AEG Integrated refrigerator SKS71200C0 User Manual
Have a look at the manual AEG Integrated refrigerator SKS71200C0 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 513 AEG manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
ProblemPossible causeSolutionA rectangular symbol is shown instead of numbers on the Temperature Display.Temperature sensor prob- lem.Contact the nearest Author- ised Service Centre (the cool- ing system will continue to keep food products cold, but temperature adjustment will not be possible).The lamp does not work.The lamp is in stand-by.Close and open the door.The lamp does not work.The lamp is defective.Contact the nearest Author- ised Service Centre.The compressor operates continually.Temperature is set incor- rectly.Refer to "Operation". Many food products were put in at the same time.Wait some hours and then check the temperature again. The room temperature is too high.Refer to climate class chart on the rating plate. Food products placed in the appliance were too warm.Allow food products to cool to room temperature before stor- ing.The door is not closed cor- rectly.Refer to "Closing the door".The COOLMATIC is switched on.Refer to "COOLMATIC func- tion".The compressor does not start immediately after pressing the COOLMATIC, or after changing the tem- perature.This is normal, no error has occurred.The compressor starts after a period of time.Water flows inside the refrig- erator.The water outlet is clog- ged.Clean the water outlet.Food products prevent that water flows into the water collector.Make sure that food products do not touch the rear plate.Water flows on the floor.The melting water outlet is not connected to the evaporative tray above the compressor.Attach the melting water out- let to the evaporative tray.ENGLISH11
ProblemPossible causeSolutionTemperature cannot be set.The FROSTMATIC or COOLMATIC function is switched on.Switch off FROSTMATIC or COOLMATIC manually, or wait until the function resets auto- matically to set the tempera- ture. Refer to "FROSTMATIC or COOLMATIC function".dEMo appears on the dis- play.The appliance is in demon- stration mode.Keep the OK pressed for ap- proximately 10 seconds until a long sound is heard and dis- play shuts off for a short time.The temperature in the ap- pliance is too low/too high.The temperature regulator is not set correctly.Set a higher/lower tempera- ture.The door is not closed cor- rectly.Refer to "Closing the door".The food products' tem- perature is too high.Let the food products temper- ature decrease to room tem- perature before storage.Many food products are stored at the same time.Store less food products at the same time.The door has been opened often.Open the door only if necessa- ry.There is no cold air circula- tion in the appliance.Make sure that there is cold air circulation in the appliance.If the advice does not lead to the desired result, contact the nearest Authorised Service Centre.8.2 Replacing the lamp The appliance is equipped with a longlife LED interior light. Only service is allowed to replace the lighting device. Contact your Authorised Service Centre. 8.3 Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Authorised Service Centre.9. INSTALLATION9.1 Positioning This appliance can be installed in a dry, well ventilated indoor where the ambient temperature corresponds to the climateclass indicated on the rating plate of theappliance:Climate classAmbient temperatureSN+10°C to + 32°Cwww.aeg.com12
Climate classAmbient temperatureN+16°C to + 32°CST+16°C to + 38°CT+16°C to + 43°CSome functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range. If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Authorised Service Centre.9.2 Electrical ConnectionCAUTION! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.WARNING! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. The wires in the mains lead are coloured in accordance with the following code: • A - green and yellow: Earth • C - brown: Live • D - blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth symbol or coloured green and yellow. 2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp ( E ) is secure over the outer sheath. Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. 5. Switch on the appliance. The appliance is supplied with a 13 amp fuse ( B). In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. WARNING! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely.ENGLISH13 A BC D E
9.3 Ventilation requirements The airflow behind the appliance must be sufficient.CAUTION! Refer to the assembly instructions for the installation.10. NOISES There are some sounds during normal running (compressor, refrigerant circulation). www.aeg.com145 cmmin. 200 cm2 min. 200 cm 2 BRRR! HISSS! CLICK! BLUBB! CRACK! SSSRR R! OK CLICK!CLICK!SSSRRR!SSSRRR!
11. TECHNICAL INFORMATION11.1 Technical data Dimensions of the recess Heightmm1225Widthmm560Depthmm550VoltageVolts230 - 240FrequencyHz50The technical information are situated in the rating plate, on the external orinternal side of the appliance and in the energy label.12. ENVIRONMENT CONCERNSRecycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and torecycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to ENGLISH15BRRR!BRRR!HISSS!HISSS! BLUBB!BLUBB!CRACK!CRACK!
your local recycling facility or contact your municipal office. * www.aeg.com16