models)
áControl panel 
àButter and cheese compartment with lid
âDoor storage compartments
äBottle compartment
ãFruit and vegetable drawer
åBottle rack
çShelves
éFreezer drawer (only for storage) 
When defrosting the bottom drawer also serves as a water 
collecting vessel.
èFreezer drawer (for storage and freezing)
êFreezer tray 
ëRating plate 
 

Appliance Description
18818 36 23-02/7
Freezer tray 
A freezer tray  is included below the 
upper drawer in the freezer 
compartment.
Berries and vegetables, for example, 
can be pre-frozen on the freezer tray.
Advantage: The berries are not squeezed and maintain their natural 
form. The frozen berries can then be stored in compartments or drawers 
packaged in individual portions. 
Cold Accumulation Block
A cold accumulation block is enclosed with the appliance.
3 In the event of power failure or a...

Appliance Description
818 36 23-02/719
Control Panel
  1ON/OFF button and ON/OFF indicator light (green)
  2Temperature display for refrigerator
  3Temperature setting buttons for refrigerator 
  4COOLMATIC button and COOLMATIC indicator light (yellow) 
 COOLMATIC for intensive cooling in the refrigerator
  5FROSTMATIC button and FROSTMATIC indicator light (yellow)
 FROSTMATIC for fast freezing in the freezer compartment
  6Temperature display for freezer compartment 
  7Temperature setting buttons for...

Appliance Description
20818 36 23-02/7
Temperature setting buttons
The temperature is adjusted using the 
„+“ (WARMER) and „-“ (COLDER) buttons.
These buttons are connected to the temperature display.
 The temperature display is switched over from the display of the 
ACTUAL temperature (Temperature display is illuminated) to the dis-
play of the DESIRED temperature (Temperature display flashes) by 
pressing one of the two buttons, „+“ (WARMER) or „-“ (COLDER). 
 Each time one of the two buttons is...