AEG Lavamat 72750 User Manual

Your appliance incorporates a recirculation system which allows an optimal use of the
concentrated detergent.
Follow the product manufacturer’s recommendations on quantities to use and do not
exceed the «MAX» mark in the detergent dispenser drawer .
Degrees of water hardness
Water hardness is classified in so-called “degrees” of hardness. Information on hardness of
the water in your area can be obtained from the relevant water supply company, or from
your local authority.
A water softener must be added...

External cleaning
Clean the exterior cabinet of the appliance with soap and water only, and then dry thor-
oughly.
Do not use methylated spirits, solvents or similar products to clean the cabinet.
Detergent dispenser drawer
The detergent dispenser drawer should be cleaned regularly.
1. Remove the detergent dispenser drawer by pulling it firmly.
2. Remove the conditioner insert from the
middle compartment.
3. Clean all parts with water.
4. Put the conditioner insert in as far as it
will go, so that it is...

Door seal
Check from time to time the door seal and elimi-
nate eventual possible objects that could be trap-
ped in the fold.
Drain pump
The pump should be inspected regularly and particularly if:
• the appliance does not empty and/or spin;
• the appliance makes an unusual noise during dra i n i n g  d u e  t o  o b j e c t s  s u c h  a s  s a f e t y  p i n s ,
coins etc. blocking the pump;
• a problem with water draining is detected (see chapter “What to do if...” for more details).
WARNING!
Before...

7. When no more water comes out, un-
screw the pump cover by turning it anti-
clockwise and remove the filter. Use pli-
ers, if necessary. Always keep a rag near-
by to dry up any water spillages when
removing the cover.
Clean the filter under a tap, to remove
any traces of fluff.
8. Remove foreign bodies and fluff from
the filter seat and from the pump im-
peller.
9. Check carefully whether the pump im-
peller rotates (it rotates jerkily). If it
doesn’t rotate, please contact your Serv-
ice Centre.
10....

Cleaning the water inlet filters
If the appliance doesnt fill, takes long to fill water, the starting button blinks yellow or the
display (if available) shows the relevant alarm (see chapter What to do if... for more details),
check if the water inlet filters are blocked .
To clean the water inlet filters:
1. Turn off the water tap.
2. Unscrew the hose from the tap.
3. Clean the filter in the hose with a stiff
brush.
4. Screw the hose back onto the tap. Make
sure the connection is tight.
5. Unscrew the...

Emergency emptying out
If the water is not discharged, proceed as follows to empty out the machine:
1. pull out the plug from the power socket;
2. close the water tap;
3. if necessary, wait until the water has cooled down;
4. open the pump door;
5. place a bowl on the floor and place the end of the emergency emptying hose into the
bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl
is full, put the cap back on the hose. Empty the bowl. Repeat the procedure until water...

ProblemPossible cause/Solution
The washing machine does not start:
The door has not been closed. • Close the door firmly.
The plug is not properly inserted in the power
socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical instal-
lation.
The main fuse has blown.
•Replace the fuse.
The selector dial is not correctly positioned and
the button 7 has not been depressed.
• Please turn the selector dial and press the
button 7 again.
The delay...

ProblemPossible cause/Solution
There is water on the floor:
Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Reduce the detergent quantity or use anoth-
er one.
Check whether there are any leaks from one of
the inlet hose fittings. It is not always easy to
see this as the water runs down the hose; check
to see if it is damp.
• Check the water inlet hose connection.
The drain hose is damaged.
• Change it with a new one.
The cap on the emergency emptying hose has
not been...

ProblemPossible cause/Solution
Spinning starts late or the machine does not
spin:
The electronic unbalance detection device has
cut in because the laundry is not evenly distrib-
uted in the drum. The laundry is redistributed
by reverse rotation of the drum. This may hap-
pen several times before the unbalance disap-
pears and normal spinning can resume. If, after
some minutes, the laundry is still not evenly
distributed in the drum, the machine will not
spin.
• Redistribute the laundry.
The load is too...

Electrical connection
Voltage - Overall power - FuseInformation on the electrical connection is given on the rating
plate, on the inner edge of the appliance door.
Water supply pressureMinimum
Maximum0,05 MPa
0,8 MPa
Maximum LoadCotton7 kg
Spin SpeedMaximum1200 rpm
Consumption values
ProgrammeEnergy consumption
(KWh)Water consumption
(litres)Programme duration
(Minutes)
White Cottons 95°2,165
For the duration of
the programmes,
please refer to the
display on the con-
trol panel.
Cottons 60°1,460
Cotton...