AEG Lavamat 12843 Vit User Manual

4.Unscrew and remove the two large rear bolts  B
and the six smaller bolts  C.
5. Remove the bracket  Dand refit the six smaller
bolts  C. Slide out the relevant plastic spacer E.
6. Open the porthole, take out the inlet hose from
the drum.
7. Fill the smaller upper hole and the two large ones with
the corresponding plastic plug caps supplied in the bag
containing the instruction booklet.
8. Connect the water inlet hose as described under the
paragraph «Water inlet».
All the different plug caps are...

42Installation
Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc.
Before placing it on small tiles, apply a rubber
coating.
Never try to correct any unevenness in the floor by
putting pieces of wood, cardboard or similar
materials under the machine.
If it is impossible to avoid positioning the machine
next to a gas cooker or coal-burning stove, an
insulating panel covered with aluminium foil on the...

4.Connect the hose to a tap with a 3/4” thread.
Always use the hose supplied with the appliance.
Installation should comply with local water authority
and building regulations requirements. A minimum
water pressure of 0.05 MPa is required for safe
operation of the appliance.
If you cannot make the cold water connection direct
from the rising mains, you may be able to operate the
appliance from your cold water storage system. There should be a minimum verti-
cal distance of between the appliance’s inlet...

The drain hose must not be kinked.
Important! The drain hose may be extended to a maximum of 4 metres. An additional drain hose and
joining piece is available from your local Service Centre.
Electrical connection
Information on the electrical connection is given on the rating plate on the inner
edge of the appliance door.
Check that your domestic electrical installation can take the maximum lo\
ad
required, also taking into account any other appliances in use.
Connect the machine to an earthed socket....

Building-in
This appliance has been designed to be built into
the kitchen furniture.
The recess should have the dimensions shown in
picture 
A.
Preparation and assembly of the door 
The machine is originally pre-arranged for the
assembly of a door opening from right to left.
In this case it is sufficient to screw in the hinges
(1) and the counter-magnet (6) provided with the
appliance, at the right level (Fig. B).
a) Door
The dimensions of the door should be:
- width 595-598 mm
- thickness 16-22 mm
The...

c) Mounting the door
Fix the hinges (1) to the machine by means of the M5x15 screws (3-Fig. B). The
hinges can be adjusted to compensate for possible uneven thickness of th\
e door.
To align the door perfectly it is necessary to loosen the screw (3-Fig.  B), adjust
the door and tighten the screw again.
d) Counter-magnet (6)
The appliance is pre-arranged for a magnetic clo-
sure of the door. To enable a correct operation of
this device, it is necessary to screw the counter-
magnet (6) (steel disk +...

Environment concerns
Packaging materials
The materials marked with the symbol  are recyclable.
>PEPSPP

www.electrolux.com
132 962 910-00-322008     Subject to change without notice

www.aeg-electrolux.com

132962910_EN.qxd  23/07/2008  10.29  Page 48