AEG Integrated fridge freezer SCT71906S0 User Manual

aluminium foil or a polythene bag to
exclude as much air as possible.
• Bottles: close with a cap and place on the door bottle shelf, or (if available)
on the bottle rack.6.5  Hints for freezing
To help you make the most of the
freezing process, here are some
important hints:
• the maximum quantity of food which can be frozen in 24 hours is shown onthe rating plate;
• the freezing process takes 24 hours no further food to be frozen should
be added during this period;
• freeze only top quality, fresh and...

2.Regularly check the door seals and
wipe clean to ensure they are clean
and free from debris.
3. Rinse and dry thoroughly.
4. If accessible, clean the condenser
and the compressor at the back of
the appliance with a brush.
This operation will improve the
performance of the appliance and save electricity consumption.7.3  Defrosting of the
refrigerator
Frost is automatically eliminated from the
evaporator of the refrigerator
compartment every time the motor
compressor stops, during normal use.
The defrost...

ProblemPossible causeSolution The mains plug is not con-
nected to the mains socket
correctly.Connect the mains plug to the
mains socket correctly. There is no voltage in the
mains socket.Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.The appliance is noisy.The appliance is not sup-
ported properly.Check if the appliance stands
stable.Audible or visual alarm is on.The cabinet has been re-
cently switched on or the
temperature is still too
high.Refer to...

ProblemPossible causeSolutionFood products prevent
that water flows into the
water collector.Make sure that food products
do not touch the rear plate.Water flows on the floor.The melting water outlet is
not connected to the
evaporative tray above the
compressor.Attach the melting water out-
let to the evaporative tray.The temperature in the ap-
pliance is too low/too high.The temperature regulator
is not set correctly.Set a higher/lower tempera-
ture.The door is not closed cor-
rectly.Refer to...

Climate
classAmbient temperatureT+16°C to + 43°CSome functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature
range. If you have any
doubts regarding where to
install the appliance, please
turn to the vendor, to our
customer service or to the
nearest Authorised Service
Centre.9.2  Electrical ConnectionCAUTION!
Any electrical work required to install this appliance
should be carried out by...

9.3 Ventilation requirements
The airflow behind the appliance must
be sufficient.CAUTION!
Refer to the assembly instructions for the
installation.9.4  Door reversibility
1.Loosen and remove the upper pin
and the spacer.
2. Remove the upper door.
3. Unscrew the pins (B) and spacers (C).
4.Remove the door.
5. Remove the lower spacer.
6. Loosen the lower pin with a key.
7.Tighten the lower pin on the
opposite side.
8. Install the lower spacer.
9. Install the door.
10. Refit the pins (B) and the spacers (C)...

2.Drill the hinge cover (A), as shown in
figure.
3. Apply the covers (A) and (A1) (in the
bag) in to the intermediate hinge
4. Install the appliance in the niche.
5. Push the appliance in the direction of
the arrows (1) until the upper gap cover stops against the kitchen
furniture.
6. Push the appliance in the direction of
the arrows (2) against the cupboard
on the opposite side of the hinge.
7. Adjust the appliance in the niche.
Make sure that the distance between
the appliance and the cupboard...

11.Attach the covers (C, D) to the lugs
and the hinge holes.
12. Install the vent grille (B).
13. Attach the hinge covers (E) to the
hinge.
14. Connect the appliance laterally to
the kitchen furniture sidewall.
15. Loosen the screws in the fixing
brackets (H), move the brackets (H)
16. Tighten the screws.
17. Disconnect the parts (Ha), (Hb), (Hc)
and (Hd).
18. Install the part (Ha) on the inner side
of the kitchen furniture.
19. Push the part (Hc) on the part (Ha).
www.aeg.com18 EEB
D
C H
H Hb HaHc
Hd...

20.Open the appliance door and the
kitchen furniture door at an angle of
90°.
21. Insert the small square (Hb) into
guide (Ha).
22. Put together the appliance door and
the furniture door and mark the
holes.
23. Remove the brackets and mark a
distance of 8 mm from the outer
edge of the door where the nail must
be fitted (K).
24. Place the small square on the guide
again and fix it with the screws
supplied.
25. Align the kitchen furniture door and
the appliance door by adjusting the
part (Hb).
26. Press...

10. NOISES
There are some sounds during normal running (compressor, refrigerant circulation).
www.aeg.com20BRRR!
HISSS!
CLICK!
BLUBB!
CRACK!
SSSRR
R!
OK CLICK!CLICK!SSSRRR!SSSRRR! BRRR!BRRR!HISSS!HISSS!