AEG Lavamat 72650 User Manual
Have a look at the manual AEG Lavamat 72650 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 513 AEG manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Installation Unpacking All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 1.After removing all the packaging, carefully lay machine on it’s back to remove the polystyrene base from the bottom. 2.Remove the power supply cable and the draining hose from the hose holders on the rear of the appliance. 3.With the provided spanner unscrew and remove the central rear bolt A. 41Installation 192998640 gb.qxd 13/08/2007 17.39 Pagina 41
4.Unscrew and remove the two large rear bolts B and the six smaller bolts C. 5.Remove the bracket Dand tighten up the six smaller bolts C. Slide out the relevant plastic spacerE. 6.Open the porthole, take out the inlet hose from the drum and remove the polystyrene block fitted on the door seal. 7.Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. 8.Connect the water inlet hose as described under the paragraph «Water inlet». All the different plug caps are supplied with the appliance in the plastic bag containing the instruction booklet. 42Installation 192998640 gb.qxd 13/08/2007 17.39 Pagina 42
Positioning and levelling Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Before placing it on small tiles, apply a rubber coating. Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine. If it is impossible to avoid positioning the machine next to a gas cooker or coal-burning stove, an insulating panel covered with aluminium foil on the side facing the cooker or stove, must be inserted between the two appliances. The machine must not be installed in rooms where the temperature can drop below 0. The water inlet hose and the drain hose must not be kinked. Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown. Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. Automatic foot:The rear foot on the left-hand side of your washing machine is built as a shock absorbing foot, which is why the appliance gives in the back left-hand corner if put under load. The automatic foot guarantees that the appliance does not move even at high spin speeds. Basically the automatic foot does not need to be set. Water inlet An inlet hose is supplied and can be found inside the machine drum. Do not use the already employed hoses to connect to the water supply. This appliance must be connected to a cold water supply. 1.Open the porthole and extract the inlet hose. 2.Connect the hose with the angled connection to the machine. 43Installation 192998640 gb.qxd 13/08/2007 17.39 Pagina 43
Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. 3.Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. 4.Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. Installation should comply with local water authority and building regulations requirements. A minimum water pressure of 0.05 MPa is required for safe operation of the appliance. If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system. There should be a minimum distance of between the appliance’s inlet and the bottom of the water storage tank. Water-stop device The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in the window “A”. Should this occur, turn the water tap off and refer to your Service Centre to replace the hose. Water drainage The end of the drain hose can be positioned in three ways: Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall. In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground. Directly into a drain pipe at a heightof not less than 60 cm and not more than 90 cm. The end of the drain hose must always be ventilated, i.e. the inside diameter of 44Installation 192998640 gb.qxd 13/08/2007 17.39 Pagina 44
the drain pipe must be larger than the outside diameter of the drain hose. The drain hose must not be kinked. Important! The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre. Electrical connection This machine is designed to operate on a 230 V, single-phase, 50 Hz supply. Check that your domestic electrical installation can take the maximum load required (2.2 kW), also taking into account any other appliances in use. Connect the machine to an earthed socket. The manufacturer does not accept any responsibility for damage or injury through failure to comply with the above safety precaution. Permanent connection In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations. The switch must not break the yellow and green earth cable at any point. This operation must be performed by a qualified electrician. The power supply cable must be easily accessible after installing the machine. Should the appliance power supply cable need to be replaced, this must be carried out by a Service Centre. 45Installation 192998640 gb.qxd 13/08/2007 17.39 Pagina 45
Enviroment concerns Packaging materials The materials marked with the symbol are recyclable. >PEPSPP
European Guarantee This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee orotherwise by law. If you move from one of these countries to another of the countries listed, the appliance guarantee will move with you subject to the following qualifications: The appliance guarantee starts from the date you first purchased the appliance which will be evidenced by production of a valid purchase document issued by the seller of the appliance. The appliance guarantee is for the same period and to the same extent for labour and parts as exists in your new country of residence for this particular model or range of appliances. The appliance guarantee is personal to the original purchaser of the appliance and cannot be transferred to another user. The appliance is installed and used in accordance with instructions issued by Electrolux and is only used within the home, i.e. is not used for commercial purposes. The appliance is installed in accordance with all relevant regulations in force within your new country of residence. The provisions of this European Guarantee do not affect any of the rights granted to you by law. 47European Guarantee 192998640 gb.qxd 13/08/2007 17.39 Pagina 47
48Customer service centres www.electrolux.com !! Albania+35 5 4 261 450Rr. Pjeter Bogdani Nr. 7 Tirane Belgique/België/Belgien+32 2 363 04 44Bergensesteenweg 719, 1502 Lembeek Česká republika+420 2 61 12 61 12Budějovická 3, Praha 4, 140 21 Danmark+45 70 11 74 00Sjællandsgade 2, 7000 Fredericia Deutschland+49 180 32 26 622Muggenhofer Str. 135, 90429 Nürnberg Eesti+37 2 66 50 030Mustamäe tee 24, 10621 Tallinn España+34 902 11 63 88Carretera M-300, Km. 29,900 Alcalá de Henares Madrid Francewww.electrolux.fr Great Britain+44 8705 929 929Addington Way, Luton, Bedfordshire LU4 9QQ Hellas+30 23 10 56 19 704, Limnou Str., 54627 Thessaloniki Hrvatska+38 51 63 23 338Slavonska avenija 3, 10000 Zagreb Ireland+353 1 40 90 753Longmile Road Dublin 12 Italia+39 (0) 434 558500C.so Lino Zanussi, 26 - 33080 Porcia (PN) Latvija+37 17 84 59 34Kr. Barona iela 130/2, LV-1012, Riga Lituania+370 5 27 80 609Verkiu, 2 9, 09108 Vilnius, Lithuania Luxembourg+35 2 42 43 13 01Rue de Bitbourg, 7, L-1273 Hamm Magyarország+36 1 252 1773H-1142 Budapest XIV, Erzsébet királyné útja 87 Nederland+31 17 24 68 300Vennootsweg 1, 2404 CG - Alphen aan den Rijn Norge+47 81 5 30 222Risløkkvn. 2 , 0508 Oslo Österreich +43 18 66 400Herziggasse 9, 1230 Wien Polska+48 22 43 47 300ul. Kolejowa 5/7, Warsaw Portugal+35 12 14 40 39 39Quinta da Fonte - Edificio Gonçalves Zarco - Q35 -2774-518 Paço de Arcos Romania+40 21 451 20 30Str. Garii Progresului 2, S4, 040671 RO Schweiz-Suisse-Svizzera+41 62 88 99 111Industriestrasse 10, CH-5506 Mägenwil Slovenija+38 61 24 25 731Tr aška 132, 1000 Ljubljana Slovensko+421 2 43 33 43 22Electrolux Slovakia s.r.o., Electrolux Domáce spotrebiče SK, Seberíniho 1, 821 03 Bratislava Suomiwww.electrolux.fi Sverige+46 (0)771 76 76 76Electrolux Service, S:t Göransgatan 143, S-105 45 Stockholm Türkiye+90 21 22 93 10 25Tarlabași caddesi no : 35 Taksim Istanbul Россия+7 095 937 7837129090Москва, Олимпийский проспект, 16, БЦ «Олимпик» 192998640 gb.qxd 13/08/2007 17.39 Pagina 48