AEG Integrated fridge freezer SCT81800S0 User Manual

3.11 DynamicAir
The refrigerator compartment is equip-
ped with a device that allows for rapid
cooling of foods and more uniform tem-
perature in the compartment.
This device activates by itself when nee-
ded, for example for a quick tempera-
ture recovering after door opening or
when the ambient temperature is high.
Allows you to switch on the device man-
ually when needed (refer to DynamicAir
mode).
The DynamicAir device stops when the
door is open and restarts immediately
after the door closing.
4....

• the maximum quantity of food which
can be frozen in 24 hrs. is shown on
the rating plate;
• the freezing process takes 24 hours.
No further food to be frozen should
be added during this period;
• only freeze top quality, fresh and thor-
oughly cleaned, foodstuffs;
• prepare food in small portions to ena-
ble it to be rapidly and completely fro-
zen and to make it possible subse-
quently to thaw only the quantity re-
quired;
• wrap up the food in aluminium foil or
polythene and make sure that the...

After cleaning, reconnect the equipment
to the mains supply.
5.2 Replacing the carbon air
filter
To get the best performance the carbon
air filter should be changed once every
year.New active air filters can be purchased
from your local dealer.
Refer to "Installation of the carbon air fil-
ter" for the instructions.
The air filter is a consumable accessory
and as such is not covered by the guar-
antee.
5.3 Defrosting the refrigerator
Frost is automatically eliminated from
the evaporator of the...

ProblemPossible causeSolution
The appliance is
noisyThe appliance is not sup-
ported properlyCheck if the appliance
stands stable (all the four
feet should be on the
floor)
The appliance does
not operate. The
lamp does not oper-
ate.The appliance is switched
off.Switch on the appliance.
 The mains plug is not
connected to the mains
socket correctly.Connect the mains plug to
the mains socket correctly.
 The appliance has no
power. There is no volt-
age in the mains socket.Connect a different electri-
cal...

ProblemPossible causeSolution
Water flows on the
rear plate of the re-
frigerator.During the automatic de-
frosting process, frost de-
frosts on the rear plate.This is correct.
Water flows into the
refrigerator.The water outlet is clog-
ged.Clean the water outlet.
 Products prevent that wa-
ter flows into the water
collector.Make sure that products
do not touch the rear
plate.
The temperature in
the appliance is too
low/high.The temperature regula-
tor is not set correctly.Set a higher/lower temper-...

6.1 Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center.
6.2 Closing the door
1.Clean the door gaskets.
2.If necessary, adjust the door. Refer
to "Installation".
3.If necessary, replace the defective
door gaskets. Contact the Service
Center.
7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before...

3.Connect the wire coloured brown to
the terminal either marked with the
“L“ or coloured red.
4.Check that no cut, or stray strands of
wire is present and the cord clamp D
is secure over the outer sheath.
5.Make sure the electricity supply volt-
age is the same as that indicated on
the appliance rating plate.
6.Switch on the appliance.The appliance is supplied with a 13 amp
plug fitted B. In the event of having to
change the fuse in the plug supplied, a
13 amp ASTA approved (BS 1362) fuse
must be used....

• Loosen the middle hinge.
• Remove the lower door.
• Loosen and remove the lower pin.
On the opposite side:
• Tighten the lower pin.
• Install the lower door.
• Tighten the middle hinge.
• Install the spacer.
• Install the upper door.
• Tighten the upper pin.
7.5 Ventilation requirements
5 cmmin.
200 cm2
min.
200 cm2
The airflow behind the appliance must
be sufficient.
7.6 Installing the appliance
CAUTION!
Make sure that the mains cable
can move freely.Do the following steps:
18www.aeg.com 

x
x
If necessary cut the adhesive sealing
strip and apply it to the appliance as
shown in figure.
1 2
Install the appliance in the niche.
Push the appliance in the direction of
the arrow (1) until the upper gap cover
stops against the kitchen furniture.
Push the appliance in the direction of
the arrow (2) against the cupboard on
the opposite side of the hinge.
4 mm
44 mm
Adjust the appliance in the niche.
Make sure that the distance between
the appliance and the cupboard front-
edge is 44 mm.
The lower...

I
I
Attach the appliance to the niche with
4 screws.
Remove the correct part from the
hinge cover (E). Make sure to remove
the part DX, in the case of right hinge,
SX in opposite case.
EE
B DC
Attach the covers (C, D) to the lugs and
the hinge holes.
Install the vent grille (B).
Attach the hinge covers (E) to the
hinge.
20www.aeg.com