AEG Lavamat 5 0 User Manual

							
Water-stop device
The inlet hose is provided with a water stop device,
which protects against damage caused by water leaks in
the hose which could develop due to natural ageing of
the hose. 
This fault is shown by a red sector in the window “A A
”.
Should this occur, turn the water tap off and refer to
your Service Centre to replace the hose.
Water drainage
The end of the drain hose can be positioned in three ways:
Hooked over the edge of a sink using the plastic hose guide supplied
with the machine.
In this case, make sure the end cannot come
unhooked when the machine is emptying.
This could be done by tying it to the tap with a piece
of string or attaching it to the wall.
In a sink drain pipe branch.  This branch must be
above the trap so that the bend is at least 60 cm above
the ground.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be  ventilated, i.e. the inside diameter of
the drain pipe must be larger than the outside diameter of the drain hose.
The drain hose must not be kinked.
Important! The drain hose may be extended to a maximum of 4 metres. An additional drain
hose and joining piece is available from your local Service Centre.
41Installation







\f

132960250.qxd  18/09/2008  14.29  Pagina  41
 
						

							
42
Electrical connection
Information on the electrical connection is given on the rating plate on the inner
edge of the appliance door and in the chapter «Technical Data».
Check that your domestic electrical installation can take the maximum lo\
ad
required, also taking into account any other appliances in use.
Connect the machine to an earthed socket.
The manufacturer does not accept any responsibility for damage or
injury through failure to comply with the above safety precaution.
The power supply cable must be easily accessible after installing the
machine.
Should the appliance power supply cable need to be replaced, this must
be carried out by a Service Centre. 
Permanent connection
In the case of a permanent connection it is necessary that you install a\
 double pole
switch between the appliance and the electricity supply (mains), with \
a minimum
gap of 3 mm between the switch contacts and of a type suitable for the r\
equired
load in compliance with the current electrical regulations.
The switch must not break the yellow and green earth cable at any point.
This operation must be performed by a qualified electrician.

Installation

132960250.qxd  18/09/2008  14.29  Pagina  42
 
						

							
Enviroment concerns
Packaging materials
The materials marked with the symbol  are recyclable.
>PEPSPP
						

							
www.electrolux.com
www.aeg-electrolux.be

132 960 250-00-392008Subject to change without notice
132960250.qxd  18/09/2008  14.29  Pagina  44