AEG Lavamat 62840 User Manual

Installation
Unpacking
All transit bolts and packing must be removed before using the appliance.
You are advised to keep all transit devices so that they can be refitted if the
machine ever has to be transported again.
1.After removing all the packaging, carefully lay
machine on it’s back to remove the
polystyrene base from the bottom.
2.Remove the power supply cable and the
draining hose from the hose holders on the rear of the
appliance.
3.With the provided spanner unscrew and
remove the central rear...

4.Unscrew and remove the two large rear bolts B
and the six smaller bolts C.
5.Remove the bracket Dand tighten up the six
smaller bolts C. Slide out the relevant plastic
spacerE.
6.Open the porthole, take out the inlet hose from the
drum and remove the polystyrene block fitted on the
door seal.
7.Fill the smaller upper hole and the two large ones with
the corresponding plastic plug caps supplied in the bag
containing the instruction booklet.
8.Connect the water inlet hose as described under the
paragraph...

Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets,
rugs etc.
Before placing it on small tiles, apply a rubber coating.
Never try to correct any unevenness in the floor by
putting pieces of wood, cardboard or similar
materials under the machine.
If it is impossible to avoid positioning the machine
next to a gas cooker or coal-burning stove, an
insulating panel covered with aluminium foil on the
side facing the...

3.Set the hose correctly by loosening the ring nut.
After positioning the inlet hose, be sure to tighten
the ring nut again to prevent leaks.
4.Connect the hose to a tap with a 3/4” thread.
Always use the hose supplied with the appliance.
Installation should comply with local water authority
and building regulations requirements. A minimum
water pressure of 0.05 MPa is required for safe
operation of the appliance.
If you cannot make the cold water connection direct from the rising mains, you
may be able...

Important!
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and
joining piece is available from your local Service Centre.
Electrical connection
This machine is designed to operate on a 220-230 V, single-phase, 
50 Hz supply.
Check that your domestic electrical installation can take the maximum load
required (2.2 kW), also taking into account any other appliances in use.
Connect the machine to an earthed socket.
The manufacturer does not accept any responsibility for...

Enviroment concerns
Packaging materials
The materials marked with the symbol  are recyclable.
>PEPSPP

47Notes
192998241 gb.qxd  9/4/2008  10:07 AM  Page 47
 

www.electrolux.com
www.aeg-electrolux.uk
192 998 241-00-352008     Subject to change without notice
192998241 gb.qxd  9/4/2008  10:07 AM  Page 48