AEG S 60360 Kg1 User Manual

Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer(s)
provided.
Butter and cheese: these should be placed in special airtight containers or wrapped in
aluminium foil or polythene bags to exclude as much air as possible.
Milk bottles: these should have a cap and should be stored in the bottle rack on the door.
Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator.
Hints for freezing
To help you make the most of the freezing...

• regularly check the door seals and wipe clean to ensure they are clean and free from
debris.
• rinse and dry thoroughly.
Do not pull, move or damage any pipes and/or cables inside the cabinet.
Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes
to clean the interior as this will damage the surface and leave a strong odour.
Clean the condenser (black grill) and the compressor at the back of the appliance with a
brush or a vacuum cleaner. This operation will improve...

• put insulating material around the drawers, e.g. blankets or newspapers.
Defrosting can be accelerated by placing bowls
with hot water (not boiling) inside the freezer.
• Loosen the drainage channel from its resting
position, push it in according to the illustration
and place it in the bottom freezer drawer where
water can collect
• carefully scrape off the ice when it starts to
thaw. Use a wood or a plastic scraper
• when all the ice has melted, clean and wipe the
cabinet dry, then put the drainage...

ProblemPossible causeSolution
 The FROSTMATIC function is
switched on.Refer to FROSTMATIC function.
 The COOLMATIC function is
switched on.Refer to COOLMATIC function.
Water flows on the rear
plate of the refrigerator.During the automatic defrosting
process, frost defrosts on the
rear plate.This is correct.
Water flows into the re-
frigerator.The water outlet is clogged.Clean the water outlet.
 Products prevent that water
flows into the water collector.Make sure that products do not
touch the rear...

Replacing the lamp
CAUTION!
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Pull outwards the hook of the lamp cov-
er.
3. Remove the lamp cover.
4. Replace the lamp with one of the same
power (the maximum power is shown on
the light bulb cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the plug to the mains socket.
8. Open the door. Make sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary,...

Climate classAmbient temperature
SN+10°C to + 32°C
N+16°C to + 32°C
ST+16°C to + 38°C
T+16°C to + 43°C
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely
around the back of the cabinet. To ensure best
performance, if the appliance is positioned below
an overhanging wall unit, the minimum distance
between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the...

Levelling
When placing the appliance ensure that it stands
level. This can be achieved by two adjustable feet
at the bottom in front.
Removing the shelf holders
Your appliance is equipped with shelf retainers
that make it possible to secure the shelves during
transportation.
To remove them proceed as follows:
1. Move the shelf holders in the direction of the
arrow (A).
2. Raise the shelf from the rear and push it for-
ward until it is freed (B).
3. Remove the retainers (C).
Door reversibility
WARNING!...

1. Open the doors. Unscrew the middle
hinge (m2). Remove the plastic spacer
(m1).
2. Remove the spacer (m6) and move to the
other side of the hinge pivot (m5).
3. Remove the doors.
4. Remove the left-hand cover pin of the
middle hinge (m3,m4) and move to the
other side.
5. Fit the pin of the middle hinge (m5) into
the left-hand hole of the lower door.
6. Remove using a tool the cover (b1). Un-
screw the lower hinge pivot (b2) and the
spacer (b3) and place them on the op-
posite side.
7. Re-insert the...

11. Unscrew the upper hinge pivot (t1) and
place it on the opposite side.
12. Fit the upper door on the upper door
pivot.
13. Re-insert the upper door on the middle
hinge pivot (m5) slightly tilting both
doors.
14. Re-screw the middle hinge (m2). Do not
forget the plastic spacer (m1).
15. Remove the cover pins (h1). Remove the
cover (h2).
16. Unscrew the handles (h3) and fix them
on the opposite side.
17. Re-insert the cover (h2) and the cover
pins (h1).
Do a final check to make sure that:
• All screws...

Nous vous remercions d’avoir choisi l’un de nos produits de qualité.
Afin de garantir une performance optimale et constante de votre appareil, veuillez
lire attentivement cette notice dutilisation. Il vous permettra d’utiliser
correctement et efficacement toutes les fonctions de l’appareil. Nous vous
recommandons de conserver cette notice à proximité pour une utilisation rapide et
optimale. Si lappareil devez être vendu ou cédé à une autre personne, assurez-vous
que la notice dutilisation laccompagne....