AEG Lavamat 74950 A User Manual

1. After removing all the packaging, careful-
ly lay machine on it’s back to remove the
polystyrene base from the bottom.
2. Remove the power supply cable and the
draining hose from the hose holders on
the rear of the appliance.
3. Unscrew the three bolts using the key
supplied with the machine.
Installation31
 

4. Slide out the relevant plastic spacers.
5. Open the porthole, take out the inlet hose
from the drum and remove the polystyr-
ene block fitted on the door seal.
6. Fill the smaller upper hole and the two
large ones with the corresponding plastic
plug caps supplied in the bag containing
the instruction booklet.
7. Connect the water inlet hose as described
under the paragraph «Water inlet».
32Installation
 

Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the machine
is not impeded by carpets, rugs etc.
Before placing it on small tiles, apply a rubber
coating.
Never try to correct any unevenness in the floor
by putting pieces of wood, cardboard or similar
materials under the machine.
If it is impossible to avoid positioning the machine
next to a gas cooker or coalburning stove, an in-
sulating panel covered with aluminium foil on the
side facing the...

3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied with
the appliance.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Installation should comply with local water
authority and building regulations...

This could be done by tying it to the tap
with a piece of string or attaching it to the
wall.
2.
In a sink drain pipe branch. This branch
must be above the trap so that the bend
is at least 60 cm above the ground.
3.
Directly into a drain pipe at a height of
not less than 60 cm and not more than 90
cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter
of the drain hose.
The drain hose must not be kinked.
The drain hose...

WARNING!
Should the appliance power supply cable need to be replaced, this must be carried
out by a Service Centre.
Environment concerns
The symbol    on the product or on its packaging indicates that this product may not be
treated as household waste. Instead it should be taken to the appropriate collection point
for the recycling of electrical and electronic equipment. By ensuring this product is disposed
of correctly, you will help prevent potential negative consequences for the environment
and human...

37
 

38
 

39
 

www.electrolux.com
132951590 - 00 -312009