Home > AEG > Refrigerator > AEG Integrated refrigerator SKS58840S2 User Manual

AEG Integrated refrigerator SKS58840S2 User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual AEG Integrated refrigerator SKS58840S2 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 513 AEG manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							ProblemPossible causeSolution
    The compressor op-
    erates continually.The temperature is not
    set correctly.Set a higher temperature.
     The door is not closed
    correctly.Refer to "Closing the
    door".
     The door has been
    opened too frequently.Do not keep the door
    open longer than necessa-
    ry.
     The product temperature
    is too high.Let the product tempera-
    ture decrease to room
    temperature before stor-
    age.
     The room temperature is
    too high.Decrease the room tem-
    perature.
    Water flows on the
    rear plate of the re-
    frigerator.During the automatic de-
    frosting process, frost de-
    frosts on the rear plate.This is correct.
    Water flows into the
    refrigerator.The water outlet is clog-
    ged.Clean the water outlet.
     Products prevent that wa-
    ter flows into the water
    collector.Make sure that products
    do not touch the rear
    plate.
    Water flows on the
    ground.The melting water outlet
    does not flow in the evap-
    orative tray above the
    compressor.Attach the melting water
    outlet to the evaporative
    tray.
    The temperature in
    the appliance is too
    low.The temperature regula-
    tor is not set correctly.Set a higher temperature.
    The temperature in
    the appliance is too
    high.The temperature regula-
    tor is not set correctly.Set a lower temperature.
    7.1 Replacing the lamp
    The appliance is equipped with a long-
    life LED interior light.
    Only service is allowed to replace the
    lighting device. Contact your Service
    Center.
    7.2 Closing the door
    1.Clean the door gaskets.
    2.If necessary, adjust the door. Refer
    to "Installation".
    3.If necessary, replace the defective
    door gaskets. Contact the Service
    Center.
    ENGLISH11 
    						
    							8. INSTALLATION
    WARNING!
    Read the "Safety Information"
    carefully for your safety and cor-
    rect operation of the appliance
    before installing the appliance.
    8.1 Positioning
    This appliance can be installed in a dry,
    well ventilated indoor, also in a garage
    or cellar, but for optimum performance
    install this appliance at a location where
    the ambient temperature corresponds to
    the climate class indicated on the rating
    plate of the appliance:
    Cli-
    mate
    classAmbient temperature
    SN+10°C to + 32°C
    N+16°C to + 32°C
    ST+16°C to + 38°C
    T+16°C to + 43°C
    8.2 Electrical Connection
    CAUTION!
    Any electrical work required to
    install this appliance should be
    carried out by a qualified electri-
    cian or competent person.
    WARNING!
    This appliance must be earthed.
    The manufacturer declines any li-
    ability should these safety meas-
    ures not be observed.
    AB
    C
    D E
    The wires in the mains lead are
    coloured in accordance with the
    following code:
    A Green and Yellow: Earth
    CBrown: Live
    E Blue: Neutral
    As the colours of the wires in the mains
    lead of this appliance may not corre-
    spond with the coloured markings iden-
    tifying the terminals in your plug, pro-
    ceed as follows:
    1.Connect the wire coloured green
    and yellow to the terminal marked
    either with the letter “E“ or by the
    earth symbol 
     or coloured green
    and yellow.
    2.Connect the wire coloured blue to
    the terminal either marked with the
    letter “N“ or coloured black.
    3.Connect the wire coloured brown to
    the terminal either marked with the
    “L“ or coloured red.
    4.Check that no cut, or stray strands of
    wire is present and the cord clamp D
    is secure over the outer sheath.
    5.Make sure the electricity supply volt-
    age is the same as that indicated on
    the appliance rating plate.
    6.Switch on the appliance.
    The appliance is supplied with a 13 amp
    plug fitted B. In the event of having to
    change the fuse in the plug supplied, a
    12www.aeg.com 
    						
    							13 amp ASTA approved (BS 1362) fuse
    must be used.WARNING!
    A cut off plug inserted into a 13
    amp socket is a serious safety
    (shock) hazard. Ensure that it is
    disposed of safely.
    9. NOISES
    There are some sounds during normal
    running (compressor, refrigerant circula-
    tion).
    BRRR!HISSS!
    CLICK!
    BLUBB!
    CRACK!
    SSSRR
    R!
    OK
    CLICK!CLICK!SSSRRR!SSSRRR!
    BRRR!BRRR!HISSS!HISSS!
    ENGLISH13 
    						
    							BLUBB!BLUBB!CRACK!CRACK!
    10. TECHNICAL DATA
       
    Dimension of the recess  
     Height873 mm
     Width540 mm
     Depth549 mm
    Rising Time 12 h
    Voltage 230 V
    Frequency 50 Hz
    The technical information are situated in
    the rating plate on the internal left side
    of the appliance and in the energy label.
    11. ENVIRONMENT CONCERNS
    Recycle the materials with the
    symbol  . Put the packaging in
    applicable containers to recycle it.
    Help protect the environment and
    human health and to recycle waste
    of electrical and electronicappliances. Do not dispose
    appliances marked with the symbol with the household waste. Return the
    product to your local recycling
    facility or contact your municipal
    office.
    14www.aeg.com 
    						
    							ENGLISH15 
    						
    							www.aeg.com/shop
    211621893-A-162013 
    						
    All AEG manuals Comments (0)

    Related Manuals for AEG Integrated refrigerator SKS58840S2 User Manual