AEG Lavamat 86810 Information Manual

31
Technical data
5
This appliance conforms with the following EU Directives:
–73/23/EEC dated 19.02.1973 Low Voltage Directive
–89/336/EEC dated 03.05.1989 EMC Directive inclusive of Amending 
Directive 92/31/EEC
–93/68/EEC dated 22.07.1993 CE Marking Directive
Consumption values
The consumption values were obtained under standardised conditions. 
They may vary when operating in domestic conditions. 
 
Height x Width x Depth850 x 598 x 640 mm
Depth when door is open1017 mm
Height adjustmentapprox....

32
Installation and connection instructions
1Safety information for the installation
This washing machine cannot be built-in.
Before using for the first time, check the appliance for damage sus-
tained while it was being transported. Do not under any circumstanc-
es connect an appliance that is damaged. In the case of damage, 
please contact your supplier.
Before using for the first time, all parts of the transport lock must be 
removed. Otherwise when spinning damage may be caused to the ap-
pliance or...

33
Installing the appliance
Transporting the appliance
1Warning! The washing machine is very heavy. Risk of injury. Be careful 
when lifting.
Do not lay the appliance on its front nor on its right side (as seen 
from the front). Electrical components may get wet.
Never transport the appliance without its transport lock. Only remove 
the transport lock when the appliance is in its place of installation. 
Transporting the appliance without its transport lock can lead to 
damage to the appliance.
Never lift...

34
2.Remove the power supply cable and 
the draining hose from the hose 
holders on the rear of the appliance.
3.With a suitable spanner unscrew and 
remove the central rear bolt A. Slide 
out the relevant plastic spacer.
4.Unscrew and remove the two large 
rear bolts B and the six smaller bolts 
C.
 

35
5.Remove the bracket D.
6.Refit the six smaller bolts C.
7.Open the porthole and remove the 
polystyrene block fitted with the ad-
hesive tape on the door seal.
8.Fill the smaller upper hole and the 
two large ones with the correspond-
ing plastic plug caps supplied in the 
bag containing the instruction 
booklet.
Important!
All the different plug caps are sup-
plied with the appliance in the plas-
tic bag containing the instruction 
booklet.
 

36
Connect the water inlet hose as described under the paragraph “Water 
inlet”.
Where to install
Important! The appliance must not be used in a room where there is a 
danger of frost. Frost damage or impaired operation! Frost damage is 
not covered by the warranty.
The surface on which the appliance is to be installed must be firm 
and level. Do not install the appliance on carpets or on soft floor cov-
erings.
The surface on which the appliance is to be installed must be clean 
and dry and free from...

37
Connecting to the water supply
Permitted water pressure
Th e wat er press ure m ust  be at  leas t 1 bar (= 10 N/ cm2= 0.1 MPa) and may 
be a maximum of 10 bar (= 100 N/cm2=1MPa). 
–If more than 10 bar: Connect a pressure reduction valve. 
–If less than 1 bar: Disconnect the appliance end of the inlet hose from 
the solenoid inlet valve and remove the flow meter. (In addition re-
move the filter using pointed pliers and take out the rubber gasket 
behind it.) Re-insert the filter.
Water inlet...

38
4.Connect the hose to a tap with a 
3/4” thread. 
Always use the hose supplied with 
the appliance. 
Installation should comply with local 
water authority and building regula-
tions’ requirements.
A minimum water pressure of 0.05 
MPa (0.5 bar) is required for safe op-
eration of the appliance.
If you cannot make the cold water 
connection direct from the rising mains, you may be able to operate 
the appliance from your cold water storage system. 
There should be a minimum distance of 5.02m (16.5 ft)...

39
Water drainage
The maximum permitted difference between the height of the surface 
on which the appliance is installed and the water outlet is 1 metre.
Only original hoses may be used to extend hoses. (A maximum of 3 m 
laid on the floor and then 80 cm vertically). The Customer Care Depart-
ment stocks outlet hoses of different lengths.
Draining water into a sink outlet
Secure the outlet/sink outlet joint 
with a hose band clip (available from 
your dealer). 
Draining water into a wash basin/bath...

40
Guarantee/Customer Service
European Guarantee
This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user 
manual, for the period specified in the appliance guarantee or otherwise by law.  If you move 
from one of these countries to another of the countries listed below the appliance guarantee 
will move with you subject to the following qualifications:
 

The appliance guarantee starts from the date you first purchased the appliance which will be 
evidenced by...