AEG Mixed Hob HD634170NB User Manual

Immediately touch  until the correct
heat setting comes on. After 3 seconds
 comes on.
To deactivate the function:  touch 
.
Power function
This function makes more power
available to the induction cooking zones.
The function can be activated for the
induction cooking zone only for a limited
period of time. After this time the
induction cooking zone automatically
sets back to the highest heat setting.
To activate the function for a cooking
zone:  touch 
.  comes on.
To deactivate the function:  touch...

To activate the function: activate the
hob with 
. Do not set the heat setting.
Touch 
 for 4 seconds.  comes on.
Deactivate the hob with 
.
To deactivate the function:  activate the
hob with 
. Do not set the heat setting.
Touch 
 for 4 seconds.  comes on.
Deactivate the hob with 
.
To override the function for only one
cooking time:  activate the hob with 
.
 comes on. Touch  for 4 seconds. 
Set the heat setting in 10 seconds.  You
can operate the hob. When you
deactivate the hob with 
 the function...

WARNING!
Do not put the same pan on
two burners.WARNING!
Do not put unstable or
damaged pots on the
burners to prevent from spill
and injury.CAUTION!
Make sure that the bottoms of pots do not stand above
the control knobs, otherwise
the flame heats the control
knobs up.CAUTION!
Make sure that pot handles
are not above the front edge
of the cooktop.CAUTION!
Make sure that the pots are
placed centrally on the
burners in order to get
maximum stability and to
get lower gas consumption.CAUTION!
Liquids spilt...

Heat settingUse to:Time
(min)Hints1 - 2.Hollandaise sauce, melt: but-
ter, chocolate, gelatine.5 - 25Mix from time to time.1 - 2.Solidify: fluffy omelettes,
baked eggs.10 - 40Cook with a lid on.2. - 3.Simmer rice and milkbased
dishes, heating up ready-
cooked meals.25 - 50Add the minimum twice as
much liquid as rice, mix milk
dishes part procedure
through.3. - 4.Steam vegetables, fish, meat.20 - 45Add some tablespoons of liq-
uid.4. - 5.Steam potatoes.20 - 60Use max. ¼ l water for 750 g of
potatoes.4. -...

burner for the burner to operate
correctly.6.3  Cleaning the hob
•Remove immediately:  melted plastic,
plastic foil, and food with sugar. If not, the dirt can cause damage to the hob.
Put the special scraper on the glass
surface at an acute angle and move
the blade on the surface.
• Remove when the hob is sufficiently
cool:  limescale rings, water rings, fat
stains, shiny metallic discoloration.
Clean the hob with a moist cloth and
some detergent. After cleaning, rub the hob dry with a soft cloth.
• To...

ProblemPossible causeRemedyAn acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.You put something on one
or more sensor fields.Remove the object from the
sensor fields.The hob deactivates.You put something on the
sensor field 
.
Remove the object from the
sensor field.Residual heat indicator does
not come on. The zone is not hot because
it operated only for a short
time.If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service...

ProblemPossible causeRemedy comes on.There is an error in the hob
because a cookware boils
dry. Automatic Switch Off
and the overheating protec-
tion for the zones operate.Deactivate the hob. Remove
the hot cookware. After ap-
proximately 30 seconds, acti-
vate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator can
stay on. Let the cookware
become sufficiently cool.
Check if your cookware is
compatible with the hob.
Refer to “Hints and tips”
chapter.There...

7.3 Labels supplied with the
accessories bag
Stick the adhesive labels as indicated
below:A) Stick it on Guarantee Card and send
this part (if applicable).
B) Stick it on Guarantee Card and keep
this part (if applicable).C) Stick it on instruction booklet.8.  INSTALLATIONWARNING!
Refer to Safety chapters.8.1  Before the installation
Before you install the hob, write down
the information bellow from the rating
plate. The rating plate is on the bottom
of the hob.
Model...

volume less than 5 m³ an air vent of
effective area of 100 cm² is required. If it
is installed in a room of volume between
5 m³ and 10 m³ an air vent of effective area of 50 cm² is required, while if the
volume exceeds 11 m³ no air vent is
required.
However, if the room has a door which
opens directly to the outside no air vent
is required even if the volume is between 5 m³ and 11 m³.
If there are other fuel burning appliances in the same room, B.S. 5440 Part 2
Current Edition, should be consulted to...

Rigid connection:
Carry out connection by using metal rigid
pipes (copper with mechanical end).8.5  Injectors replacement
1.Remove the pan supports.
2. Remove the caps and crowns of the
burner.
3. With a socket spanner 7 remove the
injectors and replace them with the
ones which are necessary for the type
of gas you use (see table in
"Technical Information" chapter).
4. Assemble the parts, follow the same
procedure backwards.
5. Replace the rating plate (it is near the
gas supply pipe) with the...