AEG Integrated refrigerator SKS58210F1 User Manual

							3.Replace the lamp with one of the
same power and shape, specifically
designed for household appliances.
The maximum power is shown on the
light bulb cover.
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains
socket.
7. Open the door.
Make sure that the light comes on.8.3  Closing the door
1.Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised Service Centre.
9.  INSTALLATIONWARNING!
Refer to Safety chapters.9.1  LocationRefer to the assembly
instructions for the
installation.
To ensure best performance, install the
appliance well away from sources of heat such as radiators, boilers, direct sunlight
etc. Make sure that air can circulate freely
around the back of the cabinet.
9.2  Positioning
Install the appliance in a dry, well
ventilated indoors where the ambient temperature corresponds to the climateclass indicated on the rating plate of theappliance.
Climate
classAmbient temperatureSN+10°C to + 32°CN+16°C to + 32°CST+16°C to + 38°CT+16°C to + 43°CSome functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature
range. If you have any
doubts regarding where to
install the appliance, please
turn to the vendor, to our
customer service or to the
nearest Authorised Service
Centre.9.3  Electrical ConnectionCAUTION!
Any electrical work required to install this appliance
should be carried out by a
qualified electrician or
competent person.WARNING!
This appliance must be
earthed.
The manufacturer declines
any liability should these
safety measures not be
observed.
The wires in the mains lead are coloured
in accordance with the following code:
ENGLISH11       
						

							•A - green and yellow: Earth
• C - brown: Live
• D - blue: Neutral
As the colours of the wires in the mains
lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter “E“ or by the earth
symbol  or coloured green and
yellow.
2. Connect the wire coloured blue to
the terminal either marked with the
letter “N“ or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
“L“ or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp
( E ) is secure over the outer sheath.
Make sure the electricity supply
voltage is the same as that indicated on the appliance rating plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp
fuse ( B). In the event of having to change
the fuse in the plug supplied, a 13 amp
ASTA approved (BS 1362) fuse must be
used.WARNING!
A cut off plug inserted into a
13 amp socket is a serious
safety (shock) hazard. Ensure
that it is disposed of safely.10.  NOISES
There are some sounds during normal running (compressor, refrigerant circulation).
www.aeg.com12A BC D E   BRRR!
HISSS!
CLICK!
BLUBB!
CRACK!
SSSRR
R!
OK  
						

							11. TECHNICAL DATA11.1  Technical data   Heightmm815Widthmm596Depthmm550VoltageVolts230 - 240ENGLISH13CLICK!CLICK!SSSRRR!SSSRRR! BRRR!BRRR!HISSS!HISSS! BLUBB!BLUBB!CRACK!CRACK!  
						

							   FrequencyHz50The technical information is situated in
the rating plate, on the external orinternal side of the appliance and in the energy label.12.  ENVIRONMENT CONCERNSPlease recycle all materials marked with
the symbol 
. Dispose of all packaging
materials appropriately and help to
protect the environment, and future
generations. Do not dispose of electrical
equipment marked with the 
 symbol
along with the general house hold waste.
Dispose all electrical goods via
applicable local authority collections, or
at local authority or, commercial
recycling centres.
*
www.aeg.com14   
						

							ENGLISH15 
						

							www.aeg.com/shop211623323-A-102016