AEG Lavamat L 16850 Manual

11Display
Display (9)
Spin Speed indicator, RINSE HOLD , NIGHT CYCLE - symbols
Drying degree indicator allowed by the set programme, IRON DRY  ,
CUPBOARD DRY  and EXTRA DRY  - symbols, selectable by
pressing the button 3and indicator «AUTO», connected to the drying
programme and the button 4. 
Programme progress indicator: PREWASH , MAIN WASH , RINSE , SPIN
OVERDOSAGE , DRYING  , ANTI-CREASE phase - symbols
The programme progress indicator shows the washing or drying phases of the
selected programme....

12Display
The display shows the following information:
Duration of the selected programme
After selecting a programme, the duration is displayed in hours and minutes (for
example 
2.05). The duration is calculated automatically on the basis of the
maximum recommended load for each type of fabric. After the programme has
started, the time remaining is updated every minute.
Delay start
The selected delay (20 hours max) set by pressing the relevant button appears on
the display for a few seconds (for...

13Use
First Use
Ensure that the electrical and water connections comply with the installation
instructions.
Remove the polystyrene block and any material from the drum.
Run a cotton cycle at 90°C or 95°C, without any laundry in the machine, to
remove any manufacturing residue from the drum and tub. Pour 1/2 a measure
of detergent into the dispenser drawer and start the machine.
Personalization
Acoustic signals
The machine is provided with the acoustic device, which sounds in the following
cases:
●at the...

14Use
Daily Use
Load the laundry
1.Open the door by carefully pulling the door
handle outwards. Place the laundry in the
drum, one item at a time, shaking them out as
much as possible.
2.Close firmly the door. You must hear a click
during closing.
Attention!Do not embed the laundry
between the door and the rubber joint.
Measure out the detergent and the fabric softener
Your new appliance was designed to reduce water, energy and detergent
consumption.
1.Pull out the dispenser drawer until it
stops....

15Use
WASHING
Select the required programme by pressing the programme
selector dial (1)
You can choose the right programme for any type of laundry following the
descriptions on the washing programme tables (see «Washing Programmes»).
Turn the programme selector dial to the required programme. The programme
selector determines the type of washing cycle (e.g. water level, drum movement,
number of rinses) and the washing temperature according to the type of laundry.
By selecting a programme, the programme...

16Use
NIGHT CYCLE: by selecting this option, the machine will not drain the water of
the last rinse, so as not to wrinkle the laundry. As all spinning phases are
suppressed, this washing cycle is very noiseless and it can be selected at night or
in times with a more economical power rate
.In some programmes the rinses will
be performed with more water. At the end of the programme, a blinking «
0» and
RINSE HOLD symbol appear on the display, the DOOR symbol remains lit, the
pilot light of button 
7goes...

17Use
The Prewash ends with a short spin in programmes for COTTON and SYNTHETIC
fabrics, whereas in the programmes for DELICATE fabrics the water is only
drained. The relevant symbol will appear on the display.
STAIN option
Select this option to treat heavily soiled or stained laundry with stain remover
(extended main wash with time optimised stain action phase).
This option is notavailable with a temperature lower than 40°C.
Attention!If you wish to perform a programme with the stain option, pour
stain...

18Use
Press the START/PAUSE (button 7)
To start the selected programme, press the button 7; the corresponding red pilot
light stops blinking.
The DOOR symbol appears on the display to indicate that the appliance has
started operating and the door is locked.
To interrupt a programme which is running, press the button 
7:the
corresponding red pilot light starts blinking.
To restart the programme from the point at which it was interrupted, pressthe
button 
7again.
If you have chosen a delayed start, the...

19Use
CANCELLING THE DELAYED START:
●set the washer-dryer to PAUSE by pressing the button 7;
●press the button 8 until the symbol 0’is displayed;
●press the button 7again to start the programme.
The button 
8cannotbe selected with DRAIN programme.
Altering an option or a running programme
It is possible to change any option before the programme carries it out. Before
you make any change, you must pause the washer-dryer by pressing the button
7.
Changing a running programme is possible only by resetting...

20Use 
At the end of the programme
The machine stops automatically, the pilot light of button 8and the DOOR
symbol go off, a blinking «
0» appears on the display and the acoustic signal
sounds for some minutes.
If you have choosen a programme or an option that ends with water in the tub,
follow the below instruction to empty the water out: :
●turn the programme selector dial to O
●select the DRAINING or SPINNING programme
●reduce the spin speed if needed, by pressing the relevant button
●press the button...